|
| 1 | Demolition of plain cement concrete of any description and in any position (below and above ground level) not otherwise specifically provided for complete all as specified and as directed. |
| 2 | Demolition of brick work/ stone masonary built in cment mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified and as directed. |
| 3 | Demolition of reinforced cement concrete of any description and in any position (below and above ground level ) not otherwise specifically provided for including reinforcement cut to required size to facilitate demolition complete all as specified and as directed. |
| 4 | Material & labourfor cement concrete in foundations, filling and mass concrete 1:4:8 type D-2 using 40mm graded stone aggregate complete all as specified and as directed. |
| 5 | Use and waste type of formwork to sides of walls ofRCC drain and similar works for rough finished flat surface of drain complete all as specified and as directed. |
| 6 | Use and waste type of formwork to sides of walls or Slab Bottom in Drain Covering or Similar Work ofRCC drain and similar works for fairfinish surface of drain complete all as specified and as directed. |
| 7 | Formwork to edges of concrete flats,floor and roofs n exc 20cm wide and sides of RCC/ PCC bands in walls, horizontal or sloping and similar work exc 10cm but n exc 20cm wide for rough finished flat surface complete all as specified and as directed. |
| 8 | Material and labour for RCC drain bottom slab / basement slab using reinforced ready mixed cement concrete M-25 (design mix) using 20mm graded stone aggregate transprted at site using transit mixer and pumped suitably using line / boom pump in position complete all as specified and as directed. |
| 9 | Material and labour for RCC retaining wall / drain side wallusing reinforced ready mixed cement concrete M-25 (design mix) using 20mm graded stone aggregate transprted at site using transit mixer and pumped suitably using line / boom pump in position complete all as specified and as directed. |
| 10 | Material & labourfor TMT bar 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and as directed. |
| 11 | Ditto as per item No 10.00 above abovebut 6mm to8mm dia complete all as specified and as directed. |
| 12 | Material & labourfor brick work with sub class \"B\" bricks straight or curved on plan exc. 6m mean redius built in cement mortar 1:4 complete all as specified and directed. |
| 13 | Material & labourfor uncoursed random rubble masonarybuilt in cement mortar 1:4 complete all as specified and as directed. |
| 14 | Ditto as above item No 13.00 but except stone complete all as specified and as directed. |
| 15 | Material & labourfor plain cement concrete in copping and haunching in drain and any other pcc course type C-1 1:3:6 type C-1 using 20mm graded stone aggregatecomplete all as specified and as directed. |
| 16 | Material & labourfor extra for forming fair finished drain or channel 30 cm inner not exceedinggirth in cement concrete, using ex- tra cement, including forms, moulds, mi- tred/stopped ends etc.complete all as specified and as directed. |
| 17 | Ditto as above sl item No 16.00 but for inner girth not exceeding 55cm complete all as specified and as directed. |
| 18 | Taking down cement plaster on brick or stone walls, etc. including raking out joints, hacking for key, scrubbing down with water, etc complete all as specified and as directed. |
| 19 | Racking out joints/ pointing of cement / cement lime mortarto uncoursed random rubble masonary complete all as specified and as directed. |
| 20 | Material & labourfor 15mm thick rendering on fair finished surface in cement mortar 1:4 finished even and smooth without using extra cement complete all as specified and as directed. |
| 21 | Material & labourfor keyed pointing g to random or polygonal rubble, uncoursed or brought upto course in cement mortar 1:4 complete all as specified and as directed . |
| 22 | M & L for preparing new plastered surface of wall and applying two coats of cement base paint over and including a coat of alkali resistant primer complete all as specified and as directed. |
| 23 | Dismantling posts or struts steel or R.C.C any section, including taking out embedded portion and making good disturbed ground for embedment of new fencing post complete all as specified and as directed. |
| 24 | Supply & fixing mild steel angle iron posts and struts in fencing, steel gate frame including handmade hinges etc. including cutting top to shape as directed drilling holes welding and notching for wire etc and flat iron fillets for securing wire mesh including bedding or riveting etc conforming to Fe-290 Gde E-165, complete all as specified and directed. |
| 25 | Dismantling fencing wire mesh, any type complete all as specified and as directed. |
| 26 | Fixing only Chain link fencing including line wires, any mesh, size and type to any type of standerd, rails, straining bolts, etc including provision of binding wire complete all as specified and as directed. |
| 27 | Supply only chain link MS galvanised fencing of mesh size 100 mm x 100 mm , complete all as specified and directed. |
| 28 | Supply & fixing mild steel screw bolts ( machine made) with hexagonalheads at one end and screwed the other or screwed both ends each screwed end to be fitted with washer and one hexagonal or square nut not exc 5cm and dia of shank 11 to 15mm complete all as specified and directed. |
| 29 | Material & labourpreparation of new or previously untreated steel surfaces of any description, over 10 cm width or girth, not otherwise described and applying two coats of synthetic enamel paint (ordinary tint) over a coat of red oxideprimer, complete all as specified and directed. |
| 30 | Material & labourtwo coats of synthetic enamel paint over a coat of red oxide primer on steel surfaces of any description n.exc10cm inwidth or girth not otherwise described includingpreparation ofsurfaces all as specified and directed. |
| 31 | Supply & fixing in repair Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain- ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. complete all as specified and as directed |
| 32 | Dismantling wroughtmild steel work of any description not otherwise provided for complete all as specified and as directed. |
| 33 | Supply & fixing mild steel Framed work suck as grills, gratings, guard bar etc with ends of bars shouldered and/or riveted, or forged into spikes, framed guard bars complete all as specified and as directed. |
| 34 | Material and labour for75 mm thickPCC 1:4:8 type D2 using 40 mm graded aggregate as in sub basecomplete all as specified and directed. |
| 35 | M&L for 75mm thick PCC 1:3:6 type C1 (using 20mm graded stone aggregate) as in plinth protection, surface finished even and smooth without using extra cement complete all as specified and directed |
| 36 | Use of forming Contraction (Dummy) joints 65mm deep x 10mm wide, filled with sealing compound grade \"A\" in plinth protection complete all as specified and directed |
| 37 | Supply & fixingrubber moulded decorative designedcoloured machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness M-35 Grade with grey cement and pigmentcomplete all as specified and directed. |
| 38 | Ditto As in item above But Dismantling and Refixing Paver Blocks of any thickness complete all as specified and as directed by Engineer-in-Charge |
| 39 | Material and labour forsand filling under floor or in foundation including watering and consolidation completed all as specified (Note:- Sand cushion layer consolidated thickness is 20 mm below precast interlocking paver blockcomplete all as specified and directed. |
| 40 | Dismantling Stone slabs and tiles of any description or thickness in floors, aprons laid bedded and pointed in any mortar etc complete all as specified and directed |
| 41 | M&L 20 mm thick Granite (of any type) work (table rubbed and polished) as in steps, jambs, pillars, window- cills,cooking platforms, working table and like over 20 mm thick screed bed or bedding layer in cement mortar (1:4), including pointing in white cement (1:2) using marble dust with admixture of pigment to match withshade of granite |
| 42 | M&L for Granite tiles 20mm thick (approved color and texture) machine cut, bedded including 20mm thick screed bed CM 1:6 and jointed with grey cement slurry and pointed with white cement with admixture of pigment to match the shade of granite stone including grinding and polishing complete |
| 43 | Rounding to edges of stone slabs one edge, such as in steps, cooking platform, and other similar situations |
| 44 | Dismantling floor hearthor wall tiling including cement mortar bedding (but not backing) , removing serviceable tiles to store and rubish of the premisses complete all as specified and directed |
| 45 | M&L for Vitrified Ceramic colured tiles of Dark Shade or Double Charged of size area of each tileexc 0.36 sqm but not exc 0.42 sqmin flooretc,jointed in neat cement slurry and pointed in white or colours cement to match complete all as specfied and directed over and including 15 mm thick screed bed in Cement Mortar 1:6 complete all as specified and directed |
| 46 | M&L for 25mm thick PCC 1:2:4 type B-0 using 12.5mm graded stone aggregate, including finishing of concrete topping even and rough complete all as specified and directed |
| 47 | M&L for Endura Non Skidjoint free colour tiles 8 to 10 mm thick (square/ rectangular) area of each tiles not exceeding 0.11 sqm , in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match with colour of tiles over and incliding screed bed 15cm in CM (1:6) complete all as specified and directed. |
| 48 | M & L for chequered cement concrete tiles 20 cm x 20 cm x 25 mm thick, with grey cement and pigment, set, jointed and pointed in neat cement slurry in floorsincluding screed bed 15 mm thick in CM 1:6,complete all as spd & directed by Eng-in-charge |
| 49 | Dismantling Plain or corrugated steel sheeting, any gauge, thickness, including Nainital orsimilarpattern roof coverings complete all as specified and as directed by Engineer-inCharge |
| 50 | Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and as directed by Engineer-in-Charge |
| 51 | Excavating in post holes (or similar holes) each n exc 0.5 cum in Soft Disintegrated Rocks, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, complete all as specified and as directed by Engineer -in-Charge |
| 52 | Material and Labour for Rolled mild steel Fe-410-W (GdeE-250) quality B in Joist, channel, angle, or tee sections, fixed independently, without connecting plates, etc. (cut to ordinary lengths i.e. within 20 mm of the length indicated) complete all as specified and as directed by Engnr-in-Charge |
| 53 | Material and Labour for Rolled mild steel Fe-410-W (GdeE-250) quality B Roof trusses (framed), trussed, purlins, crane gantries, rails and fastenings and heavy bracket framing (Beam, tee, angle, channel or flat sections) including distance pieces, cleats etc. complete all as specified and as directed by Engnr-in-Charge |
| 54 | Material and Labour for Rolled mild steel Fe-410-W (GdeE-250) quality B Rolled sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates. complete all as specified and as directed by Engnr-in-Charge |
| 55 | Material and Labour for Pre- painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified complete all as specified and as directed by Engnr-in-Charge |
