Tender For Supply And Construction Of Misc Works For Fd Tech Shelter In Rms - Portland Pozzolana Cement: PPC cement, IS-1489 (Part- E 2) for calined clay-based PPC and IS 1489 (Part-1) for fly ash based PPC), packed in 50 Kgs HDPE bags conforming to IS 11652/2000 (Make AMBUJA/ACC/ ULTRA TECH DALMIA/RAMCO/BIRLA) Coarse Sand Sand shall be clean, sharp, angular hard and durable free from adherent coating and shall not contain clay, mica and other impurities. The maximum quantities of clay and fine silt in sand shall not be more than 5% by mass as per IS-383-1970 20mm Stone Aggregates: Stone aggregate shall be crushed stone 20mm graded conforming to IS-383-1970 and shall be clean hard tough, durable and of uniform quality throughout. The aggregate shall be free from soft disintegrated materials, vegetable and other organic impurities. 40mm Stone Aggregates: Stone aggregate shall be crushed stone 40mm graded conforming to IS-383-1970 and shall be clean hard tough, durable and of uniform quality throughout. The aggregate shall be free from soft disintegrated materials, vegetable and other organic impurities Hardcore 63 mm Stone Aggregates: Stone aggregate shall be crushed stone not exceeding 63mm graded conforming to 15-383-1970 and shall be clean hard tough. durable and of uniform quality throughout. The aggregate shall be free from soft disintegrated materials, vegetable and other organic impurities. TMT Bar 8mm dia (Make- TATA/SAIL/JAI BALAJI) TMT Bar 12mm dia (Make-TATA/SAIL/JAI BALAJI) TMT Bar 16mm dia (Make-TATA/SAIL/JAI BALAJI) Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%) total coated thickness with zinc coating 120 grams per som as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer in-charge. The sheet shall be fixed using self drilling/self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. S&F of False ceiling: Providing powder coated Aluminium Main T - 38mm * 25mm * 1.5mm thickness Cross T-25mm * 25mm * 1 thickness and Wall angle-25mm x 25mm * 1.5mm thickness and using 2mm SS Rod for suspension and Level adjustment for J Bolt & Nut using and L Clip/Joint Plate /Rivet/Screws and all necessary Hardware items using (Grid Size is 595mm X 595mm). Make: Everest pearl designer ceiling tiles or equivalent and laying 12mm Gypsum board false ceiling fixed to at the bottom of roof trusses/roof sheets and applying two coats of acrylic emulsion paint over one coat of primer with all materials, complete as directed by Engineer-in-charge. Sub class B Bricks size 230 * 115 * 75mm Glazed Ceramic Wall Tile 300mm * 450mm * 7 - 8 mm thick (Make:Kajaria/Asian/Orient/Johnson) Synthetic enamel paint, Make: Asian, Berger Salimar Putty Primer for oil bound distember paint. Make: Asian, Berger Salimar Oil bound distemper Make: Asian, Berger, Salimar Binding Wire 0.90mm Ply wood 19mm thick size 8 * 4 Water proof) Nails Paint brush 2 ^ n Paint brush underline 4 ^ prime prime Ovell shape WHB confirming to IS-2556 Part-II (1981) shall be of size 550 x 410mm flat back pattern with a chromium plated pillar taps of 15 mm diameter of approved design with 32mm diameter chromium plated waste coupling and 32mm diameter PVC waste pipe. Toilet paper holder of vitreous china fixed to wall with chromium plated CP brass screws, (Make Bharat/Parryware/Sona/Prayag) Vitreous china urinals, bowl type (back or corner wall type), complete including providing and fixing plugs, bedding urinal against wall in cement mortar 1:2, securing urinal to plus with and including 60mm long brass screws. pointing around urinal back in cement; fixing automatic flushing cistern with brackets, flush pipe, grating and union for discharge pipe Vitreous china urinals, bowl type (wall mounted large type), size: 340 x 380 x 610mm, complete including providing and fixing plugs, bedding urinal against wall in cement mortar 1:2, securing urinal to plus with and including 60mm long brass screws, pointing around urinal back in cement, fixing automatic flushing cistem with brackets, flush pipe, grating and union for discharge pipe Urinals valve auto closing system with built in control cock and wall flange for urinal, Make: Jaguar, Parryware/CERA 12mm thick high pressure laminate (HPL) compact board with stainless steel hardware, dimensions of divider 1200 height, 500mm width and 300 mm depth. Divider for Urinals. Make: Jaguar, Parryware/CERA Corner shelf of toughened glass with Chromium plated steel frame PVC Connection Pipe 450mm long alongwith both side of neat of size 15mm dia (Make Prayag) CP Brass Angle Cock 15mm dia Make: Bharat/Parryware/Sona/Prayag) CP Brass Bib Cock 15mm dia Make: Bharat/Parryware/Sona/Prayag
