|
| 1 | Dismantling 1\"X1\" apeture square or hexagonal multithread HDPE of 1mm dia copolymer bird proofing netting ultra voilet resistent fixed with nylon rope and 4mm diaGI wire complete all as specified. |
| 2 | Dismantling Plain or corrugated steel sheeting, any gauge, thickness, including Nainital or similar pattern roof coverings complete all as specified. |
| 3 | Dismantling wrought iron or mild steel work of any description not otherwise provided as MS Flat with galvanised steel wire netting fixed with tinned tacks or wire complete all as specified. |
| 4 | S&F Joist, channel, angle, or tee sections, fixed independently, without connecting plates, etc. (cut to ordinary lengths i.e. within 20mm of the length indicated) complete all as specified. |
| 5 | S&F Wire netting mesh ofsize 20mm, with GI steel wire 1.40mm dia fixed with tinned tacks of wire staple complete all as specified. |
| 6 | S&F0.5mm thick galvalume sheet having strength of 550 mps fixed with self taping screw as in ceiling (over & below)/cladding to wall complete all as specified. |
| 7 | S&F in Repair 1\"X1\" apeture square or hexagonal multithread HDPE of 1mm dia copolymer bird proofing netting ultra voilet resistent fixed with nylon rope and4mm dia GI wire complete all as specified. |
| 8 | S&F stainless steel spikes of 1.4mm dia including 50mm wide rubber (protective pad) to fixed on desired location complete all as specified. |
| 9 | M&L for preparing new steel Surfaces of any description, over 10cm in width or girth and applying Two coats of synthetic enamel paints over acoat of red -oxide primer complete all as specified. |
| 10 | M&L for prepration of new steel Surfaces of any description, n.exc 10cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer when uncon?nected with other painting or when painted in a different tint\t complete all as specified.Note :- Applicable for Serial No 1.00 to 10.00 :- The work shall be executed in ceiling of building up to 15.00 metre height and rates quoted by the contractor shall deemed to includes all material, T&P etc inculding refixing of electrical fittings if any disburbed during execution. |
| 11 | Demolition of Cement Concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) complete all as specified. |
| 12 | M&L for 100mm thick PCC 1:4:8 type D-2 (using 40mm graded stone aggregate) as in sub base of flooring complete all as specified. |
| 13 | Providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified. |
| 14 | M&L Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever requiredcomplete all as specified. |
