Horizontal Cylindrical High Pressure High Speed Steam Manufactured As Per Bis Specification No. Is: 3829 (Part-2) ? 1978, With The Latest Amendments And Bearing Isi Mark Is: 3829(Part-2).Shape & Dimension: Cylindrical 400Mm X 600Mm (16? X24?) Approx.Mode

Sharing tender

Horizontal Cylindrical High Pressure High Speed Steam Manufactured As Per Bis Specification No. Is: 3829 (Part-2) ? 1978, With The Latest Amendments And Bearing Isi Mark Is: 3829(Part-2).Shape & Dimension: Cylindrical 400Mm X 600Mm (16? X24?) Approx.Mode Of Heating: Electrically Heated By Immersion Heaters Of 18Kw Electric Load Wired For Operation On 3Phase 4-Wire, 400/440 Volts 50Hz A.C. Supply.Working Pressure: 30 Lbs/Sq. Inch 2.20Kgf/Cm2.Operating Pressure: 2.10 +0.15 Kgf/ Cm2 Approx. (30Psi).Operating Temperature : About 134?C.Hydrostatic Test: The Shell Should Be Subject To Hydrostatic Test To Twice The Working Pressure.Material Of Construction:A)Chamber & Back Plate: Ss Sheet Of Grade (04Cr18ni10) 304 Non-Magnetic 10Swg.B)Jacket & Boiler: Ss Sheet Of Grade (04Cr18ni10) 304 Non-Magnetic 12Swg.C)End Ring: Ss 304L Non-Magnetic.D)Piping & Connections: Made Of Stainless Steel Having Mirror Finish.E)Dished Door: Stainless Steel 304 Quality 14Mm Thick.Dished Door: Fitted With Radial Arms Of Ss-304 To Manipulate Smoothly By Well-Insulated Handles, And Should Have Automatic Pressure Locking Device Of Gun Metal With Brass Hinges To Provide Complete Safety To The Operating Personnel Against Any Explosive Opening Of The Door Under High Pressure. The Dished Door Should Lock Positively When Pressure In The Chamber Is 0.35 Kgf/Cm2 Or More And The Lock Should Not Be Released Until The Pressure Falls Below 0.35Kgf/Cm2 Or Less. Provision Id Made To Tighten The Dished Door While In Locked Position. A Moulded Steam And Heat Resisting Silicone Rubber Gasket One Piece Without Joint Is Fitted To The Door.Operating Valve: To Control The Cycle Of Sterilization As Per Isi Standards.Safety Valve: As A Pressure Switch For Controlling Pressure Is Provided On The Jacket, Spring- Loaded Safety Valve Should Be Provided To The Jacket As A Safe Guard Against Excess Pressure In The Jacket.Ejector: A Powerful Ejector System To Create Partial Vaccum (Help In Quick Drying).Drying System: Allows Filtered Air Into The Chamber During Drying Cycles.