Tender For Repairs To Paths, Hardstanding And Misc B/R Repairs In Domestic Area At Af Stn Sirsa; 1 2 Unsc PCC Paver Block, any size or thickness 500.00 Sqm 10.00 5,000.00 2 5 Unsv Brick bats of any description. 32.50 Cum 500.00 16,250.00 3 6 Unsv scrap iron, reinforcement bars of any desc. 120.00 Kg 24.00 2,880.00 4 7 Unsv MS sections, any type or size 200.00 Kg 25.00 5,000.00; 1 M&L for Dismantling PCC Tiles of any description or thickness, in paths, aprons, hardstanding, etc. laid, bedded and pointed in Cement Mortar, removal of debris outside AF land, cleaning of area to remove dust, debris, loose particles, washing with water complete all as specified and directed. 2 M&L for Dismantling PCC Blocks of any description or thickness, in paths, aprons, hardstanding, etc. laid dry incl removal of debris outside AF land, cleaning of area to remove dust, debris, loose particles complete all as specified and directed. 3 Dismantling Floor, Paver Tiles, Hearth or Wall Ceramic Tiling,etc. including Cement Mortar Bedding (but not backing) and removing debris, etc. to Outside MD/AF Land, complete all as specified and directed. 4 Demolition Cement Concrete (un-reinforced) of any description in Ground Floors, Pavings, etc. not exc. 150mm thickness (above or below Ground Level) and removing debris, etc. to Outside MD/AF Land, complete all as specified and directed. 5 Demolition Brick work built in Cement Mortar and in any Position including all Quoins, Arches and Pillars, etc., and removal of debris outside AF land complete all as specified and directed. 6 Demolition of Cement Concrete (Reinforced) of any description in Ground Floors, Pavings, etc. not exc. 150mm thickness (above or below Ground Level) (reinforcement cut as required to facilitate demolition) and removing debris, etc. to Outside MOD Land, complete all as specified and directed.(NOTE: Old reinforcement shall be measured under Sch of Credit) 7 Dismantling wrought iron or mild steel work of any description in rafters, purlins and wind ties wtc and removal from site complete all as specified and directed.NOTE: If the planned MS structure, truss, etc is different from the existing structure, proper measurement of the existing structure to be demolished, shall be recorded in MB duly signed by the Engineer-in-Charge. 8 Taking down Cement Plaster including raking out Joints, hacking for Key, scrubbing down with Water and removing Debris, etc. to Outside MD/AF Land, complete all as specified and directed. 9 M&L for Brick Work with Fly-AshBricks (Old Size Bricks), Straight or Curved on Plan exc. 6.0 Metre mean Radius, built in Cement Mortar 1:6, complete all as specified and directed. 10 M&L for 15 mm thick plastering in two layers, 10 mm + 5 mm in cement mortar 1:4, top layer of 5 mm thickness provided as a setting coat on surfaces ofbrick walls or concrete surfaces finished even and smooth without using extra cement complete all as specified and directed. 11 M&L for preparation of new plasterd/concrete surfaces and applying two coats of cement base paint over a coat of white wash complete all as specified and directed. 12 M&L for preparation of new plasterd surfaces and applying three coats of white wash complete all as specified and directed. 13 M&L for Hardcore of broken stone or boulder of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface complete all as specified and directed. 14 M&L for Cement concrete, 100 mm thick, type D- 2, 1:4:8 (40mm graded aggregate) in sub floors, sub bases, pavings etc., complete all as specified and as directed. 15 M&L for Cement concrete, 75 mm thick, type C- 2, 1:3:6 (40mm graded aggregate) in sub floors, sub bases, pavings etc., complete all as specified and as directed. 16 M&L for Cement concrete, 25 mm thick, type B-0, 1:2:4 (12.5mm graded aggregate) in sub floors, sub bases, pavings etc., complete all as specified and as directed. 17 Supply and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed.NOTE : Quoted rate shall deem to include the cost of sand cushioning. 18 M&L for providing rubber moulded cement concrete coloured chequered tiles 300x300x22-25mm thick, set, jointed and pointed in neat cement slurry in floors, with grey cement and pigment, laid over and including 20mm thick screed bed in cement mortar 1:4 complete all as specified and directed.NOTE : Quoted rate shall deem to include the cost of cement screed bed. 19 M&L for providing outdoor ceramic Floor (Paver) Tiles, 300 x 300 x 9-10mm thick, of design and pattern as sprroved by GE, Anti-skid, Impact Resistant, set and jointed in neat cement slurry, laid over and including 15mm thick screed bed in cement mortar 1:4, tiles fixed with spacers to provide provide a uniform spacing of 3-5mm between the tiles and after setting of screed bed and tiles, removing the spacers and filling the joints and pointing with suitableepoxy grout complete all as specified and directed.NOTE : Quoted rate shall deem to include the cost of cement screed bed and epoxy grout. 20 M&L for providing outdoor ceramic Floor (Paver) Tiles, 400 x 400 x 12 mm thick, Anti-skid, Impact Resistant, of design & pattern as approved by GE, set and jointed in neat cement slurry, laid over and including 15mm thick screed bed in cement mortar 1:4, tiles fixed with spacers to provide provide a uniform spacing of 3-5mm between the tiles and after setting of screed bed and tiles, removing the spacers and filling the joints and pointing with suitableepoxy grout complete all as specified and directed.NOTE : Quoted rate shall deem to include the cost of cement screed bed and epoxy grout.(MAKE: Kajaria, DuRock Series / Simpolo, Rockdeck Series / Johnson, Endura Series / Somany, Durastone Series / AGL, Grandura Plus or similar products in other makes specified in tender) 21 S&F in position, at or near ground level, factory made precast cement concrete kerb stone blocks, in M-25 grade cement concrete, fixed to the required line, level and curvature, jointed in cement mortar 1:3, including making joints with or without grooves (thickness of joints, except at sharp curves shall not be more than 5 mm) including making drainage opening wherever required complete all as specified and directed. 22 M&L for Cement Concrete 1:2:4 type B1 (20mm graded stone aggregate) as in Coping, Bed Plates, Holdfast, Bed Block, Kerb Stonesincluding necessary Formwork and weathering, slightly rounded or chamfered angles and throating, complete all as specified and as directed. 23 Excavation over areas not exceeding 1.5 metre in depth in soft/loose soil and getting complete all as specified and as directed. 24 Excavation in trenches not exc 1.5 metre width and not exceeding 1.5 metre in depth in soft/loose soil and getting complete all as specified and as directed.NOTE: Width of excavation should not be more than that specififed under Para 3.2.3 of SSR part-II (Rates). 25 -ditto- as per Item Nom 22 here-in-before but for portions of road/hardstanding etc, not exc 1.50 m wide and not exc 1.50 m deep and getting out in soft/loose soil complete all as specified and directed. 26 Returning, filling in including spreading levelling watering and well ramming in layers n.exc 25 thick for soft/loose soil complete all as specified and as directed. 27 Removal of excavated material to a distance n.exc 50 metre and depositing where directed at a level n.exc 1.5m above the starting point complete all as specified and as directed. 28 M&L for Cement concrete, type D- 2, 1:4:8 (40mm graded aggregate) as in foundation filling and mass concrete complete all as specified and as directed. 29 M&L Loose Filling with Aggregates of gauge 80mm to 150mm (Broken Bricks) in recharge pits, etc., complete all as specified and as directed. 30 M&L for coarse sand filling, inside recharge pits, in layers complete all as specified and directed. 31 Supply and laying Reinforced Concrete Pipes 150mm (internal dia), Class NP-3, laid in Trenches on Concrete Bed, to required Slope, jointed with jute & cement mortar 1:1, complete with collars all specified and as directed. 32 M&L Cement Concrete 1:3:6, type C2 (40mm graded stone aggregate) as in Concrete Bed to Drain Pipes of 150mm bore (dia), including packing under, and haunching against the sides of pipes after they are laid and testedcomplete all as specified and as directed. 33 M&L Reinforced Cement Concrete 1:1½:3 type A1 (20mm graded stone aggregate) in Slabs & beams supported on Walls, etc., finished Even and Smooth without using Extra Cement, complete all as specified and as directed.NOTE : Formwork & Reinforcement will be Measured and Paid separately under relevant Items. 34 M&L for Use and Waste of Formwork to Soffits of Suspended Slab and similar work not exc. 200mm thick, Fair Finished surfaces, complete all as specified and as directed. 35 M&L TMT Bars 10mm dia and over, cut to length, bent to shape required including cranking, bending spirally for hooping for Columns, hooking Ends and binding with and including Mild Steel Wire (annealed) not less than 0.90 mm dia, complete all as specified & directed. 36 M&L for Mild steel framed works such as grills, gratings etc. with ends of bars shouldered and/or riveted or forged into spikes, framed guard bars, barred iron doors, ladders, framed balusters, walkways, railings, framework of water tanks and similar works conforming to Fe-290 Gde E-165 complete all as specified and directed.(NOTE: Quoted rate shall deemed to include for the cost of all GI anchor bolts & nuts, screws, rawl plugs, etc as required for fixing the grills/MS structure to walls or openings. No claim shall be entertained during currency of work. 37 M&L preparing new or previously untreated Steel and Iron Surfaces of any description, over 10 Cm width or girth and applying Two Coats of Synthetic Enamel Paint (First quality) over a coat of Red Oxide Zinc Chrome Primer, complete all as specified and directed. 38 M&L preparing new concrete surfaces of kerbs, of any description, over 10 Cm width or girth and applying Two Coats of Synthetic Enamel Paint (First quality), in different shades as directed by Enginbeer-in-Charge, over a coat of suitable cement primer complete all as specified and directed. 39 M&L preparing old concrete surfaces of kerbs, of any description, over 10 Cm width or girth and applying One Coat of Synthetic Enamel Paint (First quality), in different shades as directed by Enginbeer-in-Charge complete all as specified and directed.
