|
| 1 | Item Name :- 3)WBM Grading 3Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, applying and brooming, stone screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density Grading 3 as per Technical Specification Clause 405.(A)By Manual Means (Including Cost of All Matarial T&P, Royalty, Taxes, Labour Cess etc but Excluding GST ) |
| 2 | Item Name :- Prime Coat (i) Low porosityProviding and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70 kg/sqm using mechanical means as per Technical Specification Clause 502 (Including Cost of All Matarial T&P, Royalty, Taxes, Labour Cess etc but Excluding GST ) |
| 3 | Item Name :- Tack CoatProviding and applying tack coat with Bitumen VG-10using bitumendistributor at the rate of 0.30 kg per sqm on the prepared granular surfaces treated with primer & cleaned with Hydraulic broom as per Technical Specification Clause 503. (Including Cost of All Matarial T&P, Royalty, Taxes, Labour Cess etc but Excluding GST ) |
| 4 | Item Name :- 20mm thick Open-Graded Premix Carpet using Bituminous (penetration grade/modified bitumen) BinderProviding, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by seal coat of either Type A or Type B or Type C as per Technical Specification Clause 508.Case - I ByManual Means (I)Bitumen (S-90) (Including Cost of All Matarial T&P, Royalty, Taxes, Labour Cess etc but Excluding GST ) |
| 5 | Item Name :- Seal CoatProviding and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type A, Type B and Type C as per Technical Specification Clause 510 A.By Manual Means Case - III :Type C (I)Bitumen (S-90) (Including Cost of All Matarial T&P, Royalty, Taxes, Labour Cess etc but Excluding GST ) |
| 6 | Item Name :- Cement Concrete PavementConstruction ofun-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than0.2 cum capacity and appropriate weigh batcher using approved mix design,laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixture (Including Cost of All Matarial T&P, Royalty, Taxes, Labour Cess etc but Excluding GST ) |
| 7 | Item Name :- Construction of Subgrade and Earthen ShouldersConstruction of subgrade and earthen shoulders with approved material obtained from R.O.W. with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300.2as per Technical Specification Clause 303.1. |
