|
| 1 | Supply and delivery of wet type 50LPMx25m Headx2.00 HP mm Open Well submersible pumpset with motor and confirming to IS 8034/89 and IS 9283/79 with ISI marking |
| 2 | Single phase panel board (2.0 HP) withD.O.Las per standard specification. The pump set should be supplied with 5Mflat submersible copper cable. |
| 3 | Supply and delivery of 2.50 sq mmWater Proof cable |
| 4 | Supply and delivery of following pipe pipe line materials(with ISI mark) etc complete. 32 mm GI pipe with B class |
| 5 | 32mm dia G.I Elbow |
| 6 | 32mm G.I Capling |
| 7 | 32mm G.M Non Retrun valve |
| 8 | 32mm dia G.Ibend with coupler |
| 9 | 32mm dia G.I union |
| 10 | 20mm GI pipe with coupler medum class |
| 11 | 20mmG.I Coupling |
| 12 | 20mm CICP Tap |
| 13 | 32mm HDPE Pipe |
| 14 | 1000liter H.D.P.E water tank with ISI mark (1270/1996) |
| 15 | 50mm HDPE Pipe |
| 16 | Labourcharge for the erection of submersible pump set in bore well including fixing and jointsubmersible cable with proper clamps upto staterto require depth and also fixing of raiser pipesto the required depth valve erection clamp pressure gauges upto the exterior wall of pump room and erection of panel board consisting of TPICNswitches starter Voltmeter, Ammeter, three pilot(indicating) lamps capacitor single phase preventor, water level guard and laying and jointing the cable and twin earthing as per IS rules etc complete. |
| 17 | Supply and Run of 2x4 sq.mm(84/0.3) PVC insulated Sc unsheathed Cu.Conductor of 1100V grade in 25mm dia G.I pipe (Bclass) suitable bend at both ends with necessary angle iron up right and end supports for mains. |
| 18 | Supply and Run of 2x4 sq.mm(84/0.3) PVC insulated Sc unsheathed Cu.Conductor of 1100Von 7/20 Gibearer wire for service connection mains. |
| 19 | Supply and fixing of following electrical materials 16Amps MTPC Switch |
| 20 | 16 Amps fuse carrier |
| 21 | Supply and fixing m.s single phase panel board metersheet box including cost and convayance of materials and labour charge etc complete. |
| 22 | S&F M.Sbore clamp |
| 23 | Earth work excavation for foundation and depositing on bank with in the initial lead of 10m and a lift of 2m in hard stiff clay, stiff block cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders etc.,as per SS 20 A. TNDSS NO: 23 & 24 VI (S2) VI,VII 9,10with standard specifications. |
| 24 | Plain Cement Concrete 1:4:8 (one part of cement, four part of Crushed Stone Sand (M- Sand) and eight part of coarse aggregates) using 40mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges and all incidential charges such as water providing etc., complete as per standard specification |
| 25 | Plain Cement Concrete 1:1.5:3 (One part of Cement, one and half part of Crushed Sand (M- Sand), three coarse aggregates) using 20mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges etc., complete as per standard specification |
| 26 | Brick work in cement motor 1:5 mix(one cement and five sand) using 2nd class country brick of size 9\"x41/2\"x3\" includingcuring finishing and cost and conveyance of materials and labour chargeetc completeas per std specification. |
| 27 | Plastering Cemend mortor 1:5mix (one cement and five sand) 12mm thick includingcost and conveyanace of materials and labour charge etc completed as per std specification. |
| 28 | Cement paint two coats of approved colour and qualityincluding preparation of plastering wall surface , finishing neatly and all other labour ,materials costetc complete as per std specification. |
| 29 | Lowering of HDPE Hose including all acost of labour for laying etc as perd standard specification |
| 30 | Refilling the excavated Earth includig all cost of labour for filling etc as per standard Specifcation |
