Tender For M/O Various Colonies Under Nazul A/C-Ii Dwarka Zone.Sh:- R/M/O Of Ei & Fans At 104 Mig Staff Qtrs., Sec-23, Dwarka.; 1 Providing labour for R/M/O of electrical installations i/c light point/ceiling fan point /Exhaust fan point/ bell point/ power point/ SDB etc. as per terms & conditions attached by deploying following staff:-a) Wireman Gr-I- 01 No. in general shift as and when required.b) Khallasi-01 No. in general shift as and when required. 2 Supply and replacementof the following electricalitems etc as reqd. suitable for operation of single phase 220-240V AC supply :- a)SP 5/6 Amp, one way switch, piano type ISI marked 3 b) SP 15/16 Amp, one way switch, piano type ISI marked 4 c) 3 Pin 5/6 Amp, socket outlet, piano type ISI marked 5 d)6 pin 15/16 & 5/6 amps, socket outlet, piano type ISI marked 6 e)Bell push, piano type 7 f) PVC Batten/ Angle holder 8 g) Call bell / buzzer, Single phase 9 h) 6A to 32 A rating SP MCB, “C” curve 10 KA breaking capacity 10 i) 6A to 32A rating DPMCB, “C” curve 10 KA breaking capacity 11 j) Stepped type fan regulator (1 module) piano type 12 k) 3.15 MFD capacitor for Fans 13 Supplying and drawing following sizes of ISI marked,FRLS PVC insulated copper conductor ,single core cable in the exixting surface /recessed steel /PVC conduit as required. a) 1.5 sq mm 14 b) 4 sq mm 15 Supply, Installation, Testing and Commissioning of 1200 mm sweep,BEE 5 star rated, ceiling fan with Brush Less Direct Current (BLDC) Motor, class of insulation: B, 3 nos. blades, 30 cm long down rod, 2 nos. canopies, shackle kit, safety rope, copper winding, Power Factor not less than 0.9, Service Value (CM/M/W) minimum 6.00, Air delivery minimum 210 Cum/Min, 350 RPM (tolerance as per IS : 374-2019), THD less than 10%, remote or electronic regulator unit for speed control and all remaining accessories including safety pin, nut bolts, washers, temperature rise=75 degree C (max.), insulation resistance more than 2 mega ohm, suitable for 230 V, 50 Hz, single phase AC Supply, earthing etc. complete as required. 16 Supplying and Replacement of 300mm, sweep size heavy duty exhaust fan with complete in all respect with louvers suitable for single phase 230 volt, 50 Hz AC supply i/c connection, testing etc. complete as reqd. 17 Supplying, installation, Testing & Commissioning of LED surface mounted Batten light of following body materialand construction as per IS : 10322 withdriver (Replaceable)as per the requirement with Driver efficiency >85% ,Operating voltage AC140-270 Volt,freq 50/60 hz, Operating temp range -15 deg to 40 deg centigrade, internal surge protection of 2.5 KV with Short & Open circuit protection ,THD < 10% , P. F.≥0.95, IP20,CRI>80, Flicker free, (flickershould be below 5 %), life time (LED,Driver & electrical circuitary), ofminimum 50000BurningHourswith,70%ofinitial Lumenmaintained tilllife ends, CCT3000°K/ 4000°K / 5700°K/6000°K/6500°K(AsperANSIBin), SDCM(Standard Deviation Color Matching) <3, Maximum power consumption should not more than the specified rating and Fixture shall be of relevant BISstandard andtrade markcertificate(T.C.).Manufactures Word Mark/ Name Engraved/ Embossing/ Screen printing on housing. completeinallrespecti/cconnectionswith1.5sqmmFRLS,PVCinsulatedcopper conductor single core cable and earthing etc. as required with Minimum 5 year OEM warranty.System lumen efficacy≥105 <120lm/Watt output . LM79 & LM80 Test reportfromNABLlab foralltestingrequiredforLED fixtures as per BISshall be submitted. Shape size and CCT shall be as approved by Engineer-in-Charge as per requirement. (Thermalmanagement:heatsinkofaluminumhousing such that LED junction temperature shall not rise above 90°C). Powdercoated die cast/ Extrudedaluminium Body (Thickness≥ 1.20 mm).18-22 Watt
