Expansion/ Development And Up-Gradation Of Jakhani Park( Balance Portion) At Udhampur, District Udhampur (Jandk) Refer To Boq- 1 Providing, Laying and Commissioning of Sprinkler Irrigation System With Allied Works in Park 2 Providing and laying of HDPE pipe ISI marked in dug out trenches complete with necessary fittings .The job includes digging out trenches for laying of HDPE pipe line including refilling and neatly levelling of trenches. 40 mm OD X 6 Kg/cm 3 Providing and laying of HDPE pipe ISI marked in dug out trenches complete with necessary fittings .The job includes digging out trenches for laying of HDPE pipe line including refilling and neatly levelling of trenches. 50 mm OD X 6 Kg/cm 4 Providing and laying of HDPE pipe ISI marked in dug out trenches complete with necessary fittings .The job includes digging out trenches for laying of HDPE pipe line including refilling and neatly levelling of trenches. 63 mm OD X 6 Kg/cm 5 Providing and laying of HDPE pipe ISI marked in dug out trenches complete with necessary fittings .The job includes digging out trenches for laying of HDPE pipe line including refilling and neatly levelling of trenches. 75 mm OD X 6 Kg/cm 6 Providing and fitting of PVC Control Valve 63mm 7 Providing and fitting of PVC Control Valve 75mm 8 Providing and fitting of Control Valve Nipple 63mm 9 Providing and fitting of 10dia toughened PVC control valve box with top lid. 10 Providing and fitting of 6dia toughened PVC control valve box with top lid. 11 Providing and fitting of 7.5 HP, 3-Phase monoblock pump set with of Kirlosker or KSB make. The job includes material, carriage and labour charges. 12 Providing andfitting of Pop-up Sprinkler along with swing joint 3/4with complete fittings from HDPE pipe ( Adj. Arc with radius 10 Mits. and above) 13 Providing and fitting of Uni Spray complete from HDPE pipe (Adj. Arc) 14 Providing and fitting of MS ornamental shed 4- x 2-0 with omamental roof of height 3-0. The ornamental shed is to be fabricated out of 18 gauge MS sheet with front door in two equal halves having proper bolting system. Angle irons extended from four corners of the shed are to be grouted in cement concrete block. Painting one coat of steel primer and two coats of synthetic enamel paint inside and outside is also included in the job. Complete including all material required, labour and carriage charges. 15 Providing and, fitting of starter panel fitted with 32Amps contactor, Over-load relay, single phase preventer, MCB TPN, Amp. Meter, Volt Meter, selector switch, push button etc. Angle irons extended from corners of the panel are to be grouted in cement concrete block. Painting of synthetic enamel paint inside and outside is also included in the job. Complete including all material required, labour and carriage charges. 16 Providing and fitting of screen filter 25 cum / Hr. 17 Providing and fixing G.I. pipes complete with G.I. fittings excluding trenching and refilling etc. (external work) 65 mm dia. nominal bore Medium 18 Providing and fitting of 65mm dia Brass foot valve. 19 Providing and fixing G.I. pipes complete with G.I. fittings and clamps, including cutting and making good the walls etc.: Internal work-Exposed on wall 15 mm dia. nominal bore 20 Providing and fixing G.I. pipes complete with G.I. fittings and clamps, including cutting and making good the walls etc.:Internal work-Exposed on wall 25 mm dia. nominal bore 21 Providing and fixing gun metal gate valve with C.I. wheel of approved quality (screwed end) 25 mm nominal bore 22 Providing and fixing gun metal gate valve with C.I. wheel of approved quality (screwed end) 50 mm nominal bore 23 Providing and fixing gun metal gate valve with C.I. wheel of approved quality (screwed end) 25 mm nominal bore 24 Providing and fitting of 3/4x1/2 bush. 25 Providing and laying of 16mm sq 4 - core armoured aluminum cable as service line. The job includes fitting and carriage charges. 26 Earthing with copper earth plate 600 mm X 600 mm X 3 mm thick including accessories, and providing masonry enclosure of bricks with CC bed and cover plate having locking arrangement and watering 40mm dia pipe of 2.7 metre long etc. with charcoal/ coke-90Kg and sait-50Kg. Complete job with excavation and refilling of earthing pit. 27 Providing and fixing 25 mm X 5 mm G.I. strip in 40 mm dia G.I.pipe from earth electrode including connection with G.I. nut, bolt, spring, washer excavation and re-filling etc. as required. 28 Supplying and laying 25 mm X S mm G.I strip at minimum one ft below ground as strip earth electrode, including connection/ terminating with G.I. nut, bolt, washer etc. as required. (Jointing shall be done by overlapping and with 2 sets of G.I. nut bolt & washer spaced at 50mm). The job includes digging andrefilling of trenches. 29 Providing and fixing G.I. Union in G.I. pipe including cutting and threading the pipe and making long screws etc. complete (new work) 30 15 mm nominal bore 31 15 mm Tee 32 15 mm Elbow 33 1/2x2 Nipple 34 1/2x3 Nipple 35 1/2x9 Nipple 36 3/4x2 Nipple 37 25 mm Union 38 25 mm Elbow 39 25 mm x 50 mm Nipple 40 1x6 Nipple 41 1x12 Nipple 42 50mm Tee 43 50mm Union 44 2x12 Nipple 45 2x6 Nipple 46 2.5 Elbow 47 50 mm socket 48 50 mm plug 49 Reducer Socket 50 mm x 60mm 50 Supplying and fixing of Ornamental benches with all complete job including all leads, liftsand carriages. 51 Construction of 1 Nos. Ornamental Gazebo/View point in cement concrete 1:2:4 in platform and M-20 mix in pillars and roof to the shape of bamboo finish including the cost of pillars, Pillars and roof to be RCC modelled as tree trunks, sloping RCC shuttering, strutting propping etc. including painting of approved brand and shade indicating cement concrete or bamboo type painting with all costs including carriage of material by mechanical transport from source to site of work, head load of upto 200mwith all lifts, leads etc. (Complete Job). 52 Supplying of dustbins = 10 No @ 3000/No . LMR (Subject to actual) 53 Earth work in excavation by manual means in trenches for foundations, drains, pipes, cables etc. (not exceeding 1.5 m in width) and for shafts, wells, cesspits and the like not exceeding 10 sqm on plan, including dressing of sides and ramming of bottoms lift upto 1.5 m, including getting out excavated earth and disposal of surplus excavated earth as directed: 1 meter from cutting edge All kinds of soil : 54 Demolishing cement concrete manually/by mechanical means including disposal of material within 50 meters lead as per direction of Engineer-incharge: 1:3:6 or richer mix (i/c equivalent design mix) 55 Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with: 1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size) 56 Providing and laying in position specified grade of reinforced cement concrete including curing but excluding the cost of centering, shuttering, finishing and reinforcement. All works upto plinth level1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size) 57 Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level Thermo-Mechanically Treated bars of grade Fe-500D or more. 58 Centering and shuttering including strutting, propping etc. and removal of form work for:Foundations, footings, bases for columns 59 Brick work with common burnt clay (non-modular) bricks of class designation 7.5 in foundation and plinth including curing in : Cement mortar 1:4 ( 1 cement : 4 coarse sand) 60 Providing and fixing Ist quality ceramic glazed wall tiles conforming to IS : 15622 (thickness to be specified by the manufacturer), of approved make, in all colours, shades except burgundy, bottle green, black of any size as approved by Engineer- in-Charge, in skirting, risers of steps and dados over 12 mm thick bed of cement mortar 1:3 ( 1 cement : 3 coarse sand) and jointing with grey cement slurry @ 3.3 kg per sqm, including pointing in white cement mixed with pigment of matching shade complete. 61 Structural steel work in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. Welded 62 Painting with synthetic enamel paint of approved brand and manufacture to give an even shade. Two or more coats on new work
