Work Of Fabrication And Erection Of Enclosed Depository For Medical Store At Designated Location In The Hospital Premises - Providing, detailing, composite fabricating members like Trusses, N-girders, girders, bracings, supports, purlins, runners, and similar structural steel members fabricated using M.S. hollow tubular steel sections (circular & rectangular pipes), of TATA Structura Make or equivalent conforming to IS 1239 part 1 and 2 and of grade Fe 250 as per specifications and approved fabrication drawings (which are to be prepared by Contractor and got approved from Engineer), including transportion of the same to site, erection of structural steel members for all heights & at all levels, provision of necessary erection bolts, fixing bolts, nuts, washers, cleats, stiffeners, gussets, base plate, and all necessary operations like preheating as per specifications, straightening, bending, cutting, drilling, grinding, machining if specified, welding, grinding, removing the welding burr and preparing surface for painting with wire brush cleaning and applying two coats of epoxy red oxide zinc phosphate primer of 30 microns each and two coats of Epoxy Corrosion Resistant Enamel paint of 30 microns after fabrication including touching up with spray painting after erection etc complete as directed by Engineer In Charge. 2 Providing, detailing, fabricating and fixing at desired location using M.S. chequered Plates of any thickness and of grade Fe 250 as per specifications and approved fabrication drawings (which are to be prepared by Contractor and got approved from Engineer), including transporation of the same to site, erection at all heights and levels, provision of necessary erection bolts, fixing bolts, nuts, washers, cleats, stiffeners, and all necessary operations like preheating as per specifications, straightening, bending, cutting, drilling, grinding, machining if specified, welding, grinding and removing the welding burr and preparing surface for painting with wire brush cleaning and applying two coats of epoxy red oxide zinc phosphate primer of 30 microns each and two coats of Epoxy Corrosion Resistant Enamel paint of 30 microns after fabrication including touching up with spray painting after erection etc complete as directed by Engineer In Charge. 3 0.63 mm thick GI corrugated sheet with zinc coating not less than 275gm/m² 4 geotextile mat (300 GSM) 5 Filling in plinth, floors, trenches, pits with approved excavated Filling in plinth, floors, trenches, pits with approved contractors murum in layers not exceeding 200mm including breaking of clods, watering, consolidating each layer in filled up area by rolling and compacting with roller/ plate compactor as required to achieve not less than 97% modified proctor density conforming to relevant IS etc. complete as directed by Engineer In charge. The rate includes necessary soil testing charges at laboratory & field as per relevant I.S. codes, royalty, octroi and other taxes if any. (Note: Borrow areas selected by CONTRACTOR shall be got approved from Engineer In Charge, before executing the work) 1) The rate includes the royalty and other taxes if any. 6 Nominal Mix of 1:2:4 (1 cement OPC: 2 coarse sand : 4graded stone aggregate 20 mm nominal size) 7 63 Amp. 415V DP Switchfuse unit with CRCA sheet steel powder coated enclosure with rewirable fuses 8 63A DP MCB 9 32A SP MCB 10 25A SP MCB 11 1st category Cu armoured cables FRLS outer sheathed- 2C x 6 Sq.mm 12 1st category Cu armoured cables FRLS outer sheathed- 2C x 2.5 Sq.mm 13 1st category Cu armoured cables FRLS outer sheathed-2C x 1.5 Sq.mm 14 Light /Fan / Ex. fan Points with Modular switches & FRLSH wires
