|
| 1 | Design, Construction, Supply, Erection, Testing, Commissioning of 400 MLD capacity Main Pumping Station (MPS) and 100 MLD Sewage Treatment Plant (STP) based on Sequential Batch Reactor (SBR) Technology alongwith Power Generation comprises of Main Receiving Chamber, By Pass Channel, Inlet Chamber, Coarse Screen Chamber, Distribution Chamber, Wet Sump, Piping Gallery, Walkway, Stilling Chamber, Fine Screen Chamber, Sump, Grit Chamber, Distribution Channel, Distribution Chamber, Valve Chamber, Primary Clarifier, Distribution Chamber, SBR Basin, Equivalization Tank, Rapid Gravity Filters, Pump Sump, Receiving Chamber, Treated water channel, Flash Mixer, Floculators, Inclined tube settlers, Distribution Channel, Outlet Channel, Chlorine Contact Tank, Combined Sludge Sump, Thickened Sludge Sump, Sludge Thickener, Sludge Chambers, Anaerobic Sludge Digestor, Digested Sludge Sump, Gas Holding Tank on turnkey basis complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) 1.1. Complete Civil Works |
| 2 | Design, Construction, Supply, Erection, Testing, Commissioning of 400 MLD capacity Main Pumping Station (MPS) and 100 MLD Sewage Treatment Plant (STP) based on Sequential Batch Reactor (SBR) Technology alongwith Power Generation comprises of Sluice valve (motorized and manual), NRV (manual), Sluice Gate (Motorized), Gate valve (manual), Diaphragm valve (manual), Dismantling Joint, Ultrasonic sensor with indicator / Meters, Ultrasonic flow meter, Online analyzer, Strainer, Laboratory equipments, Air Blowers, Agitators, for (Flash Mixer, Chemical Solution Tanks for Ferric Chloride, Lime, Polyeletrolyte, Sludge Thickener, Flocculator, Grit Mechanism), Manual Coarse screen, Manual Fine Screen, Mechanical coarse screen, Mechanical Fine screen, Inclined tube settler, Decanter for SBR, Belt Filter Press for sludge dewatering, Digester mixing system, Bio Gas compressor, Biogas Handling system complete, All pumps complete, Thickened sludge pumps, Digester mixing pumps, Digested Sludge pumps, Booster Pumps, Metering Pumps, EOT, Automation System (PLC / SCADA), Cabling, LT and HT Panels, CCTV cameras, Gaseous Chlorinators, Chlorine tonners, Exhaust Fans, Weirs, External Lighting, D.G. Sets, Transformer, Odour Control Unit, Prov. and laying of D.I. Pipe fitting with specials including excavation etc. on turnkey basis complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) 2.1. Complete Electrical, Mechanical and Instrumentation Works |
| 3 | Design and Construction of RCC M-25 Framed structure Building (Single Storey and Double Storey) Confirming to National Building Code for Control room for compressed Bio Gas Generator room, Scrubber / Buffer Tank, Compressor and Heat Exchanger platform, Power House Building, Sub station yard, Admin cum Lab Building, Chemical House Building, Combined and thickened sludge (Pump and Panel room), Chlorination room, Tonner room, Digested Sludge Pump and Panel Room, Rapid Gravity Filter Gallery, Belt Filter Press Building, Guard Room, Staff quarters, Main gate including all Electrical, Mechanical and other contingent work thereto as per sizes and specification given in the DNIT. Total Minimum area of above buildings are 3250 Sqm or more if required as per design complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) |
| 4 | Design and Construction of RCC Platforms for Transformer yard, D.G. Set yard, Air Blower for SBR, Dry sludge platform, Air blower for filters etc and all other work contingent thereto as per sizes and specification given in the DNIT complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) |
| 5 | Providing chemical i.e. Ferric Chloride, Lime, Polyelectrolyte, Chlorine for 3 months trial run and all other works contingent thereto. |
| 6 | Providing, lowering, cutting, jointing and testing of 2000mm i/d RCC pipe Class - Np3 with HDPE lining as per IS 458 - 2003 with spigot and socketted joints manufactured with ISI marked Sulphate Resistance Cement as per ISI 12330 with rubber rings ISI marked,antitermite as required at site, into trenches, for all depths and laying out the same to correct alignment, gradients and levels including dressing and trimming and cutting of concrete beds and sides of trenches, if required, jointing with rubber rings in trenches and jointing with 1: 11/2 cement sand mortar and with end dowels filled with 1:1 1/2 cement sand mortar and finishing the joints at an angle of 45 degree with faces of spigot of socket joints cutting and finishing the cut surface alongwith construction of manholes, dewatering and dismantling of existing road, if any and its reconstruction complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) |
| 7 | Providing, lowering, cutting, jointing and testing of 400mm i/d RCC pipe Class - Np3 with HDPE lining as per IS 458 - 2003 with spigot and socketted joints manufactured with ISI marked Sulphate Resistance Cement as per ISI 12330 with rubber rings ISI marked,antitermite as required at site, into trenches, for all depths and laying out the same to correct alignment, gradients and levels including dressing and trimming and cutting of concrete beds and sides of trenches, if required, jointing with rubber rings in trenches and jointing with 1: 11/2 cement sand mortar and with end dowels filled with 1:1 1/2 cement sand mortar and finishing the joints at an angle of 45 degree with faces of spigot of socket joints cutting and finishing the cut surface alongwith construction of manholes, dewatering and dismantling of existing road, if any and its reconstruction complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) |
| 8 | Providing, lowering, cutting, jointing and testing of 300mm i/d RCC pipe Class - Np3 with HDPE lining as per IS 458 - 2003 with spigot and socketted joints manufactured with ISI marked Sulphate Resistance Cement as per ISI 12330 with rubber rings ISI marked,antitermite as required at site, into trenches, for all depths and laying out the same to correct alignment, gradients and levels including dressing and trimming and cutting of concrete beds and sides of trenches, if required, jointing with rubber rings in trenches and jointing with 1: 11/2 cement sand mortar and with end dowels filled with 1:1 1/2 cement sand mortar and finishing the joints at an angle of 45 degree with faces of spigot of socket joints cutting and finishing the cut surface alongwith construction of manholes, dewatering and dismantling of existing road, if any and its reconstruction complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) |
| 9 | Providing, lowering, cutting, jointing and testing of 500mm i/d RCC pipe Class - Np3 with HDPE lining as per IS 458 - 2003 with spigot and socketted joints manufactured with ISI marked Sulphate Resistance Cement as per ISI 12330 with rubber rings ISI marked,antitermite as required at site, into trenches, for all depths and laying out the same to correct alignment, gradients and levels including dressing and trimming and cutting of concrete beds and sides of trenches, if required, jointing with rubber rings in trenches and jointing with 1: 11/2 cement sand mortar and with end dowels filled with 1:1 1/2 cement sand mortar and finishing the joints at an angle of 45 degree with faces of spigot of socket joints cutting and finishing the cut surface alongwith construction of manholes, dewatering and dismantling of existing road, if any and its reconstruction complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) |
| 10 | Design and Construction of 3.75 to 5.00 Mtr wide CC Roads and pavements with embankment as required gradient with 150mm thick (1:3:6) with concrete base and 200mm thick M-25 Design Mix Concrete with Kerbs and channels, Supplying and installing of 8.00 Mtr. high LED solar street light at 30M c/c, Main gates, walkways, leveling etc. complete in all respect and all other work contingent thereto as per sizes and specification given in the DNIT at Existing STP Behrampur, Gurugram with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) |
| 11 | Design and construction of Gas Holder Dome with M.S Sheet as per design with electrical and mechanical items complete in all respect and all other work contingent thereto as per sizes and specification given in the DNIT complete in all respect along with Operation and Maintenance for 11 years (including 12 months defect liability period) after trail run period of 03 months. (O and M Cost will be considered as 20% of the quoted price for this item) |
