|
| 1 | A/mtc. of transformers of capacity from 25 KVA to 63 KVA, R.D Fuse unit and GO switches with all material including replacement of defective parts, loading, unloading, transportation etc. complete in all respect and maintaining the supply properly in working condition for 365 days 24 hours rates are each set per month.(Rate without GST) |
| 2 | Repair and Maintenance charges of LED street light / Flood lights points from 225 watt to 400 watt installed on 9 mtr./11 mtr. long PCC /STP poles/High Mast, ON/OFF operation and fault finding of electrical circuits, cost of material charges i.e. Driver/SPD/PCB/ PVC tape roll/screw etc. arranging of T and P i.e. Hydraulic ladder/alum. Ladder, safety belt, safety shoes etc.) on various sectors / master roads complete in all respect upto the entire satisfaction of engineer in charge of work. (Rate without GST) |
| 3 | Repair and Maintenance charges of LED street light / Flood lights points from 90 watt to 200 watt installed on 9 mtr./11 mtr. long PCC /STP poles/High Mast, ON/OFF operation and fault finding of electrical circuits, cost of material charges i.e. Driver/SPD/PCB/ PVC tape roll/screw etc. arranging of T and P i.e. Hydraulic ladder/alum. Ladder, safety belt, safety shoes etc.) on various sectors / master roads complete in all respect up to the entire satisfaction of engineer in charge of work. (Rate without GST) |
| 4 | Supply and erection of 11 KV Disc insulator polymer type with fitting on PCC pole of approved make of State Electricity Nigam requirement to complete in all respect to confirming to ISS 731/1971 latest amendment thereto. (Rate without GST) |
| 5 | Supply and Erection of 11 KV G.O. Switch vertical mounted with heavy duty 6 Nos. post insulators suitable, for copper male and female contacts fixed on GI angle frame with G.I. Nut and Bolts including G.I. pipe and operating handle complete in all respect. (Rate without GST) |
| 6 | Supply and erection of 11 KV pin insulator polymeric type 10 KN with GI pin as per specification and approved make by DHBVN. (Rate without GST) |
| 7 | Supply and erection of 63 Amps connection plate 4 pole for incoming and outgoing cable fitted with connector fixed on Bakelite sheet complete with nut and bolts complete in all respect up to entire satisfaction of the Engineer-in-Charge of the work. (Rate without GST) |
| 8 | Supply and erection of Fuse unit of L.T. side suitable for 25 kva to 200 KVA transformer complete with wooden board, aluminum strips, MS clamps and nut and bolts including all petty material required up-to the entire satisfaction of Engineer-in-Charge. (Rate without GST) |
| 9 | Supply and erection of junction cover for octagonal poles made out of fiber sheet of size 1.0 sq feet complete with cutting and binding of covers with poles using transparent cello tape complete in all respect. (Rate without GST) |
| 10 | Supply and erection of PCC pole 11 mtr long as per IS: 1678-1960 specifications, 140mm x 200mm at top and 140mm x 400mm at bottom with working load of 400Kg buried 2.20M in ground or as per DHBVNL specification. (Rate without GST) |
| 11 | Supply and Erection of shackle insulator brown glazed of size 90 mm x 75 mm suitable for 415 /240 Volt confirming to IS 1545/1977 with latest amendment thereof complete in all respect up to the entire satisfaction of Engineer-In-Charge. (Rate without GST) |
| 12 | Supply and erection of 30mm2 PVC insulated ACSR conductor conforming to IS 398 (Part-II) 1976/1996, IS 4826-1976 IS 1521-1972 and IS 1778-1980 with latest amendments and erection of the same with accessories including stringing and sagging of conductor as well as jointing and binding with insulator at supports in all respect up to the entire satisfaction of Engineer-in-Charge. (Rate without GST) |
| 13 | Supply and erection of 50sqmm ACSR conductor conforming to IS 398 (Part-II) 1976/1996, IS 4826-1976 IS 1521-1972 and IS 1778-1980 with latest amendments and erection of the same with accessories including stringing and sagging of conductoras well as jointing and binding with insulator at supports in all respect up to the entire satisfaction of Engineer-in-Charge. (Rate without GST) |
| 14 | Supply and erection LT AB cable of size 25 Sqmm x 4 core with 25 Sqmm single core messenger conductor complete with necessary connection complete in all respect up to the entire satisfaction of Engineer-in-charge of the work. (Rate without GST) |
| 15 | Supply and erection of 2.5 sqmm x 3 core aluminum flexible cable PVC insulated and sheathed core round/flat cable 1100 volts each core having single solid aluminium conductor as per IS: 694, complete in all respect up to entire satisfaction of the Engineer-in-Charge of the work. (Rate without GST)Make:- Havells/Polycab/Grandlay or make approved by DHBVN. |
| 16 | Trenchless horizontal boring 1 mtr. Below Ground level suitable for the HDPE pipe of size 75mm PE63/PN4 including the cost of HDPE pipe and laying of pipe complete in all respect up to the Entire satisfaction of Engineer-In-Charge. (Rate without GST). |
| 17 | Operation and maintenance charges without material of HT/LT lines, cables on per kilometer per month basis complete in all respect to maintain the supply available for 24 hours by engaging properly skilled electrical staff to complete the job complete in all respect.(Rate without GST) |
| 18 | [13.27]Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. |
| 19 | [13.32]Providing and fixing bolts including nuts and washers complete. |
| 20 | [23.22.1.5]MCCB ,DISTRIBUTION BOARDS, MCB`s, RCCB`s, CHANGE OVER etc. 1.5. Supply and erection of Modular case circuit breaker single pole/4 pole on existing wall/pedestal/Panel including bounding to earth and making necessary connections required to complete the job in all respect up to the entire satisfaction of the Engineer-in-charge of the work. TRIPLE POLE MCCB 200 to 250 Amp, 25 KA |
| 21 | [23.22.5.1]MCCB ,DISTRIBUTION BOARDS, MCB`s, RCCB`s, CHANGE OVER etc. 5.1. Supply and erection of miniature circuit Breaker240/415 V in the existing distribution board including making necessary connections:- 6 amp. to 32 amp Single Pole |
| 22 | [24.13.24]LT CABLES (Aluminium Conductor, Armoured and Unarmoured) PROVIDING& ERECTION/ LAYING OF PVC/ XLPE INSULATED UNDERGROUND ALUMINIUM CONDUCTOR UNDERGROUND CABLE LOOSE IN EXISTING PIPE OR TRENCHES COMPLETE IN ALL RESPECT WITH NECESSARY CONNECTION UPTO THE ENTIRE SATISFACTION OF ENGINEER IN CHARGE OF THE WORK 24.16 Sq mm 4 core (Arm.) |
| 23 | [24.13.32]LT CABLES (Aluminium Conductor, Armoured and Unarmoured) PROVIDING& ERECTION/ LAYING OF PVC/ XLPE INSULATED UNDERGROUND ALUMINIUM CONDUCTOR UNDERGROUND CABLE LOOSE IN EXISTING PIPE OR TRENCHES COMPLETE IN ALL RESPECT WITH NECESSARY CONNECTION UPTO THE ENTIRE SATISFACTION OF ENGINEER IN CHARGE OF THE WORK 32.25 Sq mm 4 core (Arm.) |
| 24 | [24.15.2]HT CABLES (Aluminium Conductor, Armoured and Unarmoured) Providing and erection/ laying of XLPE (E) 11 KV HT Aluminium Conductor Armoured Cable ISI Mark Laid in 1 per meter below ground level with sand and bricks with all labour and material including digging and refilling of trench as required to complete the job in all respect upto the entire satisfaction of the Engineer-In-Charge of the Works 2.50 Sq mm 3 core |
| 25 | [24.15.7]HT CABLES (Aluminium Conductor, Armoured and Unarmoured) Providing and erection/ laying of XLPE (E) 11 KV HT Aluminium Conductor Armoured Cable ISI Mark Laid in 1 per meter below ground level with sand and bricks with all labour and material including digging and refilling of trench as required to complete the job in all respect upto the entire satisfaction of the Engineer-In-Charge of the Works 7.185 Sq mm 3 core |
| 26 | [24.3.3.1]HT CABLE 3.1. Supplying and making indoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for following size of 3 core, XLPE aluminium conductor cable of 11 KV grade as required :70 to 120 sqmm |
| 27 | [24.3.3.2]HT CABLE 3.2. Supplying and making indoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for following size of 3 core, XLPE aluminium conductor cable of 11 KV grade as required :150 to 185 sqmm |
| 28 | [24.3.4.1]HT CABLE 4.1. Supplying and making outdoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for following size of 3 core, XLPE aluminium conductor cable of 11 KV grade as required :70 to 120 sqmm |
| 29 | [24.3.4.2]HT CABLE 4.2. Supplying and making outdoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for following size of 3 core, XLPE aluminium conductor cable of 11 KV grade as required : 150 to 185 sqmm |
| 30 | [24.3.5.1]HT CABLE 5.1. Supplying and making straight through cable jointing with heat shrinkable jointing kit complete with all accessories including ferrules suitable for following size of 3 core, XLPE aluminium conductor cable of 11 KV grade as required :70 to 95 sqmm |
| 31 | [24.3.6.2]HT CABLE 6.2. Supplying and making indoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for following size of 3 core, XLPE aluminium conductor cable of 33 KV grade as required :120 to 185 sqmm |
