Tender For Repair To Boundary Wall, Gate,Fencing, Drains And Allied Works Of Zone B And Zone D Under Age B/R-Ii Of Ge (East).; 1 Dismantling fencing wire mesh, any type complete all as specified and as directed. 2 Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded in natural ground and making good disturbed area complete all as specified and as directed. 3 Dismantling galvanised 2 strand, steel barbed wire, concertina coil in fencing complete all as specified and as directed. 4 Excavation in post hole (or similar hole) each n exc 0.5 cum each and getting out, returning filling in and ramming earth or broken rubble mixed with earth around,in layers not exceeding 25 cm in soft/loose soil complete all as specified and as directed. 5 M&L for cement concrete type C2 1:3:6 (using 40 mm graded stone aggregates) as in foundation, filling and mass concrete complete all as specified and as directed. 6 S&F Mild steel work as in hand rails , half round or other section, balustersrunning bars, nosing to steps, wind ties, posts and struts in fencing incl cutting tops to shape as required, drilling holes , noching for wire , flat iron fillets for securing wiremesh etc. incl all necessary drilling, bolting or riveting etc & similar work conforming to Fe-290 Gde E-165 complete all as specified and directed. 7 S&F mild steel round bars 10mm dia cut to length, bent to shape required bent to shapehoking end required and fixed in fencing confirming to Fe 410-W (Gde E-250) or Fe 290 (Gde E-165) complete all as specified and as directed. 8 S&F Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, exc 5cm but n exc 10cm long complete all as specified and as directed. 9 Supply only chain link having MS galvanised wire and mesh of size 50mmx50mm complete all as specified and as directed. 10 Fixing only chain link fencing including line wire any mesh, size and tied to any type of standards, rails, straining bolts etc including provision of binding wire.complete all as specified and as directed. 11 S&F galvanised 2 strand, steel barbed wire 2.24mm, dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails straining bolts, including securing or tying at crossings with and provn of galvanised mild steel wire staples or steel pins etc complete as specified and as directedNote: (Each line wire to be measured) 12 All as above but serviceable barbered wire obtain from dismentling 13 S&F galvanised punched type concertina coil of loop dia 450 mm (dia of coil when unstretched) fixed to existing angle post strut and tying at three places ie two bottom & one at top with 3.15 mm dia galvanised mild steel wire complete as specified and as directed 14 Demolition of brick work or stone boulder masonary built in cement mortar including all quoins, arches, pillars etc. but excluding ashlar facing dressed stone work and precast concrete articles complete all as specified and as directed. 15 M&L for brick work with sub-class B bricks, straight or curved on plan exc 6.0 metre mean radius as wall built in cement & sand mortar 1:6, complete all as specified and as directed. 16 All as above but except brick 17 Taking down cement plaster on brick or stone walls, concrete surface etc. including raking out joints, hacking for key, scrubbing down with water, etc complete all as specified and as directed. 18 M&L for rendering 15 mm thick in cement and sand mortar 1:4 on fair faces ofbrick work or cement concrete surfaces including finishing the surface even and smooth without using extra cement, complete all as specified and as directed. 19 M&L for rendering 15 mmthick in cement and sand mortar 1:4 on surface other than fair face of brick work or cement concrete surfaces including finishing the surface even and smooth, complete all as specified and as directed. 20 M&L for preparation of new plastered surface of walls and applying two coats of cement base paint over and including a coat of primer complete all as specified and as directed. 21 M&L for preparation of old surface of walls and applying one coats of cement base paint of approved shadecomplete all as specified and asdirected. 22 Roughening / cleaning existing concrete surface by brushing with wire brushed for removing caked mud etc, sweeping with brooms and reomve all loose dirt etc 23 Demolition of cement concrete (unreinforced) in ground floors and pavings n.exc 15cm thickness (Below or above ground level) complete all as specified and as directed. 24 M&L 75mm thickcement concrete 1:4:8 type D2 (using 40 mm graded aggregate) as in sub floors, sub bases, floors and paving etc. complete all as specified and as directed. 25 Supply and laying 60mm thick factory made chamfered edge cement concrete interlocking paver block of M-35 grade confirming toIS 15658-2006 with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over minimum 50 mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand.complete all as specified and as directed. 26 M&L for machine factory made PCCblock (1:2:4) type B1 using 20 mm graded stone aggregate, as in kerb stone set in cement mortar (1:4), complete all as specified and directed. 27 M&L for glossy pattern Chequred Cement concrete coloured tiles with grey cement and pigments 30cm x 30cm x 25mm thick, machine pressed, set jointed and pointed in neat cement slurry in floors, laid over and including 20 mm thick screed bed in cement mortar 1:6 all as specified and as directed. 28 Demolition and breaking up drain pipe (salt glazed ware, AC or reinforced concrete) of any type and size, set in cement mortar, in foul position. 29 M&L 300mm bore reinforced concrete pipes, class NP2, laid and jointed complete with collars complete all as specified and directed. 30 Concrete bed to drain pipes including packing under and completely surrounding pipes with concrete after they are laid and tested in cement concrete type C-2, 1:3:6 (using 40mm graded aggregate) 300mm dia pipe 31 M&L for cleaningdrain garbage, debries waste/earth material n exc 200 mm thick and removing the waste material / debris etc. and removeing from site to outside MoD land complete all as directed. 32 M&L for PCC 1:3:6 type C 1 using 20mm graded ag as in copping/surface channelincl weathering , slitily rounded or champer angleand throughting , as directed. 33 M&L for forming fair finished drain or channel n exc 50Cm in girth in CM concrete complete all as directed 34 Dismantling asbestos cement/galvalume/fibre (corrugated or semi corrugated) sheets including ridges in roof coverings, complete all as specified and directed.. 35 S&F Fibre glass, 2.0 mm thick, reinforced translucent corrugated sheeting with two corrugation side lap fixed withcoach screw and washer in roof, wall etc. complete all as specified and as directed. 36 Dismantling wrought iron or mild steel work of any description not otherwise provided for, complete all as specified and as directed. 37 S&F rolled mild steel work or MS Tubular section as in doorgate of angle or other section complete, drilled or welding for fixing of steel sheeting or other covering door etc to be prepared for hanging or sliding with and including either hooks and ginges or steel hanging door fittings (exclusive steel sheeting or other covering running rails and gides) and hanging : also fastening and fixing complete all as specified and directed. 38 S&F plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, without any attachment conforming to Fe-410W Gde E-250 quality A, complete all as specified and directed. 39 M&L for preparation of new steel and iron surface of any description and applying 2 coats of syntheltic enamel paint over a coat of red oxide primer, complete all as specified and as directed. 40 Demoltion/dismentling of RCC cover slabs of drains and other similar work etc complete all as specified and directed 41 M&L for RCC cover slabs , in cement concrete (1:2:4) type B1 mix using 20 mm graded stone aggreted including necessary frame work complete all as specified and directed 42 M&L for MS TMT bars 10 mm dia and over, cut to length bent to shape required incl cranking bending ,spirally for hooping for column ,hooking ends and binding with and including MS wire annealed not less than 0.9mm dia, complete all as specified & directed. 43 M & L in repair for providing 75-80 mm thick pre-cast cement concrete 1:3:6 type C-0 using 12.5 mm graded stone aggregate as in louvers & jallies (measured solid) including all mouldings and including pre-cast frames set in cement mortar 1:6 complete all as specified and as directed. 44 M & L in repair for providingprecast concrete Posts 100x100mm size &75-100 cm height1:3:6 type C0 using 12.50 mm graded stone aggregateas in RCC jali postsetting in mortar1:6 complete all as directed
