|
| 1 | Demolition of Stone slabs and tiles of any description or thickness in floors, aprons etc. laid dry or laid dry andpointed andremoving rubbish off the premises etc complete all as specified and directed |
| 2 | Demolition of Stone slabs and tiles of any description or thickness in floors, aprons etc. laid, bedded pointed in any mortar andremoving rubbish off the premises etc complete all as specified and directed. (Note for item No. 1.00 & 2.00 :- Serviceable tiles/paver blocks shall be segregated and stacked carefully to reuse) |
| 3 | Demolition of cement concrete (un reinforced) in ground floors and paving n. exc. 15 cm thickness (below or above ground level) removing rubbish off the premises etc complete all as specified and directed |
| 4 | Demolition of concrete (reinforced) of any description and in any position not otherwise specifically provided for, removing rubbish off the premises etc complete all as specified and directed. |
| 5 | Taking down galvanised steel barbed wire of any description as in fencing, fixed to any type of standard rails complete all as directed. |
| 6 | Dismantling fencing wire mesh any type complete all as directed. |
| 7 | Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion in natural ground and making good disturbed ground complete all directed. |
| 8 | Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion in concrete and making good disturbed ground complete all directed. |
| 9 | Demolition of brickwork built in cement mortar and removing rubbish off the premises etc complete all as specified and directed |
| 10 | Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed. |
| 11 | Taking down cement plaster or lime plaster on walls /ceiling of any description from concrete or brick wall etc including raking out joints, hacking for key, scrubbing down with water and disposing off the retrieved debris as directedincluding necessary scaffoldings etc complete all as specified and directed |
| 12 | Taking up or down 15 mm bore steel watertubing and connectionscomplete all as specified. |
| 13 | Taking up or down 20 mm bore steel watertubing and connectionscomplete all as specified. |
| 14 | Taking up or down 25 mm bore steel watertubing and connectionscomplete all as specified. |
| 15 | Dismantling PVC/HDPE/plastic water tank of capacity exc 500 Litre and notexceeding 1000 Ltr complete all as specified and directed |
| 16 | Excavating in post holes (or similar holes) each n exc 0.50 cum, getting out, returning filling in and ramming earth or broken rubble mixed with earth around in layers not exc 25cm, watering and removing surplus soil to a distance not exc 50 m and making good surfaces in soft/loose soil complete all as specified and as directed. |
| 17 | Excavating in trenches not exc 1.5m wide and n.exc 1.5 m in depth, for foundations, etc, or for shafts, wells, cesspits, manholes, pier holes, etc and not exceeding 10 square meter on plan for manholes etc and not exceeding 1.5m in depth and getting out in hard/dense soil complete all as specified and directed. |
| 18 | Returning filling in with approved excavated soil including spreading, leveling, watering and well ramming in layers not exceeding 25cm thick complete all as specified and directed. |
| 19 | Removing excavated soils to a distance not exceeding 50 metres and depositing where directed at a level nexc. 1.5 metre above the starting point complete all as specified and directed. |
| 20 | Materials and Labour for Sand filling under floors or in foundationincluding watering and consolidation complete all as specified and as directed. |
| 21 | Materials and Labour for plain cement concrete (1:4:8) type D-2,using 40mm graded stone aggregate as in foundations, filling and mass concrete complete all as specified and as directed. |
| 22 | Materials and Labour for plain cement concrete (1:3:6) type C-2,using 40mm graded stone aggregate as in foundations, filling and mass concrete complete all as specified and as directed. |
| 23 | Materials and Labour for plain cement concrete (1:2:4) type B-0,using 12.5mm graded stone aggregate as in coping, kerbs and the like including weathering, slightly rounded or chamfered angles and throating including necessary formwork complete all as specified and as directed. |
| 24 | Materials and Labour for plain cement concrete (1:3:6) type C-2,using 40mm graded stone aggregate as in surface channel and drain complete all as specified and as directed. |
| 25 | Materials and Labour for extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped ends etc. all as specified and as directed. |
| 26 | Materials and Labour for formwork to soffits of suspended slabs such as roof slab, floor slabs, landings and similer works,for rough finished flat surfaces of concrete, thickness of slab not exc 200 mm,complete all as specified and directed |
| 27 | Materials and Labour for reinforced cement concrete (1:1.5:3) type A1 (nominal mix) using 20 mm graded stone aggregate as in slabs and shelves supported on walls, beams and columns in floors, roofs and landings etc, any thickness complete all as specified and directed. (Note: Steel reinforcement shall be measured & paid separately) |
| 28 | Materials and Labour for reinforced cement concrete (1:1.5:3) type A1 (nominal mix) using 20 mm graded stone aggregate as in Beams, cantilevers, bressummers, lintels complete all as specified and directed including necessary formwork. (Note: Steel reinforcement shall be measured & paid separately) |
| 29 | Materials and Labour for precast reinforced cement concrete (1:2:4) type B1 using 20 mm graded stone aggregate as in in landings, cover slabs (for man holes etc.)chullah hoods,chajjas, water troughs, mangers, shelves and similar articles with plain faces etc, any thickness,placed in position and set in cement mortar 1:6 complete all as specified and directed. (Note: Steel reinforcement shall be measured & paid separately) |
| 30 | Materials and Labour for TMT bars 10 mm dia and over, as reinforcement for concrete cut to length, bent to shape required including cranking, bending, spirally hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.90mm dia, complete all as specified and directed. |
| 31 | Materials and Labour for TMT bars 6 to 10 mm dia in stirrups, spacers and binders, as reinforcement for concrete cut to length, bent to shape required including cranking, bending, spirally hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.90mm dia, complete all as specified and directed. |
| 32 | Materials and labour for providing heavy duty Virified Ceramic tiles 300x300x10 mm thick, polished, premium quality of colour as approved, in floors, paths, hardstanding etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match, laid over and including 15mm thick screed bed or bedding layer of cement mortar (1:4) complete all as specified and directed. |
| 33 | Materials and labour for chequered cement concrete tiles 20 cmx20cmx/30cm x 30 cm size, 25 mm thick (with grey cement and pigments), set, jointed and pointed in neat cement slurry in floor with grey cement mixed with pigments to match with the colour of tiles, laid over and including 15 mm thick screed bed in CM 1:4, complete all as specified and directed. |
| 34 | Labour only for laying machine pressed precast concrete interlocking paver block of any shape and size laid as directed to any shape complete all as specified and as directed. (Note: Serviceable paver blocks obtained against item No. 1.00 & 2.00 shall be reused) |
| 35 | Materials and labour for Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand Complete all as specified and as directed |
| 36 | Materials and labour for providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete all as specified and as directed |
| 37 | Materials and labour for 75 mm thick plain cementconcrete (1:3:6) type C2 using 40 mm graded stone aggregate as in sub-base of floors etc. finished the surface of concrete even and rough complete all as specified and directed. |
| 38 | Materials and labour for 75 mm thick plain cementconcrete (1:2:4) type B1 using 20 mm graded stone aggregate as in floors, path,paving etc. finished the surface of concrete even and smooth without using extra cement, laid in alternate bays, complete all as specified and directed. |
| 39 | Materials and labour for brick work with fly ash bricksmodular size, straight or curved on plan exc. 6mtr mean radius, built in cement mortar 1:6, complete all as specified and directed. |
| 40 | Materials and labour for rendering 15mm thickin cement mortar (1:4) on fair faces of brick work or concrete surfaces, finished even and smoothwithout using extra cement, complete all as specified and directed. |
| 41 | Materials and labour for applying three coats of white wash on newly plastered wall surface including preparation of surface, complete all as specified and directed. |
| 42 | Supplying and fixing of 15mm dia Unplasticised PVC pipes of pressure rating 10 kgf/cm2 fixed complete to walls, ceilings or in floors etc complete all as specified and directed. Note:- Quoted rate includes all plain UPVC fittings and pipe cuttings fixing with UPVC solvent cement and testing. |
| 43 | Supplying and fixing of 20mm dia Unplasticised PVC pipes of pressure rating 10 kgf/cm2 fixed complete to walls, ceilings or in floors etc complete all as specified and directed. Note:- Quoted rate includes all plain UPVC fittings and pipe cuttings fixing with UPVC solvent cement and testing. |
| 44 | Supplying and fixing of 25mm dia Unplasticised PVC pipes of pressure rating 10 kgf/cm2 fixed complete to walls, ceilings or in floors etc complete all as specified and directed. Note:- Quoted rate includes all plain UPVC fittings and pipe cuttings fixing with UPVC solvent cement and testing. |
| 45 | Supply & fixing rotational moulded polyethylene water storage tanks (cylindrical vertical with closed top) 1000 Ltr capacityhoisted and fixed in position, connecting with existing pipes all as specified in SSR Part I complete all as specified and directed. |
| 46 | Supply and fixing in repair 25 mm bore Gun metal gate or globe valve with iron wheel head screwed both ends for iron pipe complete all as specified and directed. |
| 47 | Supply and fixing in repair 25 mm bore Ball valves highpressure of PTMT with epoxy coated Aluminium rod &highdensity plastic ball screwed for iron pipe and fixed. (Minimum weight 15mm-142gms/ 2 0mm-210gms./25mm-455gms/ 40mm - 690 gms)complete all as specified and directed. |
| 48 | Materials and Labour for 40 mm average thickness plain cement concrete (1:2:4) type B-1, using 20 mm graded crushed stone aggregate as in padding over roof including formwork, making rounded chamfered on edges, complete all as specified and directed. Note: WPC shall measured and paid separately. |
| 49 | Supply and fixing galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings, straining, tightening and fixing to MS Nibs embedded in precast RCC fencing posts, struts, etc. securing and tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. Note: Each line wire to be measured. |
| 50 | Supply & fixing rolled mild steelFlats , channel, angle or tee sections as in wind ties for roof including securing bolts, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and as directed. |
| 51 | Supply & fixing Mild steel screw bolt (Machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends each screwed end to be filled with washers and one hexagonal or square nut 5 to 10mm dia shank and exc 5cm but n exc10cm longcomplete all as specified and as directed. |
| 52 | Supply & fixing Mild steel hand rails, half round or othersteel section or core for wooden hand-rail straight portion,drilled and countersunk for balusters running bars, fordoors, balusters, nosing to steps including embeding in concrete and screwing etc. wind ties for roof including securing bolts; nut 5 to 10mm dia shank and exc 5cm but n exc10cm long, posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and as directed. |
| 53 | Supply only chain link fencing with 4mm dia galvanised steel wire ,size of mesh 100mmx100mm complete all as specified and as directed. |
| 54 | Fixing only chain link fencing including line wires , any mesh, size and type to any type of standard, rails , straining bolts, etc including provision of binding wire complete all as specified and as directed. |
| 55 | Materials and Labour for round bars 10 mm dia and over for fixing of chain link fencing,cut to length, bent to shape required including cranking, bending, hooking ends and fixed, complete all as specified and directed. |
| 56 | Materials and labour for preparing of new steel surfaces of any description , over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer, complete all as specified and directed. |
| 57 | Materials and labour for preparing of new steel surfaces of any description , below 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer, complete all as specified and directed. |
| 58 | Supply and fixing PVC (SWR) pipes 75mm bore single socketed, in any length with rubber ring joints laid in concrete drains as weep holes, complete all as specified and directed. |
