Tender For Outside And Inside Fully Renovation Including Painting, Repairing, Roof Treatment And Outside Drain Cover Casting, And Miscellaneous S And P Work Of U.G. Hostel At V.L. College Campus. C.U.xc- 1 Stripping off worn out plaster and raking out oints of walls, celings etc. upto any height and in any floor including removing of rubbish within lead of 75m as directed. Outside Measurement= (8.30m Ht.including parapet cover peripheri and dado). 2 Stripping off worn out plaster and raking out oints of walls, celings etc. upto any height and in any floor including removing of rubbish within lead of 75m as directed.inside Measurement= 3 Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints or roughening of concrete surface, including throating, nosing and drip course, scaffolding/stagng where necessary i) With 1:6 cement mortar (b)15mm thick plaster Sq.M[ quantity is the same as that of item 01 4 Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints or roughening of concrete surface, including throating, nosing and drip course, scaffolding/stagng where necessary i) With 1:6 cement mortar (b)20 mm thick plaster 5 Drain coverR.C. shelves (1:1.5:3) either precast or cast in situ with stone chips and necessary reinforcement upto 1% (0.8% main and 0.2% distribution bars), shuttering etc. and 10 mm. thick cement plaster (1:4) including neat cementfinishing and cutting chase fitting and fixing in position, mending good damages as necessary complete. In ground floor(a) 50 mm. Thick panelsI. SAIL/ TATA/RINL Sq. M.measurement= 6 Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty on thesurface, including priming one coat. a) On timber or plastered surface : With super gloss (hi-gloss) - Two coats (with any shade except white) Measurement--- 7 Applying Acrylic Emulsion Paint of approved make and brand on wallsand ceiling including sand papering in intermediate coats including putty(to be done under specific instruction of Superintending Engineer) :(Two coats)Luxury Quality 8 Protective and Decorative Acrylic exterior emulsion paint of approved quality, as per manufacturers specification and as per direction of Engineer in charge to be applied over acrylic primer as required. The rate includes cost of material, labour, scaffolding and all incidental charges but excluding the cost of primer. In Ground floor (Two Coat) a) Normal Acrylic Emulsion. Measurement and quantity = same as the gross area of item no -01(without percentage calculation 9 Scraping of moss, blisters etc.thoroughly from exterior surface of walls necessitating the use of scraper, wire brush etc.(Payment against thisitem will be made only when this has been done on the specific directionof the Engineer-in-charge) Measurement and quantity = same as the gross area of item no -01(without percentage calculation) 10 Priming one coat on timber or plastered surface with synthetic oilbound primer of approved quality including smoothening surfaces by sand papering etc.Qty is the same as I-07 11 Applying Exterior grade Acrylic primer of approved quality and brandon plastered or cencrete surface old or new surface to receive decorative textured (matt finish) or smooth finish acrylic exterioremulsion paint including scraping and preparing the surface throughly,complete as per manufacturers specification and as per direction of theEIC. a) One CoatMeasurement and quantity = same as the gross area of item no -01(without percentage calculation) 12 125 mm. thick brick work with 1st class bricks in cement mortar (1:4) inground floor.Drain -------- 13 Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20mm nominal size) excluding shuttering and reinforcement if any, in ground flooras per relevant IS codes.(i) Pakur Variety 14 R.C. weather board (1:1.5:3) with stone chips and necessary reinforcement upto 1% (including main and distribution bars), shuttering and 10 mm. thick cement plaster (1:4) including all moulding, drip course etc. complete inground floor.50 mm thick using steel ofI. SAIL/ TATA/RINL 15 Applying 2 coats of bonding agent with synthetic multi functional rubberemulsion having adhesive and water proofing properties by mixing with water in proportion (1 bonding agent4 water : 6 cement) as per Manufacturersspecification [Cement to be supplied by the Department]on the right wall of ground floor stair block 16 Supplying & laying as per IRC-SP:063-2004 paver unit of any shade of approved quality as per relevant IS code, laid inpattern as directed in pavement, footpath, driveway (paver block only), etc including necessary underlay complete in all respect with all labour and material. [Border concrete if necessary to be paid separately].Note: Sub-grade CBR should not be less than 5.a) 25 mm thick Tiles as per IS: 1237-2012 for footpath,ramp,staircase of public building(over 25 mm thick (Avg) Cement mortar (1:3) & Cement Slurry @ 4.4 kg/Sq.m at back side of Block. Cement for Mortar & Slurry to be suppliedby Department).Coloured Decorative RAMP 17 (b) 50 mm thick interlocking designer concrete paver block M- 30 grade for non-traffic zone,buiding premises, garden, parks, domestic drive as per IS: 15658- 2006 (over 20-30 mm medium sand bed on 200mm thk bound gnaular /granular base course including cost of sand for sand bed but excluding cost of base course & subgrade preparation.)(i) Coloured Decorative. 18 Earth work in filling in compound, tank, low land, ditches etc. with good earth, in layers not exceeding 150 mm. including breaking clods and consolidating the same by ramming and dressing complete. (Payment will be made on profile measurement before and after the work) With earth obtained by fresh excavation upto 1800 mm. depth (including the cost of excavation from land arranged by the Deptt. within a lead of 100 m.) 19 Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement,if any, in ground floor as per relevant IS codes.a) Pakur VarietyROAD Side walls plinth protection 20 Supplying, fitting & fixing 1st quality Ceramic tiles in walls and floors to match with the existing work & 4 nos. of key stones (10mm) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc.Wall---------- With Sand Cement Mortar (1:3) 15 mm thick & 2 mm thick cement slurry at back side of tiles using cement @ 2.91 Kg/Sq.m & joint filling using white cement slurry @ 0.20kg/Sq.m.Area of each tile upto 0.09 Sq.mColoured decorative 21 Taking out old damaged tarfelt from the roof, parapet etc. preparing the roof surfaces by removing all spoils, blisters, moss etc. from the working site and disposal of the same beyond the compound and cleaning the site in all respect as per direction of Engineer-in-Charge. 22 Supplying & laying 3mm thick pre-fabricated plastomeric water proofing membrane conforming to EN 12311-1 & ASTMD 5147, manufactured with atactic poly propylene (APP) modified premium grade asphalt , specially reinforced with non-woven polyester core with polyester reinforcement @160 gms per sqm & both faces covered with thermo-fusible polyethylene film /MineraL on top face over a coat of primer @ 0.40 lit/sqm of manufacturers specification on smooth,clean dry surface prepared wherever required.Lap joint shall be provided of 75 mm in longitudinal & 100 mm in transverse direction and fused using LPG/ Propane torch employing extra care ensuring full bondage, complete removal of entrapped air and sealing edges into grooves in appropriate manner as per direction of Engineer -in-charge all complete including materials,labour and applicable taxes. (Payment shall be made on the basis of finished surface area.).Membrane Property: Softening Point > 150 deg C, Cold Flexibility < -6 deg C, Tensile Strength, N/cm : 600 (longitudinal), 450 (transverse), Tearing Strength, N: 300 (longitudinal), 200 (transverse)calculation= 7.80m x 1/2 x (23.95+ 17.70 + 14.00 + 7.80 + 19.07 + 12.35) = 369.99 sqm QTY same as Item16 23 Preparation of bed with 1:1.5: 3 proportion concrete (10mm stonechips ) for making proper slopeand pot holes repairing average thickness25mm assumed area is 60% of total area of APP application . So, area = 369.99 sqm x 0.60 = 221.99 sqm 24 Supplying, fitting and fixing bib cock or stop cock PTMT (Polytetra Bib Cock / Stop Cock ( Prayag or equivalent) 15 mm 25 Supplying, fitting and fixing PVC pipes of approved make of Schedule 80 (medium duty) conforming to ASTMD - 1785 and threaded to match with GI Pipes as per IS : 1239 (Part - I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. Payment for painting willbe made seperately)(a) For Exposed WorkPVC Pipes 15 mm ------- 3.5m x 4 nos x 2 floor = 28mtr 26 Supplying, fitting and fixing PVC pipes of approved make of Schedule 80 (medium duty) conforming to ASTMD - 1785 and threaded to match with GI Pipes as per IS : 1239 (Part - I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. Payment for painting willbe made seperately)(a) For Exposed WorkPVC Pipes 20 mm ------- 3m x 4 nos x 2 floor = 24 mtr 27 Cleaning glazed tiles with acid 28 Add: GST @ 18 %
