|
| 1 | Note 1:- (Applicable for all parts/items) : The bidders/contractors are advised to read tender documents & all corrigendum/amendments and general condition of contracts before entry/quoting the rates.Note 2:- Attention to bidder is hereby invited to upload revised BOQ if published during their bid submission. Uploading ofincorrect/ pre-revised BOQ shall be treated as non bonafide and rejected. Fixed credit has been given in technical documents which shall be taken into account during acceptance of bid/tender. |
| 2 | Repair to potholes any depth, not exc 1 sqm each including sweeping free from dust and mud, or water, scoring sunken surfaces in roads, paths, etc. cutting around edges to at least 25 mm in depth but making good by applying tack coat @ 5 kg per 10 sqm, putting in premixed bituminous macadam, well rammed and sealed with binder 9.8 kg per 10 sqm, blinded with 0.09 cum of stone chippings, 6.3 mm size and again well rammed (including supply of premixed macadam, binder and chippings) depth of potholes exc 30mm complete all as specified and directed. |
| 3 | Preparing BLACK TOP surfaces by brushing with wire brushes for removing caked mud etc, sweeping with brooms and finally fanning the cleaned surface with gunny bags to remove all loose dirt etc and applying evenly a tack coat of catonic bitumen emulsion (RS-1) conforming to IS : 8887 at a rate of application of 0.5kg/sqm on bituminious surfaces using mechanical sprayer complete all as specified and directed. |
| 4 | M&L for Premixed Bituminous Macadam (using 4% binder contend) laid / rolled and compacted to required gradient and camber consolidated thickness 75mm or less) using paving bitumen of grade VG - 30) complete all as specified and directed. |
| 5 | M&L for Bituminous premix semi dense asphaltic concrete 40 mm thick consolidated thickness with 5.50% binder content by weight of total mix using PavingBitumen of grade 30 (VG 30), rolled and compacted, mixedin mechanical hot mixed plant and pre-mixed material laid with mechanical paver, finished including rolling to required gradient and camber with 8 to 10 tonne power roller to required compaction complete all as specified and directed.Note:- Semi dense asphaltic bituminous concrete shall be designed as specified and binder content shall be provided as per design mix, contractor shall quote his rates considering the bitumen contents as 5.5%.Any variation in binder content on minus side shall be adjusted at the rate of Rs. 50.00 per Kilogram of binder but variation on plus side shall not be paid extra.Contractor shall quote accordingly |
| 6 | M&L for 2.5 mm thick painting to road surfaces as in lines, dashes, arrows, zebra cross etc on roads, pavements and like with thermoplastic road marking paint @ 5Kg/Sqm and applying glass grit(BS 6088) @ 300 gram/Sqm over painting surfaces while the painting surfaces are hot by mechanical means including cleaning surfaces complete all as specified and directed.Note:- Application shall be carried out through mechanical applicances by the approved applicator of the manufacturer of paint. |
| 7 | S&F in repair Cat Eyes (Futurevista make or equivalent) made of non breakable polycarbonate with electronically welded primatic retro reflective lens on centre for maximum retroreflection in wet and dry conditions, with dust proof body (i.e. no dust accumulation on lens) and space built for finger grip. Bitumen adhesive B1-69 shall be used for fixing the Cat Eyes complete all as specified and directed. |
| 8 | Excavation in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out soft and loose soil complete all as specified and directed. |
| 9 | Returning, filling in, including spreading, levelling, watering and well ramming in layersnot exc 25 cm complete all as specified and directed. |
| 10 | Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with CM (1:3), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete all as specified and directed. |
| 11 | Demolition of Brick work or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars, etc. but excluding ashlar facings, dressed stone work and precast concrete articles complete all as specified and directed. |
| 12 | M&L for brickwork with subclass \"B\" bricks, straight or curved on plan exc 6m mean radius built in CM (1:6) complete all as specified and directed. |
| 13 | Taking down cement plaster of any description any thickness incl racking out joints hacking for keys scrubbing down with water etc complete all as specified and directed. |
| 14 | M&L for 15mm thick plastering on fair faces of brick work or concrete surfaces in CM (1:6) and finished even and smooth without using extra cement complete all as specified and directed. |
| 15 | M&L for prepration of new wall surfaces and applying two coat of camouflage painting exterior grade emulsion paint (Colour and design as equired/approved by Engr-in-charge), over a coat of primer etc complete all as specified and directed. |
| 16 | Demolition of Plain cement concretein ground floors and pavings n exc 15 cm thickness below or above ground level complete all as specified and directed. |
| 17 | Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour,design & pattern as in footparth, parks,lawns, drive ways or light traffic parking etc.,of required strength thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed. |
| 18 | Dismantling floor hearth or wall tiling incl cement mortar bedding (but not backing) complete all as specified and directed. |
| 19 | M&L for chequered cement concrete tiles 20cm x 20cm x 25mm thick with grey pigment cement and pigment, set, jointed and pointed in neat cement slurry in floors ver & including 20 mm thick screed bed in CM (1:6) complete all as specified and directed. |
| 20 | M&L for 75mm thick plain cement concrete type B-2 (1:3:6) (using 40mm graded stone aggregate) in hardstanding finished even and fairwithout using extra cement etc complete all as specified and directed. |
| 21 | M&L Providing, cement concrete type B-1 (1:2:4) using 20 mm graded stone aggregateinrounded or chamfered on edges complete all as specified and directed. |
| 22 | Scarifying or picking gravelled, macadam or bituminous macadam suraces in area exceeding 400sq.m,exceeding 50mm and nexc 100mm deep, complete all as specified and as directed. Note:- Scarifying material obtained shall be proper seiving and stacking complete all as specified and directed. |
| 23 | Laying and comapacting 150 mm thick (compacted thickness) wet mix macadam (WMM) in two layers of 75mm eachgrarding as per table 400-13 of MoRTH specifications for road and bridge works 2013 manufactured in WMM plant , materials comprising of clean , crushed, graded aggreegate and granular materials premixed with water to a dense mass , spreding withpaver and rolling with vibratory roller of capacity 80-100 KN static wight and consolidating to required gradient and camber complete all as apesified and directed. The finished surface tolerences to be as per table 900-1 of MoRTH specifications for road and bridge works 2013. |
| 24 | M&L for preparing Unsurfaced water bound macadam surfaces by brushing with wire brushes for removing caked mud etc. sweeping with brooms and finally fanning the cleaned surface with gunny bags to remove all loose dirt etc complete all as specified and directed. |
| 25 | M&L for applying evenly a priming/tack coat with bituminous primer with paving bitumen (RS-1) at 10 kg per 10 sqm complete all as specified and directed. |
| 26 | M&L for applying evenly a priming/tack coat with bituminous primer(RS-1) at 5 kg per 10 sqm complete all as specified and directed. |
| 27 | S&F in repair Bi-Directional abrasion resistant raised pavement makers/Cats eye made out of micro prismatic tough polycarbonate lens of approved colour, Engineered thermoplastic body and fixed on the road with epoxy / approve adhesive including making good the disturb portion of the road complete all as specified and directed. |
| 28 | M&L for Continuous burnt clay brick of sub class B edging; with width equal to the depth of the brick, laid dry, on end vertically complete all as specified and directed.Note:-The rate include for embedding bricks in the ground to depths indicate and tamping ground around bricks and also for removing any surplus spoil etc. |
