Fencing And Remaining Work Of Ram Leela Shed Pyt-Upper Meer, Block-Panchari Under(Bdc) Capex Budget For Year 2025-26. As Per Nit => Limited- 1 Provision for CIB(Painting andwritingalso) 2 Demolishing stone rubble masonry manually/by mechanical means including stacking of serviceable material and disposal of unserviceable materialwithin 50 meters lead as per direction of Engineer-in-charge: In cement mortar 3 Earth work in bulk excavation by Manual means over area (exceeding 30cm in depth 1.5m as well as 10m^2 on plan ) including disposal of excavated earth lead upto 50m and lift 4 Earth work in excavation by manual meansin trenches for foundations, drains, pipes, cables etc. (not exceeding 1.5 m in width) and for shafts, wells, cesspits and the like not exceeding 10 sqm on plan, including dressing of sides and ramming of bottoms lift upto 1.5 m, including getting out excavated earth and disposal of surplus excavated earth as directed, within a lead of 50 metres:All kinds of soil 5 Providing and lying in position cement concrete 1 cement:5fine sand:10 graded crushed stone aggregates 40mm size.excludingthe cost of centring and shuttering all work upto plinth Level,Including all lead and lifts. 6 Providing and laying in position cement concrete 1 cement:3 fine sand:6 graded crushed stone aggregates 20mm size excluding the cost of centring and shuttering- all works upto plinth level.with 20% Plum,Including all lead and lifts. 7 Cetring and shuttering including strutting, propping etc and removal of the formwork. Foundation 8 Brick work with common burnt clay (non-modular) bricks of class designation 7.5 in foundation,plinth andsuperstructure including curing in :Cement mortar 1:6 ( 1 cement : 6 coarse sand) ,Including all lead and lifts. 9 15mm thick cement plaster of 1 cement: 6 fine sand mix. ,Including all lead and lifts. 10 12 mm thick cement sand plaster in 1:6 mix,Including all lead and lifts. 11 6mm thick cement plaster of 1 cement: 3 fine sand mix.,Including all lead and lifts. 12 Cement concrete flooring 1:2:4 (1cement: 2 coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry and curing complete, but excluding the cost of nosing of steps etc. complete. 50 mm thick with 20mm nominal size stone aggregate. 13 Providing and fixing strips in joints of terrazzo/ cement concrete floors. Glass strips40 mm wide and 4 mm thick,Including all lead and lifts. 14 Providing and applying white cement based putty of specified thickness, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete. 1 mm thick 15 Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade on New work (two or more coats) over and including priming coat with water thinnable cement primer 16 Finishing walls with acrylic smooth exterior paint of required shade on New work (Two or more coats applied @ 1.67 liter/10sqm over and including priming coat of exterior primer applied @ 2.20kg/10sqm) 17 Providing and fixing 1mm thick M.S. sheet door with frame of 40x40x6mm angle iron and 3mm M.S. gusset plates at the junctions and corners, all necessary fittings complete, including applying a priming coat of approved steel primer. Using M.S. angles 40x40x6mm for diagonal bracesIncluding all lead and lifts. 18 Painting with synthetic enamel paint of approved brand and manufacture to give an even shade. Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture 19 Supplying and fixing rolling shutters of approved make, made of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted on specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufactured from high tensile steel wire of adequate strength confirming to IS:4454 part-1 and M.S. top cover of required thickness for rolling shutters. 80x1.25 mm M.S. laths with 1.25 mm thick top cover 20 Providing and fixing ball bearing for rolling shutters. 21 Structural steel work in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.Riveted and bolted 22 Providing and fixing G.I. chain link fabric fencing of required width in mesh size 50x50 mm including strengthening with 2 mm dia wire or nuts, bolts and washers as required complete as per the direction of Engineer-in charge.Made of G.I. wire of dia 4 mm 23 Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works. 24 Add for electric ceiling fans of apprved brand like havells ,usha etc all complete @ 2500 per number. 25 Supplying and fixing LED T5 tube light of 20W.Make Havells,Syska or eqvt (LMR) 26 Wiring for light point/ fan point/ exhaust fan point/ call bell point with 1.5 sq.mm FRLS PVC insulated copper conductor single core cable in surface / recessed medium class PVC conduit, with modular switch, modular plate,suitable GI box and etc. as required. 27 Chequerred precast cement concrete tiles 22mm thick in footpath and courtyard, jointed with neat cement slurry mixed with pigment to match the shade of the tiles, including rubbing, cleaning and curing complete, on 20 mm thick bed of cement mortar 1:4 ( 1 cement : 4 coarse sand) .Ordinary cement without any pigment
