Name of Work: Fencing of land area 3120 sqm in sy no.197/17 in connection with the 34th Edition of Lakshadweep School Games at Kiltan 2025
Sl. No.
Item Description
1
Surface dressing of the ground including removing vegetation and in-equalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift upto 1.5 m: All kinds of soil
2
Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5m in width or 10 Sq.m on plan), including dressing of sides and ramming of bottoms, for all lift, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m : All kind of soil
3
Providing and laying in position cement concreteof specified grade excluding the cost of centering and shuttering- All work up to plinth level: 1: 4:8 ( 1 cement: 4 Coase and (zone-III): 8 graded stone aggrigate 40mm nominal size derived from natural sources)
4
Supplying at site R.C.C. Standards post/ struts/rails/ pales of mix 1:1.5:3 (1 cement : 1.5 coarsesand : 3 graded stone aggregate 12.5 mm nominal size) with wooden plugs or 6 mm bar nibs wherever required as per direction of Engineer-in- charge (cost of earth works in excavation, concrete works in foundation to be paid separately).
5
Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 and for all lift.
6
Providing and fixing G.I. chain link fabric fencing of required width in mesh size 50x50 mm includingtrengthening with 2 mm dia wire or nuts, bolts and washers as required complete as per the direction of Engineer-incharge. Made of G.I. wire of dia 4 mm
7
Finishing walls with water proofing cement paint of required shade : New work (Two or more coats applied @ 3.84 kg/10 sqm)
8
Providing and fixing 1 mm thick M.S. sheet sliding-shutters, with frame and diagonal braces of 40x40x6 mm angle iron, 3 mm M.S. gusset plates at the junctions and corners, 25 mm dia pulley, 40x40x6 mm angle and T-iron guide at top and bottom respectively, including applying a priming coat of approved steed primer.
9
Finishing with Epoxy paint (two or more coats) at all locations prepared and applied as per anufacturer’specifications including appropriate priming coat, preparation of surface, etc. complete. On steel work
We takes all possible care for accurate & authentic tender information, however Users
are requested to refer Original source of Tender Notice / Tender Document published by
Tender Issuing Agency before taking any call regarding this tender.
