|
| 1 | Supply and installation of hermetically sealed double swing type door of size 1800 mm x 2110 made of SS304 sheet of thickness 0.8 mm for Door Leaf and SS 304 sheet of thickness 1.2mm for Door Frame and designed to fit flush into the wall panel system on both sides. Standard 50mm panel shall have frame width of 100mm. Shutters shall be of 45mm thick sealed andPUFF insulated with polyurethane foam injected under high pressure with a minimum density of 40 kg/m3. Door shall be fitted with following accessories as part of the door: Stainless steel hinges 3Nos per leaf, Stainless Steel \"D\" type handles, Stainless steel push plates on push side. Standard arm door closure (TS-1002) 2 no each & tower bolt. View panel along with self-adhesive tape and silicon sealant. One side key operated locking arrangement, Automatic door bottom seal at the bottom of shutter. Make :- WIESPL, Magnateck Enterprises, Hospedia medicare |
| 2 | Supply and fabrication offramed Rolled sections (Fe-410 W grade 250 quality A) as in main and cross beams,colums, channels, stanchions, hip and jack rafters; purlins ,plates and angle cleats where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates fixed to concrete members or existing brick work as cills or jambsincluding base plate, anchor boltscomplete including drilling /welding all as spd and directed |
| 3 | M&L preparation of new steel Surfaces of any description, over 10 cm in width or girth, not otherwise described and applying two coats of synthetic enamel paint over a coat of zinc primer all specified. |
| 4 | S&F powder coated aluminium (minimum thickness of powder coating 50 micron) for doors, windows, ventilators ,sliding and partitionswith extruded built up standard tubular sections/ appropriate Z sections and other sections of approved make conforming to IS: 733 and IS:1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required EPDM rubber/ neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle,beading ,gaskat for glazing/ paneling,with fittings for doors with handle ,hinges screws,sliding sections ,rollers,handle,Hinges as required complete all as specified.Note:-(i) Glazing/wiremesh shall be measured and paid separately.(ii)Item shall be paid as per the weight of Aluminium section however the rate quoted shall be inclusive of the cost of neoprene beading glazing pins, screws, handle and other fittings etc which shall not be measured for arriving the weight. |
| 5 | S & F sheet glasses,frosted4.80mm to 5MMthickglazingall withaluminum beading, glazing pin. etc, or with oil putty in square exc .5 sqm in each pane |
| 6 | S&FDouble action floor springand pivot hydraulically regulated made up of minimum 1.25mm thick aluminium alloy sheet foundation box, main body with stainless steel cover, governing pivot made of brass, other parts made of mild steel heavy duty and fixed.make: hyper, hardwyn of model as per site requirement |
| 7 | S & F sheet glasses,plain4.80mm to 5MMthickglazingall withaluminum beading, glazing pin etc, or with oil putty in squaren exc .5 sqm in each pane |
| 8 | S & F in repairs 12mm thick prelaminated particle board exterior grade with decorative choice lamination on both sidesfixed with screws aluminium beadingtoAluminium frame worketc.complete all as specified and directed.((New aluminium sections shall be msrd and paid seperately) |
