Tender For External/Internal Painting/Improvement To Cantt Fund Buildings, B/Wall Shops Etc. In Cantt Area.; 1 M/L PC Plaster in cement Mortar 1:4,12 mm thick finishedeven and smooth (without using extra cement) on walls all as sp. 2 Ditto, but PC Plaster in cements Mortar 1:4, 12 mm thick finished even and smooth including water proof compound all as sp. 3 M/L Putty two coats grinding plaster surface with sand paper, putty filling again grinding to even smooth surface and one coat of primer followed by two coats of premium Acrylic emulsion such as Asian/nerolac/Berger or equivalent to smooth interior finish all as sp.(on ceiling/walls) 4 M/L Putty two coats grinding plaster surface with sand paper, putty filling again grinding to even smooth surface and one coat of primer followed by super fine roller coat finish of spectrum or equivalent to be applied with foam Roller, Finally coated with two coat premium exterior emulsion/Apex or equivalent all as sp. 5 M/L Putty two coats grinding plaster surface with sand paper, putty filling again grinding to even smooth surface and one coat of Exterior Water Based Primer followed by textured finish with Trowel natural stone finish from spectrum or equivalent acrylic plaster with grains-Application of one coat of natural stone finish upto 1.5 to 2mm thick with trowel followed by transparent silicon to make surface water repellent all as sp. 6 Heritage Granule finish/Rustic Finish- Application of one coat of quartz primer of spectrum or equivalent and application of granules of desired shade with trowel and top coat of transparent silicon to make surface water repellent all as sp. 7 Metallic Finish-Application of one coat of primer followed designer roller finish of desired design followed by two coats of luxury interior/exterior emulsion and finally one coat of metallic emulsion Nerolac/Asian or equivalent all as sp. 8 M/LPutty two coatsfollowed by primer one coat followed by painting two coats with exterior emulsion + graphics painting under Swachh Bharat Abhiyan, AKAM etc. 9 Ditto but the with scaffold upto 20 height from road level. 10 M/L grinding wooden Surface with sand paper 60 no. Filling with wood filler then grinding with 80 no. Sand paper, then again filling wood Filler then grindng with send paper 100 nos. Then wood Filler with stainer and grinding wiht 150 nos. Sand paper filing, then malamine coat, grinding wiht sand paper no. 320. one coat of lacker then final coat of malamine on designer door exc.1.25 sqm and not exc. 2 sqm. 11 Ditto, But on Plain door exc. 1.25 sqm and not exc. 2 sqm. 12 Ditto, But chowkhats single rebated or double rebated all as specified. 13 Removing of old paint, propering surface with one coat of putty grinding to smooth surface and applying two coat of Apex paint or equivalent with super fine roller coat finish of specialized or equivalent on old surface. 14 M/L special quality unistone weatherdale tiles or equivalent 200 mmx200mm having stone textured any coloron walls set and jointed in neat cement slurry and pointed in white or colored cement to match all as specified.(as per sample available in CB office) 15 Dismantling Brickwork built in C. Motar all as specified in MES SSR 2020. 16 Removing of malba/dismantle material to a distance upto 05KM. 17 Providing and laying autoclaved aerated cement blocks masonry with 150 mm/230 mm/300 mm thick AAC Blocks in supersturcture above plinth level upto floor V level with RCC band at sill level and lintel level with approved block laying polymer modified adhesive mortar all complete as per direction of Engineer-in-charge. (The payment of RCC band and reinforcement shall be made for separately.) 18 Use & waste of formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of Foundation and Plinth Beams and similar work; vertical or to batter fair finished surface all as sp. in MES SSR 2020. 19 Use & waste of formwork to soffits of suspended slabs such as roof slabs, floor slabs, Columns, beams, landings and similar work, not exceeding 200mm thick (Horizontal or sloping)fair finished surface all as sp. in MES SSR 2020. 20 M/L RCC work 1:1½ :3 for foundation including raft footing foundation beams plinths beams bases for columns basement slabs under reamed piles and mass concrete and the like all as specified inMES SSR, 2020. Note : Only OPC cement will be used for all RCC works. 21 M/L RCC work 1:1½:3 for slabs supported on walls, columns , roofs, landing, balconies, canopies deck slabs and in shelves and the like all as specified in MES SSR, 2020. Note : Only OPC cement will be used for all RCC works. 22 S/F Mild steel bars 10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hoping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips all specified in MES SSR, 2020. 23 S/F framed work such as grills, grating, cattle traps etc., with ends of bars shouldered and/ or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters, trusses purlins, MS bar fencing, walk wais; railings; frame work of water tanks and similar work confirming to Fe 410-0 or Fe 310-0 all as specified in MES SSR, 2020. 24 Supply and fixing of pre painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50 mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws all as specified in MES SSR 2020. 25 M/Lanti skid ceramic tiles 16 x16 in floors etc. set and jointed in neat cement slurry and pointed in white or colored cement to match all as specified in MES SSR, 2020 ( colored tiles)including screed 15-20 mm thick. 26 M/L glazed ceramic tiles 300 mm x 200mm or 300 mm x 300 mm x 7 mm thick etc. on walls set and jointed in neat cement slurry and pointed in white or colored cement to match all as specified in MES SSR,2020 ( colored tiles). 27 M/L for one light point 5 Amp controlled by one switch with cables 1.5 Sqmm in size copper conductor PVC sheathed single core in PVC Conduit all as specified in MES SSR 2020. 28 M/L for moudular switch 1 way6 Amp 1 module complete all as specified in MES SSR 2020. 29 Supply and fixing of steel rolling shutters, with out ball bearing, as specifed including top cover, an-choring rod, hasp and staple and one shop coat of primer; erected in position as indicated, complete: Pull or manual type complete all as specified in MES SSR 2020. 30 S/F Aluminium Frame (color coated) Made of Aluminium rectangular section of 1.3 mm Thickness of size 2 ½”x 1 ½” Complete including fixing of5 mm thick Glass Black/Brown for widows, doors & partly fixed partly openable frame,including hinges door closer, handle etc. complete all as specified in MES SSR 2020. 31 Removing mortor from and cleaing bricks in C:M then execpt bricks, bricks work in cement mortor1:4 complete all as sp. in MES SSR 2020.
