|
| 1 | 38.6) Providing and laying water proofing treatment on roofs of slabs by applying cement slurry mixed with water proofing cement compound consisting of applying : a) after surface preparation, first layer of slurry of cement @ 0.488 kg/sqm mixed with water proofing cement compound @ 0.253 kg/sqm. b) laying second layer of Fibre glass cloth when the first layer is still green. Overlaps of joints of fibre cloth should not be less than 10 cm. c) third layer of 1.5 mm thickness consisting of slurry of cement @ 1.289 kg/sqm mixed with water proofing cement compound @ 0.670 kg/sqm and coarse sand @ 1.289 kg/sqm. This will be allowed to air cure for 4 hours followed by water curing for 48 hours. The entire treatment will be taken upto 30cm on parapet wall and tucked into groove in parapet all around. d) fourth and final layer of brick tiling with cement mortar (which will be paid for separately For the purpose of measurement the entire treated surface will be measured. |
| 2 | (27.18.1) Providing and fixing 1st quality ceramic glazed vitrified tiles of colour standard white, grey, ivory, fume, red brown, light green, light blue, and other light shades with water absorption less than or equal to 0.08% confirming to IS : 13753 & IS : 15622 in floor, steps etc laid on bed on neat cement slurry finished with flush pointing in the white cement mixed with pigment to match the shade of the tile complete (excluding the cost of cement plaster on wall and pillar) Size 600mm x 600mm |
| 3 | (21.1.7) Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering - All work upto plinth level :1:4:8 (1 Cement : 4 fine/ coarse sand : 8 graded stone aggregate 40 mm nominal size). |
| 4 | (21.1.2) Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering - All work upto plinth level : 1:1½:3 (1 Cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size). |
| 5 | (25.1.2) Random rubble masonry with hard stone in foundation and plinth : Cement mortar 1:4 (1 cement : 4 coarse sand) |
| 6 | (34.12.5) Providing and fixing G.I. pipes complete with G.I. fittings including trenching and refilling etc. |
| 7 | 25 mm dia. nominal bore |
| 8 | 40 mm dia. nominal bore |
| 9 | (53.7) P/Laying ISI marked P.V.C. insulated submersible cable confirming to(IS:694) and as per IS 8130 : 2013 of 1.1 kV grade . Wire should be made from 99.90 % purity copper, stranding in acc. to IS:8130/IEC 60228 for lower watt loss , oxygen free for less chances of oxidization, insulation PVC type A/C/D , flame retardant as per IS 10810-53, better amperage rating as per IS:3961 part 5, existing pipe / open trench / Cable tray / on surface including making connection etc. as required. For additional technical parameters of product / work refer Annexure \"A\" attached with this BSR |
| 10 | 1.5 Sq.mm 3 core flat / Round |
| 11 | 2.5 Sq.mm 3 core flat / Round |
| 12 | 10.0 Sq.mm 3 core flat / Round |
| 13 | 16.0 Sq.mm 3 core flat / Round |
| 14 | (34.17) Providing and fixing gun metal gate valve with C.I. wheel of approved quality (screwed end) : |
| 15 | 25 mm nominal bore |
| 16 | 40 mm nominal bore |
| 17 | Supplying and installation of submersible motor pump sets ISI marked (IS:8034-1989) of approved make with required accessories including making connection suitable for T.W./ D.C.B./ Open well. The job includes lowering of riser pipe, G.I. / H.D.P.E. pipe with rope, cables, installation of complete fitting and accessories, jointing of electrical cables up to switch board. All labour for testing of submersible pumps set and supply of water to water mains, complete in all respect. |
| 18 | 1.0 HP to 3.0 HP |
| 19 | 5.0 HP to 10 HP |
| 20 | P&F TP&N 415 V metal clad HBC \"cum rewireable switch fuse unit with \"porcelain kit-kat & neutral link and \"confirming to IS:13947 P-I&III and \"making connections with lugs testing etc. as required. |
| 21 | 63 A rating Group 1st |
| 22 | 100 A rating Group 1st |
| 23 | Supplying and fixing of starter panel for following rating motors made out with MS powder coated sheet housing, protection relays for overload, short circuit and single phasing, On/Off buttons etc. complete in all respect Delta Star 3-15 HP. |
| 24 | Servicing of fountain by washing of water tank, fountain, pipeline etc. Four time in a year. |
| 25 | Servicing of fountain panel including providing and fixing of faulty/burnt parts of the control panel including replacement of submersible cable of pump and lights complete in all respect. |
| 26 | P&F of stainless steel mesh filter on the fountain pump |
| 27 | Repairing of 1 to10 HP submersible fountain pump including rewinding and refixing at the fountain. |
| 28 | Providing and fixing of 18 V, water proof LED colour changing lights with 96 LEDs of RGB 32 nos each. |
| 29 | Providing and fixing of RGB colour changing unit Programmed for changing of colours of LED lights. |
| 30 | Providing and fixing of 18V 5amp. SMPS power supply of LED lights. |
| 31 | P/F of brass chroumium plated nozzles of various sizes. |
| 32 | P&F of 1\" foaming / Geyzer nozzles made from aluminum casting housing with powder coating and engineering plastic components in side. |
| 33 | P/F of 20mm dia And both side threaded aluminum sticks for ball fountain as required length and colour. |
| 34 | P/F of 20mm dia PVC stick for ball fountain as required length and colour. |
| 35 | P/F of brass umbrella nozzles for ball fountain as per size and shape of existing nozzles. |
| 36 | Supply and fixing of 150mm dia alluminum ball with threade holes for sticks for Ball fountain. |
| 37 | Supply and fixing of 300mm dia alluminum ball with threade holes for sticks for Ball fountain. |
| 38 | Supply & Fixing of 2\" PVC Hosepipe. |
| 39 | Regarding operation of fountain supply of water through water tanker as per necesety. |
| 40 | Operating and Comprehansive maintenance of fountains at various garden including washing and cleaning of fountain pool with repairing of minor leackage if any, proper adjusting fountain nozzles, valves, repairing of fountain lights and panel boards with providing of operator for operating of the fountain at evening for two to three hours. (the time of operation will be vairy during the change of wheather or instructed by the officer incharge).(14 X 12 = 168) Please Enable Macros to View BoQ information |
