|
| 1 | Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead. dsr 2023 i.no 15.56 |
| 2 | Dismantling of flexible pavement (bituminous courses) by mechanical means and disposal of dismantled material up to a lead of 1 kilometre, as per direction of Engineer-in-charge. |
| 3 | Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge.. In cement mortar dsr 2023 i.no 15.7.4 |
| 4 | Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:4 (1 cement : 4 coarse sand) DSR 2023 I.NO 6.1.1 |
| 5 | Providing, laying spreading & compacting of granular sub base (GSB) by providing close graded (Fr-1) materials, sprading in uniform layers with Mortor Graded on prepared surface, mixing by mix I n placed method with Rotovater at OMC and compacting with in layers with smooth wheeled Vibratory Roller to achieve the desired density, complete as per MoR &H clause 401& as directed by Engineer Incharge including all machine charges & including all labour, T& P etc req for proper completion of work. Analysis rate |
| 6 | 12 mm cement plaster of mix : 1:4 (1 cement: 4 coarse sand) dsr 2023 i.no 13.4.1 |
| 7 | 1:2:4 (1 cement : 2 coarse sand(zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) dsr i.no 4.1.3 |
| 8 | 30mm red sand stone sun-shade (chisel-dressed) supported on red sand stone brackets, fixed in walls with cement mortar 1:4 (1 cement : 4 coarse sand) including finishing complete. dsr 2023 i.no 7.3 |
| 9 | 40 mm thick rubbed stone flooring over 20 mm (average) thick base of cement mortar 1:5 (1 cement :5 coarse sand) with joints 3mm thick, side buttered with cement mortar 1:2 (1 cement : 2 stone dust) admixed with pigment to match the shade of stone and pointing with same mortar Red sand stone dsr 2023 i.no 11.30.1 |
| 10 | Providing 50mm thick precast cement concrete Jali 1:2:4 (1 Cement : 2 Coarse sand: 4 graded stone aggregate 6mm nominal size), reinforced with 1.6mm dia mild steel wire, including centering and shuttering, roughening cleaning, fixing and finishing in cement mortar 1:3 (1 cement: 3 fine sand) etc. complete, excluding plastering of the jambs, sills and soffits. SI 31 DSR 16 5. 18.1 |
| 11 | Wall painting with acrylic emulsion paint, having VOC (Volatile Organic Compound ) content less than 50 grams/ litre, of approved brand and manufacture, including applying additional coats wherever required, to achieve even shade and colour. Two coats. dsr 2023 i.no 13.83.2 |
| 12 | Painting with synthetic enamel paint of approved brand and manufacture to give an even shade : Two or more coats on new work. dsr 2023 i.no 13.62.2 |
| 13 | Suppy and instalation of See-Saw two seater item Code No SS-01 (make by royal Amusements) or equivalent quality as directed by E/I. MRpark 2 |
| 14 | Suppy and instalation of designer straight slidder (8 feet) item Code No SD-06D (make by royal Amusements) or equivalent quality as directed by E/I .MRpark 2 |
| 15 | Suppy and instalation of Swing 2 seater item Code No SW-02 (make by royal Amusements) or equivalent quality as directed by E/I . MRpark 2 |
| 16 | Supply and fixing R.C.C. sleeper/batton moulded bench, required as per direction of Engg I/C. Including fixing with necessary nuts and bolts in proper possition. (Analysis rate) park 2 |
| 17 | Cartage of dismentled material 3km distance UPPWDSOR 2023-24 S.NO 3 page .no. 16A |
| 18 | Supply of Solar AIO Single piece High pressure Die cast (LM6 Alloy) 17W Aluminium housing appearance of Solar AIO shall be traditional Street Light, IP65 & IK08, suitable for OD 50/60mm bracket, having Min 3000 lumens, suitable for 24hrs (2 Nights) Autonomy and its backup calculation sheet shall be approved by Consultant Dimming Profile :• From Dusk – First 05hours sensor enabled with 30% brightness level• Next 05Hours sensor disabled and fixed at 30% Brightness level• Next 2hours/dawn- Sensor enabled with 30% brightness levelLithium pherrophosphate Battery capacity min [email protected] or 256 watt hour & shall be of fresh manufactured battery (Not re-used cells) Battery Temp range -20-+60℃ and panel capacity min 35Wp, CRI >=70, Efficacy Min >175lm/W is MUST, system wattage should not be more than 17W ± 5%, if wattages increases then the size of battery & panel shall also be increased in similar percentage to maintain equal autonomy of the system. Life class of LED System 50000hrs@L70, LED Make - CREE/ NICHIA/ LUMILEDS /OSRAM. CE Certified, charger efficiency >90% and standards IEC62109-1, IEC61547, CISPR15, IEC62093, IEC61347-2-13, EN50530, IEC62384 The PV module should be made up of crystalline silicon solar cells \"Mono-Crystalline\" and must have a certificate of testing conforming to IEC 61215 Edition II / BIS 14286 & IEC 61730-1,2 IEC60598, Operating temp 0 Degree C to 50 Degree C, certifying above given prameters all reports shall be from In-house NABL or IECQ or any international accredited Laboratory, Complete luminaire /battery/panel/charge controller must be BIS accredited (If applicable) and as per UPPWD Approved Product List. With five yeart warrenty |
| 19 | Supply & fixing of 7m GI Octagonal Pole of approved make (top dia 70mm, bottom dia 130mm and base plate 12mm thick) having 3mm thickness with single arm bracket (1m length) on RCC foundation including the cost of foundation, foundation bolts, excavation & back filling and required T&P complete in all respect. |
| 20 | Providing & Fixing of Hand Boring with 150 mm Q Buro hole by casing pipe method in ordinary soil including correction ….. Levelling of side complete.. |
| 21 | Supply of 110 mm Q 6 kg / sqm I.S.I. mark P.V.C.pipe including all taxes cartage up to side including cord cape. |
| 22 | Providing & Laying of Column Pipe 50 mm dia |
| 23 | Supply of solvent |
| 24 | Supply of Filter Cloth |
| 25 | Supply of 1.5 H.P.I.S.I. Marka K.S.B.make or equivalent Submersible Motor Pump Complete. |
| 26 | Supply of 3 Phase 2.5 mm I.S.I. Marka Flate cable |
| 27 | Supply of Starter with overload relay I.S.I.mark. |
| 28 | Supply of 50 mm dia Iron clamp |
| 29 | Supply of 2 \" Nipple 50 mm dia. |
| 30 | Supply of 2 \" Albow Please Enable Macros to View BoQ information |
