|
| 1 | Dismantling of RCC/steel posts/struts any section , including taking out embedded in concrete, brick work or stone masonry including taking out embedded portion etcand making to disturbed ground complete all as specified and directed. |
| 2 | Demolition of stone masonry built in cement or cement lime mortar all as specified and directed. |
| 3 | M&L for squared rubble walling, Jodhpur type brought up to courses, well bonded, bedded and solidlyhearted, built in cement mortar (1:6) all as specified& directed. |
| 4 | M&L for squared rubble walling, Jodhpur type brought up to courses, well bonded, bedded and solidlyhearted, built in cement mortar (1:6) all as specified& directed.but except stone |
| 5 | Extra over stone walling for hammer dressing to face stones with maximum depression on face from a straight edge not exceeding 20mm & dressing face beds and joints as specified to squared rubble walling Jodhpur type brought up to courses all as specified & directed by Engineer-in-Charge. |
| 6 | M & L for Cement plastering 15mm( thick in two layers -first layer 10mm thick with ready mix plaster and outer layer 5mm thick ready mix water proof plaster) on outer walls by adding potable water by weight of material as mentioned by manufacture ready mix plaster shall comply with IS- 1661-1972, IS-2402-1963, IS- 2250-1981 and shall confirm 28 days compressive strength 10-15 MPA, bulk density 1600-1800 kg/cum and pull out bond strength->0.5 MPA complete all as specified and directed |
| 7 | M&L for preparing newly plastered surfaces of walls and applying two coats of cement base paint over a coat of alkali resistance primer complete all as specified. |
| 8 | S&F Posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe 410-0 or Fe 310-0 |
| 9 | S&F 11 to 15mm dia Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, exc 5cmbut n.exc 10cm long |
| 10 | Supply and fixing in repairs galvanized 2 strand, steel barbed wire 2.24 mm dia, barbed with 2 mm dia barbs at 75 mm spacing and straining and fixing to any type of stranded rails, straining bolts, including securing or tying at crossing with and provisions of galvanized MS wire, staples or steel pins, etc as directed (Each line wire to b e measured). |
| 11 | Dismantling mild steel work of any description not otherwiseas specified and directed. |
| 12 | S &F framed work as in doors or gates of angle or other section with gusset plates, rails, braces etc complete drilled for fixing of steel sheeting or other covering. Door etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings and decorative cast iron artical etc. |
| 13 | Preparing new steel surfaces of any description exceeding 10 cm in width or girth and applying two coats of synthetic enamel painting over over a coat of pink primer complete all as specified and directed. |
