Tender For Special Repair Of Khirkiya Bargadiya Road - Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density complete work. 2 Providing and laying of 80 mm thick Interlocking cement concrete tiles (300mpa) including laveling and dressing of surface to required level and slope, filling joints with local sand including the cost of material,labour T&P etc.required for proper completion of work as directed by Engineer-in-Charge. SOR Chp. 20 New Item No. 1 3 Cement concrete with 4 cm. (1½) gauge approved stone, ballast, approved coarse sand and cement in the proportionof 8:4:1 including supply of all materials, labour and T&P etc. required for proper completion of the work. SOR 281 4 First class brick work in 1:4 cement and coarse sand mortar in foundation and plinth including supply of all materials, labour and T&P etc. required for proper completion of the work. SOR 305 5 Cement concrete with 2 cm. (1½) gauge approved stone, ballast, approved coarse sand and cement in the proportionof 4:2:1 including supply of all materials, labour and T&P etc. required for proper completion of the work. SOR 279(i) 6 Construction (E/W in cutting/Filling of Patri) of Subgrade and earthen shoulders with apporved material obtained from borrow pits with attl ifts and leads transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300.2 with a lead upto 1000 m as per Tecnical Specification Clause 303.1 7 Construction (E/W in cutting/Filling of Patri) of subgrade and earthen shoulders with approved material obtained from boeeowpits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300-2 (Carted 3.00 Km) 8 Construction ofun-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design,laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days,using curing compound (where specified) and water finishing to lines and grade as per drawingand Technical Specification Clause 1501
