|
| 1 | Excavating in post holes (or similar holes) each n exc 0.5 cum getting out, returning, filling in and ramming earth around, in layers n.exc 25 Cm, watering and removing surplus soil to a distance n.exc 50m and making good surface in soft / loose soil complete all as specified. |
| 2 | S&F mild steel framed work such as grills, gratings, etc. with ends of bars shouldered and / or riveted or forged into spikes, framed guard bars, barred iron doors, ladders, framed balusters, walk ways, drainage crossings, railings, framework of water tanks and similar work, mild steel conforming to Fe.290,Gde-E-165 complete all as specified and as directed. |
| 3 | S&F 1.25 mm thick mild steel, plain black sheet in hearths, covering to door shutters, covering to door chowkatsframes), chullah hoods, water tanks, water troughs, ducts, urinal troughs and funnels, etc. cut to size edges beaded if directed, holes punched, including round headed screws, clout nails or rivets and fixed to wood or steel members, etc., with plain 40 mm lap joints or welded/ riveted seams including bending, turning up, mitred angles, stopped ends, outlets, etc. as required complete all as specified and as directed. |
| 4 | M&L for preparation of new or previously untreated steel surfaces of any description not otherwise described over 10cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified and as directed |
| 5 | S & F HIT-HY 270 with HIT-V Threaded Rod. The product should be approved by ETA in anchors to use in masonry. The chemical should have an ETA approval for 50 years age testing. Anchoring with HIT-V with HY270 to be designed as per guidelines ofEN 1992-4. Drilling hole with double flute type drill bits/hollow drill bits to the required depth by rotary hammer drill, cleaning with brush and jet of clean air or with Safe-set Hollow Drill Bit technology to ensure dust-free clean holes and proper bonding of chemical to the required depth, filling resin and hardener using serrated nozzle to eliminate mixing error with standard HDE A22 battery dispenser along with piston plug. The installation and the setting instructions should be strictly followed as per the manufacturer’s recommendations. The adequate Diameter, embedment depth & number of anchors to be calculated as per PROFIS Engineering Software & the report to be submitted to the project manager, design engineer for approval. Scanning before drilling to be done withPS 300 to avoid hitting existing rebars. For shear loads, base plate designed by SOFA, filling sets are mandatory. HIT-HY 270 with Anchor rod HIT-V-8.8 M12X170 complete all as per manufacturers specification and specified and directed by Engr-in-Charge. Make : Hilti, sika, milwaukee as approved by GE |
| 6 | M&L for rendering 15 mm thick in CM 1:4 on fair faces of brick masonry surfaces or concrete surface finished even and smooth without using extra cement incl mixing with WPC as per manufacturers instruction complete all as specified and directed.Note : (i) WPC shall be measured and paid seperately as supply only(ii) Rendering upto 5 storey building incl necessary scaffolding and other safety precaution arrangement shall be inclusive in quoted rate |
| 7 | Supply only Integral water proofing compound ISI marked complete all as specified and directed. |
| 8 | Note:- The contract sum shall be calculated by deducting the amount shown in Credit Schedule attached to this tender, from total amount of Schedule \"A\"/BOQ |
