|
| 1 | Demolition of cement concrete (unreinforced) as in ground floor and paving of any description and in any position not otherwise described for, complete all as specified and directed. |
| 2 | M&L rubber moulded chequered cement concrete tiles 30cmx30cmx25mm thick with grey cementandpigments over 20mm thick screed bed or bedding layer in cement mortor (1:6) over 75 mm thick PCC (1:4:8) type D2 (using 40mm graded crushed stone aggregate),set, jointed and pointed in neat cement slurry, complete all as specified and directed |
| 3 | M&L for60mm thick, rubber mouldedmachine pressed precast concrete interlocking paverblock of any shape and size confirming to IS-15658-2006, M-35 with grey cement and pigment over 50mm thick sand cusining over 75mm thick PCC (1:4:8) type D2(Using 40mm graded crushed stoneaggregate), complete all as specified and directed. |
| 4 | Demolition of brick work, built in cement mortor including all quions, arches, pillars etc but excluding ashlars facings, dressed stonework and precast concrere articles,complete all as specified and directed |
| 5 | Taking down cement plaster of any description on brick work or stone walls etc. including racking out joints, hacking for key, scrubbing down with water etc., complete all as specified and directed. |
| 6 | M&L for brick work with sub class ‘B’ bricks, old size, straight or curved on plan to any radius in half brick thick walls, built in CM 1:6, complete all as specified and directed. |
| 7 | M&L for 15mm thick rendering in CM 1:6 onfair faces of brick work or concrete surface, finished even and smooth without using extra cement, complete all as specified and directed. |
| 8 | M&L for preparation of newly plastered wall surfaces and applying two coats of cement base paint over a coat of alkali restistant primer, complete all as specified and directed |
| 9 | Dismantling timber scantling (Framed work) 40 sqcm and over in section in any positions including demolioton of embedded PCC of Posts & Struts,complete all as specified and directed. |
| 10 | M&L softwood 2nd class clean sawn 40mmx12mm laths (fixed straight or diagonal) in two way trellis work with75mm spacesin the clear, including75mmx50mm fillet (notchedto take ends of laths) all round and fixed including dismantling of old Jafri(Trelis), complete all as specified and directed |
| 11 | M&L for preparation of new or preiously untreated wood surfaces of any description over 10cm width or girth and applying two coats of synthetic enamel paint over a coat of pink primer, complete all as specified and directed |
| 12 | M&Lfor PCC 1:2:4, Type B2 ( using 40mm graded crushed stone aggregate) as in foundation and mass concrte, complete all as specified and directed. |
| 13 | M&Lfor second class clean sawn soft wood timber framed and fixed in scantling, complete all as specified and directed. |
| 14 | S&F in repair wooden jallies as per pattern at site at vertical spacing of 75mm centre to centre including top, middle and bottom battens of second class clean sawnsoft wood fillets having cross sectional area exc 15 sqcm but n.exc 25 sqcm, complete all as specified and directed. |
| 15 | S&F in repair 2mm thickfibre glass reinforced translucent corrugated/Plainsheeting with two corrugation side lap fixed with\"L\" type or \"J\" typeor cranked hook and washer in wall cladding/gate/roofing , complete all as specified and directed. |
| 16 | Dismantling wrought iron or mild steel work of any description not otherwise provided for, complete all as specified and directed. |
| 17 | S&F mild steel section of angle, tee, flats and plates for posts and struts in fencing including cutting drilling, notching, riveting and or welding as directed and fixing with screws, boltsetc and confirming to Fe-290 Gde-E-165,complete all as specified and directed |
| 18 | S&F Framed work such as MS grills, gratings etc with ends of bars soulderedand/or revited or forged into spike, framed guard bars, barrel iron doors, laddrs, framed balustrs, walk ways, railings, framed work of water tank and similar work conforming to Fe-290, Gde E-165, complete all as specified and directed |
| 19 | Preparation of new or previously untreated steelsurfaces of any description over 10cm width or girth and applyoing two coats of synthetic enamel paint over a coat of red oxide, complete all as specifed and directed. |
| 20 | Preparation of old untreated steelsurfaces of any description over 10cm width or girth and applyoing one coat of synthetic enamel paint, complete all as specifed and directed. |
| 21 | M&L for applying two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50gms/litre and UV esistance as per IS-15489-2004, Alkali & fungak resistance, duret resistance exterior oaint of required sgade (Company Depot Tinted) with silicon additivs @1.43 litre/10Sqm over and including priming coat if exterior primer applied @ 0.90 litre/10sqm over new surfaces,conmplete all as specified and directed |
| 22 | Dismantling plain or corrugated sheet of any gauge and thickness of roof covering etc, complete all as specified and directed. |
| 23 | S&F 0.63mm thick galvanised, corrugated mild steel sheeting with two corrugations side lap, fixed with \"L\" or \"J\" type or cranked hook, bolts and washers in lieu of screws as in roof covering/wall cladding/gate etc. with grade of zinc coating 275, complete all as specified and directed. |
| 24 | S&F 0.63mm thick plain, galvanised, mild steel sheeting as in ridges, hips, valley gutters, drip and straight flashings (length and girth as fixed) fixed with \"L\" or \"J\" type or cranked hook, bolts and washers in lieu of screws with grade of zinc coating 275, complete all as specified and directed |
| 25 | S&F Pre-painted galvalumealuminium zinc coating GI based corrugated steel sheet 0.50mm thick of an colour having tensile strength 550 Mpa as in roof covering/clading to wall/gate etcfixed with self tapping screws, complete all as specireid and directed. |
| 26 | M&L for providing and fixing stainless steel (Grade 304) railing made of hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (where ever required) and fitting the same with necessary stainless steel nuts and bolts complete, including fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc., of required size, on the top of floor or the side of waist slab with suitable arrangement complete including dismantling of old railingall as specified and as directed. |
| 27 | M&L for Endura coloured tiles 300mmx300mmx10mm thick confirming to IS, laid in floors etc, set & jointed in neat cementmixed with pigment to match the colour of tiles over 20mm thick screed bed in cement mortar (1:4) including demolition /dismantling of old tiles, complete all as specified and directed. |
| 28 | Dismantling of chain link fencing wire mesh any type, complete all as specified and as directed |
| 29 | Supply only chain link MSgalvanisedfencing, any size or type, complete all as specified and directed |
| 30 | Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire, complete all as specified and directed |
| 31 | S&F MS screw bolts of 11 to 15mmdia(machine made) with hexagonal or squareheads at one end and screwed both ends, each screwd end to be fitted with washers and oen hexagonal or square exc 5cm but n.exc 10cm long,complete all as specified and directed. |
| 32 | S&F mild steel section of angle, tee, flats and plates for posts and struts in fencing including cutting drilling, notching, riveting and or welding as directed and fixing with screws, boltsetc and confirming to Fe-290 Gde-E-165, complete all as specified and directed. |
| 33 | Dismantling of stone/boulder of retaining wallmasonry, built in cement mortor, complete all as specified and directed. |
| 34 | M&L for Walling of random rubble, uncoursed, well bonded, bedderd and solidly hearted, built in cement mortor 1:4 except stone,complete all as specified and directed. |
| 35 | M&L for PCC 1:2:4, type B1 (using 20mmgraded crushed stone aggregate) as in coping on top face of wall including necessary form work, complete all as specified and directed. |
| 36 | M&L for 110mm dia PVC(SWR)pipes single socketed in any length with rubber rings joints fixed inwalls, complete all as specified and directed. |
| 37 | M&L forraised pointing to random or polygonal rubble, uncoursed or brought to courses in CM (1:3) including taking down, racking out joints, complete all as specified and directed |
| 38 | S&F double shutters with frame (glass & wire shutters) sound proofing UPVC window with 10mm thick sound proofing toughened glass and numbers including sound proofing beads, handles and glazing clips, joints cleats, rubber gaskets, shutter, handle, tower bolts, wire mesh, fixing on shutter etc. complete all as specified and directed by Engineer-in-charge |
| 39 | Dismantling boarding, any description, fixed in any position with nails as in flooring, ceiling, cupboard, drawers, showcase, cupboard shutters, wooden shelves, Partition, wooden flooring etc complete all as specified and directed. |
| 40 | S&F for wooden laminated flooring in strips of size 120 cm long and 20 cm wide and 6-8 mm thick, fixed with PVC sheet and cushion including fillets/cornices, laid over 12mm thick BWR plywood complete all as per manufracturer\"s instruction all as specified and directed. |
| 41 | Demolition of Stone slabs and tiles of any description or thickness in floors, aprons etc. laid bedded in any mortar complete all as specified and directed |
| 42 | M&L for 20mm thick Granite (of any type) in steps, jambs, pillars, window- cills, cooking platforms and like including rounding edges, laid over 15mm thick in cement mortar (1:6) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite all as specified & directed. |
| 43 | M&L for French polishg on surface of any descriotion , width or girth cleaning and preparation the surfaces including a coat of wood filler on new/old surfaces withtwo or more coats complete all as specified and directed (Bldg upto and including 3 storeys) |
| 44 | Dismantling floor, hearth or wall tiling including cement mortar bedding (but not backing), removing serviceable tiles to store and rubbish off the premises, complete all as specified and directed. |
| 45 | M&L for digital Non-skid ceramic tiles on floor of size 600x600x 8 to 10mm thick etc sert and jointed in neat cemetn slurry and pointed in white or coloured cement to match with shade of tile laid over and including sceed bed or bedding layer 15mm thick in CM(1:4), complete all as specified and directed. Make: Somany, Kajaria, Orient bell |
| 46 | M&L for digital ceramic glazed tiles on wall 600x300x 7 to 8mm thick etc set and jointed in neat cement slurry and pointed in white or coloured cement to match with shade of tile laid over and including screed bed or bedding layer 10mm thick in CM (1:4) complete all as specified and directed Make: Somany, Kajaria, Orient bell |
| 47 | S&F 10mm thick toughned glass as in hinged door, partitions automatic door with necessary long solid fancy typehandle, suitable hinges, locking arrangment, hydraulic floor spring as required with decorative/logo etching and Design as approved by GE including hacking out old glass complete all as specified and directed. |
| 48 | Notes :-An amount of Rs 1,43,495.00 on account of Credit Schedule for Schedule \"A\" Part-II shall be deducted from total quoted amount of BOQ to arrive at the contract sum. |
