Tender For Annual Maintenance Of Work At I.A. Sarojni Nagar Distt. Lucknow - Surface dressing of the ground including removing vegetation and in- equalities not exceeding 15 cm deep and disposal of rubbish, lead upto 50 m and lift upto 1.5 m. 2 Clearing jungle including uprooting of rank vegetation, grass, brush wood, trees and saplings of girth up to 30 cm measured at a height of 1 m above ground level and removal of rubbish up to a distance of 50 m outside the periphery of the area cleared 3 Tractor with trolly (includong CP and OH) 1350 ( Add 15% CP and OH) 4 Supply Of Skilled Labour (Add 15% CP & OH) 5 Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the All kinds of soil. 6 Road Marking with Hot Applied Thermoplastic Compound with Reflectorising Glass Beads on Bituminous Surface, Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads 250 gms per som area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:25-2015 The finished surface to be level, uniform and free from streaks and holes. 7 Providing, laying, spreading and compacting graded stone aggregate (Table 400-13) to wet mix macadam specificationincluding premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller of minimum static weight of 80 to 100kNto achieve the desired density, complete as per Clause 406 8 Brick work with common burnt clay F.P.S. (non modular) bricks of class class 150in foundation and plinth in: Cement mortar 1:6 (1: cement :: 6: coarse sand) 9 Providing wheeled wxcavator cum loader including POL & driver ( INCLUDING 15% CP & OH) 10 Finishing walls with Premium Acrylic Smooth exterior paint with Silicone additives of required shade: New work (Two or more coats applied 1.43 Itr/10 sqm over and Including priming coal of exterior primer applied @ 2.20 kg/ 10 sgm) (apex Ultima, weather coat All guard) aslan, berger 11 Dewatering works (1 pump) Hire charges of pump set for 4000 litres/hr ( 800 + 10% CP + 6% OH) (800*1.1*1.06=928RS/DAY = 928// = 116 RS PER/HOUR 12 Tractor trolly water tanker with including driver & POL,4wheel. (Add (15% CP & OH ) 13 Providing and layingdense bituminous macadam with 100-120 TPH batch type HMP using crushed aggregates ofGrading - 2 (Table 500-10), premixed with bituminous binder (VG-30) @ 4.5 per centby weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause No. 505 B complete in all respects. 14 12mm Cement Plaster Of Mix : 1:4 (1 cement : 4 fine sand) 15 Providing and laying damp-proof course 40mm thick with cement concrete 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources: 4 graded stone aggregate 12.5mm nominal size. 16 Lettering with black japan paint of approved brand and manufacture 17 Reflective Raised Pavement Markers (Cat Eye/ Road Stud) Supply and luding of raised pavement marker with Made of Plastic body of RPM Road Stud shall be moulded from ASA (Acrylic Styrene Acryloninite) or HIPS (High-imoad Polystyrene) Butadien Styrene (ABS) or Any other sulable material approved by the Engineer. The Marker shall support a load of 13,635 kg lasted in accordance with ASTM D4280, The Reflective panels shall consist of number of lenses contatning single or dual prismatic cubes capable of providing total internal reflection of the light entring the lens face. Linses shall be mouled of methyl methacrylate conforming to ASTM D788 of equivalent. The slop or retro-reffecting surface shall preferably be 35+/-5 degree to base and the area of sach retro-reflecting surface shall not be less than 13:00 sq.crm. the marker height shall not be less than 10 mm and shall not exceed 20 mm & Width shall not exceed 130 mm. The base of the marker shall be flat within 1.3 mm all road studs shall be legibly marked with the name, trade or other means of identification of the manufacture, spory installations, excess adhesive around the edge of the marker, excess adhesive on the pavement and adhesiva on the exposed surfaces of the markers shas be Immediately removed. The contractor shall submit a two year warranty for satisfactory fleid performanca including stipulated retro-reflectance of the reflecting panel, to the Engineer. In addition, a two year warranty for satisfactory infield performanca of the finished road marker shall also be given by the contractor who carries out the work of foxing of reflective road markers. In case the markers are displaced, damaged, get worn out or lose their reffectivity compared to stipulated standards, the contractor would be required to replace all such markers within 15 days of the intimation from the Engineer, at his own cost. The rate shall include as malerials, labour, T&P, transportation, installation and incidentals all complete as per direction of the Engineer-in-Charge 18 Chequeired precast cement concrete tiles 22 mm thick in footpath & courtyard, jointed with neat cement slurry mixed with pigment to match the shade of tiles, including rubbing and cleaning etc. complete, on 20 mm thick bed of cement mortar 1:4 (1 cement: 4 coarse sand).Light shade pigment using white cement 19 Painting or vanishing on iron works in small areas or new wood work with one coat of ready mixed priming paint & TWO COAT of approved superior quality ready mixed paint of clear synthetic varnish including supply of all materials, labour and T & P elc. required for proper completion of work. Paint to be used should confirm to the I.S.I. No. 103 1950FOR EVERY COAT AFTER 1ST COAT = 35/- 20 Dismantling reinforced cement concrete or reinforced brick work including stacking of dismantled materials as directed by Engineer-In-Charge within a distance of 60 meters (200 feet). 21 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level 1:2:4 (1 cement: 2 coarse sand (zone-III) derived from natural sources: aggregate 20 mm nominal size derived from natural sources) 22 R.C.C. Standards post/struts/rails/ pales of mix 1:1.5:3 (1 cement: 1.5 coarsesand: 3 graded stone aggregate 12.5 mm nominal size) with wooden plugs or 6mm bar nibs wherever required as per direction of Engineer-in-charge (cost of earth works in excavation, concrete works in foundation to be paid separately). 23 Fencing with R.C.C. post placed at required distance, embedded in cement concrete blocks, every 15th post, last but one end post and corner post shall be strutted on both sides and end post one side only, provided with horizontal lines and two diagonals of barbed wire weighing 9.38 kg per 100 metres (minimum), between the two posts fitted and fixed with G.I. staples on wooden plugs or G.I. binding wire tied to 6 mm bar nibs fixed while casting the post (cost of R.C.C. posts, struts, earth work and concrete to be paid for separately) :- Payment to be made per metre cost of total length of barbed wire used. 24 Supplying and stacking sludge at site including royalty and carriage upto 5 km lead complete (sludge measured in stacks will be reduced by 8% forpayment). 25 Supplying and stacking at site dump manure from approved source, including carriage upto 5 km lead complete (manure measured in stacks will be reduced by 8% for payment) Screened through sieve of I.S. designation 4.75 mm 26 Mixing earth and sludge or manure in the required proportion specified ordirected by the Officer-in-charge 27 Spreading of sludge, dump manure and/or good earth in required thickness as per direction of officer-in-charge (cost of sludge, dump manure and/ or good earth to be paid separately). 28 Digging holes in ordinary soil and refilling the same with the excavated earth mixed with manure or sludge in the ratio of 2 : 1 by volume ( 2 parts of stacked volume of earth after reduction by 20 % 1 part of stacked volume of manure after reduction by 8 % ) flooding with water , dressing including removal of rubbish and surplus earth , if any , with all leads and lifts ( cost of manure , sludge or extra good earth if needed to be paid for separately 29 Grassing with selection No. 1 Doob grass including watering and maintenance of the lawn for 30 days or more till the grass forms a thick lawn, free from weeds and fit for mowing including supplying good earth, if needed (the grass and good earth shall be paid for separately). With grass Turf 30 Preparation of beds for hedging and shrubbery by excavating 60 cm deepand trenching the excavated base to a further depth of 30 cm, refilling theexcavated earth after breaking clods and mixing with sludge or manure inthe ratio of 8:1 (8 parts of stacked volume of earth after reduction by 20%:one part of stacked volume of sludge or manure after reduction by 8%),flooding with water, filling with earth if necessary, watering and finally finedressing, leveling etc. including stacking and disposal of materials declaredunserviceable and surplus earth by spreading and leveling as directed,within a lead of 50 m, lift up to 1.5 m complete (cost of sludge, manure orextra earth to be paid for separately) 31 Supply & Planting of Shrubs, Plants height 2-2.5 feet as required by engineer in charge 16 X 8 Polythene bags or earthen pot fully foliage ad well branched free from disease 32 Plantation of Trees, Shrubs, and Hedge at site i/c watering and removal ofunserveiceable material’s as per direction of officer in charge (excludingcast of plant & water) Hedge Plant 33 Cutting of Hedge/Edge including removing of cut material, cleaning, hoeingof hedge/edge bed watering, manureing and applying insecticides andfungicides etc. as per direction of officer in charge.
