|
| 1 | Demolishing lime concrete manually/ by mechanical means and disposal of material within 50 metres lead as per direction of Engineer in charge. |
| 2 | Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix) |
| 3 | Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead. |
| 4 | Half brick masonry with 1st class common burnt clay F.P.S. (non modular) bricks in foundation and plinth in: |
| 5 | Cement mortar 1 :3 (1 cement: 3 coarse sand) |
| 6 | 12 mm cement plaster of mix |
| 7 | 1:4(1 cement: 4 coarse sand) |
| 8 | Providing and applying white cement based putty of average thickness 1mm,of approved brand and manufacturer, over the plastered wall surface to preparethe surface even and smooth complete. |
| 9 | Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface : |
| 10 | Water thinnable cement primer |
| 11 | Finishing walls with Acrylic Smooth exterior paint of required shade New work (Two or more coat applied @1.67 ltr/10 sqm over and including base coat of water proofing cement paint applied @ 2.20 kg /10 sqm). |
| 12 | Earth work in excavation by mechanical means (Hydraulic Excavator)/ manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan) including dressing of sides and ramming of bot toms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. |
| 13 | All kinds of soil |
| 14 | Providing and laying in position cement concrete of specified grade excluding the cost of centering.and shuttering - |
| 15 | 1:4:8 (1 Cement: 4 coarse sand: 8 graded stone aggregate 40 mm nominal size) |
| 16 | Providing and laying factory made cement concrete interlocking paver , block of M -30 grade made by block making machine with strong vibratorycompaction, of approved size, design & shape, laid in required colour and \"pattern over and including 50mm thick compacted bed of coarse sand, filling the joints with line sand etc. all complete as per the direction of ‘ Engineer-in-charge. |
| 17 | 60 mm thick |
| 18 | Steel work in built up tubular (round, square or rectangular tubes etc.) trusses etc., including cutting, hoisting fixing in position and applying a priming coat of approved steel primer, including welding and bolted including special shaped washers etc. complete. |
| 19 | Electric resistance or induction butt welded tubes. |
| 20 | Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) with zinc ! coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in charge. The ! sheet shall be fixed using.self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal,complete upto any,pitch in horizontal/vertical r or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required with |
| 21 | Precoated galvanised iron profile sheets 0.40 mm thick |
