|
| 1 | OP-Amp Trainer kit to realize its versatile linear & nonlinear applications like: inverting, non-inverting, adder, subtract or, integrator, differentiator, function generator etc. |
| 2 | Function / Signal Generator |
| 3 | Diode, Zener Diode Characteristics Trainer Kit (To plot forward and reverse biased characteristics of diode and zener diode) |
| 4 | BJT & FET Trainer Kit to study characteristics, applications as switch |
| 5 | MOSFET Trainer Kit to study characteristics, applications as switch |
| 6 | Wheatstone Bridge Trainer kit for Measurement of medium valued resistance |
| 7 | Kelvin Double Bridge Trainer kit for Measurement of medium valued resistance |
| 8 | RC phase shift / Wien Bridge Oscillator Trainer Kit |
| 9 | DC Regulated Variable power Supply |
| 10 | Panel Voltmeter |
| 11 | Panel Voltmeter |
| 12 | Panel Ammeter |
| 13 | Milli Ammeter |
| 14 | Micro Ammeter |
| 15 | Megger |
| 16 | 4.5 Digit Digital Multimeter (DMM) |
| 17 | Experimental Kit for S.C & O.C test of single phase Transformer |
| 18 | Trainer kit for measurement of power & PF by Wattmeter for a load like fluorescent lamp |
| 19 | Trainer kit for measurement of current and voltage by low range ammeter and voltmeter respectively with shunt and multiplier |
| 20 | Study set up for speed control of D.C. shunt motor by-(a) Armature voltage control, (b) Field flux control. |
| 21 | Trainer kit for: (a) Wein Bridge, (b) Maxwell’ Bridge (c) Schering Bridge, to measure unknown parameter |
| 22 | Trainer Kit for verification of Thevenin’s Theorem and others |
| 23 | Trainer Kit for verification of Norton’s Theorem and others |
| 24 | Trainer Kit for verification of Maximum Power Transfer Theorem |
| 25 | R-L-CSeries and parallel resonance trainer kit |
| 26 | Trainer kit for study of High pass, Low Pass, Band Pass, Band rejectionfilter and design of those. |
| 27 | CRO 30 MHZ |
| 28 | Digital Logic Gates Trainer Kit |
| 29 | Digital Logic IC Trainer Kit for Gate, FF, Counter, Registor, ADC/DAC, Timer andwith Seven segment display operation |
| 30 | Trainer Kit to study V-I characteristics of SCR, TRIAC, DIAC, UJT |
| 31 | SCR Single phase half wave, full wave controlled rectifier Trainer Kit |
| 32 | Study set up for speed control of DC motor using controlled rectifier and chopper |
| 33 | Study set up for speed control of single phase Induction motor using TRIAC |
| 34 | Advanced Pressure measurement trainer |
| 35 | Dead Weight Tester calibration set up for C type Bourdon Gauge, Pressure switch |
| 36 | Trainer Kit for characteristic curve drawing, calibration of Strain Gauge load cell |
| 37 | Trainer Kit for characteristic curve drawing, calibration of Hall Effect Sensor |
| 38 | Trainer Kit for characteristic curve drawing, calibration of Piezoelectric Sensor |
| 39 | Trainer Kit for characteristic curve drawing of LVDT |
| 40 | Trainer kit for speed measurement experiment using stroboscope and tachometers |
| 41 | Trainer Kit for speed measurement using Tachometer [contact & non contact type] |
| 42 | Temperature measurement study set up [RTD, T/C, Thermistor, AD590] |
| 43 | Temperature measurement study set up [IC based] |
| 44 | Setup for measurement and digital display of flowusing Orifice,Rotameter, D/P Transmitter. |
| 45 | Level measurement study set up [Conductive gauge] |
| 46 | Setup for measurement anddigital display of Level using Conductive gauge, Capacitive gauge, Gauge glass, Float, Displacer |
| 47 | Level control setup with D/P transmitter, controller and control valve |
| 48 | Flow controlsetup with D/P transmitter, orifice, controller and control valve |
| 49 | Flow control setup using mass flow meter, controller and control valve |
| 50 | PLC Trainer [complete set up] for demonstration of: 1. Basic functionality of PLC 2. Experiment on simple arithmatic and logic operation programming using PLC 3. Demonstration of sensor module 4. Demonstration of at least 4 number of following dynamic modules: a) Tank Filling Controlb) Temperature Control Modulec) Bottle Filler Control Moduled) Star Delta Starter Modulee) Relay/ Load Modulef) Water level controlg) Traffic Controlh) Belt Conveyor |
| 51 | Microprocessor Trainer Kit - 8086 |
| 52 | Microprocessor Trainer Kit - 8085 with 8255, ADC/DAC interfacing facility |
| 53 | Microcontroller Trainer Kit - 8051 with interfacing |
| 54 | Air Permeability Apparatus (Blaine type) |
| 55 | Determination of compressive strength of OPC/PPC and concrete |
| 56 | Compression testing machine 2000 Kn |
| 57 | Sieve Shaker, Motorised |
| 58 | Compressive strength of hardened concrete by Rebound Hammer Test |
| 59 | Concrete Mixer Machine |
| 60 | Apparatus for Aggregate Impact Test |
| 61 | Aggregate Crushing Value Apparatus (150 mm) IS :9376-1979 |
| 62 | Flakiness and elongation index apparatus |
| 63 | Penetration test of bitumen |
| 64 | Flash and Fire Point test of bitumen |
| 65 | Ductility test of Bitumen |
| 66 | Hydraulic Bench with 10 Experiment |
| 67 | Hot Air oven |
| 68 | Direct shear apparatus |
| 69 | Universal permeability test apparatus ( both for constant and falling head permeability test) |
| 70 | Auto level |
| 71 | Vernier Transit Theodolite & Accessories |
| 72 | TOTAL STATION |
| 73 | Hand held GPS: |
| 74 | pH: Digital pH meter with temperature probe |
| 75 | Turbidity Meter |
| 76 | Determine suspended, dissolved solids and total solids of given sample of water/sewage |
| 77 | Digital Balance, Capacity : 30Kg |
| 78 | Digital Balance, Capacity :200 gm |
| 79 | DO meter |
| 80 | Determine Arsenic concentration (semi-quantitative) in given water sample |
| 81 | Standard Proctor Test Apparatus |
| 82 | Determine the optimum dose of coagulant in a given raw water sample by jar test |
| 83 | Reynolds’s apparatus |
| 84 | Bernoulli’s theorem apparatus |
| 85 | Centrifugal pump test rig |
| 86 | Pitot tube set up |
| 87 | Froth floatation cell |
| 88 | Thermal Conductivity of Metal Rod Apparatus |
| 89 | Linear Expansion Apparatus |
| 90 | Isothermal Batch Reactor |
| 91 | Laboratory Muffle Furnace |
| 92 | Laboratory Turbidity Meter |
| 93 | Digit Analytical Laboratory Balance |
| 94 | Aluminium Heating Mantle, For Laboratory |
| 95 | Positive displacement pump test rig |
