Tender For Supplying, Installation, Commissioning And Demonstration Of Different Machineries / Equipment With Proper Calibration Certificate, As Per Schedule, For The Laboratory Under The Office Of The Quality Control Division Ii, At Siliguri, West B, siliguri-West Bengal

Supplying, Installation, Commissioning And Demonstration Of Different Machineries / Equipment With Proper Calibration Certificate, As Per Schedule, For The Laboratory Under The Office Of The Quality Control Division Ii, At Siliguri, West Bengal As-1 Supplying, installation, commissioning and demonstration of Compression Testing Machine.Capacity: 2000 kN, Standard: IS 14858:2000, Ram diameter: 250 mm & Ram travel 60 mm, Least count: 0.1 kN, Lower plate diameter: min. 300 mm, Upper plate diameter: min. 300 mm Vertical clearance: min. 350 mm, Horizontal clearance: min. 400 mm, Specimen size to be tested: i. Cube: 70.6 mm, 150 mm ii. Cylindrical mould: 100 - 400 mm iii. Paver block: 150 x 250 mm Electricity supply: AC Single phase 220V 50 Hz or 3 - phase 440V, Controlled mode: Digital, Accurate load rate within +- 2% from 0.1 kN/s to 15 kN/s. This accuracy should be demonstrated positively at time of commissioning of the machine.Accuracy: Error of load not greater than +- 1%. This accuracy should be demonstrated positively at time of commissioning of the machine.Machine Platens: Two bearing blocks (with V. H. not less than 550) one of which is spherically seated block that will bear on the upper surface of the Specimen and the other a solid block on which the Specimen shall rest. Motor capacity: 2 HP minimum. Peak load, real date and time is displayed, Machine software should be available to be supplied / reinstalled if required for at least up to 10 years. Original hydraulic oil, oil pipe, rubber gasket and other parts of machine should be available to be supplied even after warranty period, for at least up to 10 years at same cost. 2 Supplying, installation & demonstration of brand new Digital thermometer Range: -20 to 500 deg. C & Least Count of 0.1 deg. C 3 Supplying of brand new good quality Steel tape of 5 m length. 4 Supplying of brand new good quality Steel tape of 3 m length. 5 Supplying of brand new leather hand gloves set (for Air oven use) 6 Supplying of brand new rubber hand gloves set (for hot water use) 7 Supplying of brand new Digital Vernier Calliper of 30 cm length measuring capacity of reputable brand along with Calibration Certificate. 8 Supplying of stainless steel scale of 30 cm length.

Refer document

INR 5000.0 /-

Refer document

FileName	File Description	File Size
Click here to download tender document	Tender Documents	0 KB
Click here to download tender document	Tender Documents-1	0 KB
Click here to download tender document	Tender Documents-1	0 KB
Click here to download tender document	Tender Documents-1	0 KB