|
| 1 | M.S. framed work: S & F for framed work of trussed, purlins, joists etc. or others made of mild steel angle, tee etc. of approved sections including cutting, drilling, welding etc. in any height as required all complete. |
| 2 | Translucent Sheeting : M&L for roof covering with minimum 2 mm thickfiber glass reinforced translucent corrugated sheeting with two crrugation side lap, fixed with coach screws and washers in roofs, walls etc. corrugation of the sheet should match the corrogation of existing galvalume sheet all complete. |
| 3 | Fixing only Pre-colour coated steel sheet: Fixing only pre-painted galvalume aluminium zinc coating GI based corrugated steel sheetin roof covering / clading to wall, ridges etc. fixed with self tapping screws all complete |
| 4 | Wood painting : M & L for applying two coats of synthetic enamel paint finished glossy of1st quality; make- Asian / Berger / ICIor any substantially equivalent makeover new surfaces after necessary preparation and priming of wood surfaces of any description over 10 cm width or girth all complete |
| 5 | Steel painting : M & L for applying two coats of synthetic enamel paintfinished glossy of1st quality; make- Asian / Berger / ICIor any substantially equivalent make over a coat of priming with red lead primerafter necessary preparation of new decorated steel surfaces of any description over 10 cm width or girth all complete |
| 6 | Dismantling Boardings: Labour only for dismantling boarding fixed with screws, any description, fixed in any position |
| 7 | Dismantling steel work : Labour only for dismantling wrought iron or mild steel work of any description (such as old damaged Turbo Ventilator etc.) and in any position and removing the same to store or all complete |
| 8 | Dismantling sheet : Labour only for dismantling plain or corrugated steel sheeting / galvalume sheeting of any gauge, thickness,any heightincluding Nainital or similar pattern roof coverings in roof covering and including removing the same to store or all complete |
| 9 | Wind Driven Turbo Ventilator :Supply and Fixing of Wind Driven Turbo Ventilator in SS430 neck dia 24\"\"(600mm),turbine dia 31\"\"(790mm), height 16\"\"(400mm), top plate 0.40mm SS430, base ring 0.50mm SS 430, 42 nos.of vanes of MOC 0.50 mm SS430, centre shaft, centre support pipe, bearing housing, inner & outer arms of SS430, bearing (66.11.24) double jet set , net weight 4.4kgs, suction capacity 2700 CMF of stainless steel make JINDAL, TATA, SAIL or substantially equivalent make along with polycarbonate base plate of2mm thick, 1080mmwidth/1690mm length,50microns UV coating, weight 4kgs, acidic & chemical environment resistant etc. all complete. (Proof of SS 430 to be submitted before execution of work). |
