Tender For Development Works Naya Nohra Park Infront Of Allen Coaching - 1 Earth work in excavation by mechanical means (Hydraulic Excavator )/ manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan) including dressing of sides and ramming of bottoms, lift upto 1.5 m, including taking out the excavated soil and depositing and refilling of jhiri with watering & ramming and disposal of surplus excavated soil as directed with in a lead of 50 meter. All kinds of soils 2 Providing and laying in position cement concrete of specified gradeexcluding the cost of centring and shuttering - All work upto plinthlevel :All work up to plinth level. 1 : 4 : 8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size). 3 Random rubble masonry with hard stone in foundation and plinth :Cement mortar 1:6 (1 cement : 6coarse sand) 4 Random Rubble stone masonry with hard stone in superstructure aboveplinth level and upto Three Levelabove 30cm. thick walls in : Cement Mortar 1:5 ( 1-Cement : 5-Sand). 5 Providing and laying damp-proof course with cement concrete grade M-150 (1 : 2 : 4) mortar prepared with 1% solution of water-proof compound including two coats of hot blown bitument (2 Kg. per Sqm) complete as per specification with glass strip 3 mm thick at a distance of 1 m. interval. 6 Plaster on new surface on walls in cement sand mortar 1 : 6 including racking of joints etc. complete fine finish : 7 Supply & Stacking good soil of earth at site complete including loading unloading & Transportation etc. 8 Spreading of manure , good earth in required thickness (cost of manure and good earth to be separately ) 9 Providing and laying in position cement concrete including curing, compaction etc. complete in specified grade excluding the cost of centering and shuttering - All work up to plinth level.M20 grade Nominal Mix1: 1.5: 3 (1 cement : 1.5 coarse sand : 3 graded stoneaggregate 20mm nominal size). 10 Providing, laying, spreading and compacting crushed graded stone aggregate as per Table 400-10 & 400.11 to Wet Mix Macadam specifications including premixing the Material with water to OMC in mechanical mixer (Pug mill) as per design mix, carriage of mixed Material by tipper to site laying in uniform layers, with motor grader/F.E. loader/Paver Finisher, in sub-base/base course on a well prepared under-base and compacting with Vibratory Roller to achieve the desired density including lighting, guarding, barricading and maintenance of Driversion etc. (MoRTH specification : Clause 406). with all lead & lift 11 Painting with synthetic enamel paint of approved brand and manufacture togive an even shade : 12 Finishing walls with Acrylic Smooth exterior paint of required shade including all scaffolding. New work (Two or more coat applied @ 1.67 ltr/10 sqm over and including base coat of water proofing cement paint applied @ 2.20 kg/ 10 sqm ). 13 Providing and fixing steel gate, grating , and grills made of angles, tees, square bars, flats,or black pipe with holdfast and fittings complete as per design and drawing including cutting welding and fabrication with priming coat of red oxide 14 Providing and supplying of Garden bench (Victorian) at site both side of garden bench is made of cast iron having back height of 720 mm and seating height of 390 mm (approx.) it may vary at some places and both side of Garden bench is connected with 10 Nos. MS tube of rectangular section size 65×25×3mm having length of 1520 mm for seating purpose with extra support 25×5 mm MS flat for extra stability. All sharp and rough edges of bench is to be grinded with grinder and all fill up with m-seal, and fixed at required position and this bench is having the provision of hold & fast system weight not less than 95Kg(for grouting) bench is complete with a coat of 1st class red oxide and with three coats of synthetic enamel of 1st class quality paint in green colour finally bench is assembled with nuts and fixing at the site complete with the direction of E-I-C. 15 Construction of cement concrete kerb with top and bottom width 115 and 165 mm respectively, 250 mm high in M 20 grade PCC on M-10 grade foundation 150 mm thick, foundation having 50 mm projection beyond kerb stone, kerb stone laid with kerb laying machine, foundation concrete laid manually, all complete as per clause 408 16 Provinding and laying of paver block as per IS 15658 : 2006 (Indian standerd for Precast concrete block for Paving -specification) and IRC :SP:63-2004(guidelines for the use of interlocking concrete blockPavement)M-35,60mm thick to be used in light traffic (Light traffic is defined as a daily traffic up to 150 commercial vehicles exceeding 30 KN laden weight, or an wquivalent up to 0.5 million standerd axles (MSA) for a design life of 20 years (A standerd axle is defind as a single axle load of 81.6 KN ) like pedestrain plazes, shopping complexes ramps, car Parks, office drveways , housing colonies , office complexes , rural roads with low volume traffic ,fram houses, beach sites, tourist resorts, local authority footwys ,residential roads, etc. Category Bdenated only two side like I,Z,T shape etc. as per IRC SP 63:2004 17 Add extra over rates of 1A to E, if colored paver blocks are used20% 18 Laying of lawns including ploughing levelingbreaking of clods manuring and removal of stones etc. (cost of manure or extra good earth to be paid separately )maintenance of lawn foe 30 days or more till the grass forms a thick lawns free from weeds and fit for moving in the duration of planting if lawn die some where the contractor will replant it at his own cost 19 Supply of different varities of tree/shrubs/climbers according to height and age of the plant at side including loading/unloading & transportation etc.completeDifferent flowering plants 900mm to1500mm 20 Different varieties of shrubs 600mm to 900 mm 21 Supply and planting of plants of the following species by the sensor. The height of the plants should be more than 5 m. The plant should be healthy. Before planting the plant, the sensor will have to put approved fertilizer and pesticides as per requirement in each pit and after planting the plant, at least 20 to 25 liters of water will have to be given per plant. Gulmohar 10 to 12 feet Karanj 10 to 12 feet Arjun 10 to 12 feet Neem 10 to 12 feet Sheesham 10 to 12 feet Maintenance of planted plants - The sensor will have to take care of the planted plants and maintain them. For good growth of the plants, the sensor will have to provide non-wood fertilizer as per the need from time to time, give regular water and use insecticides and weeding, making pits and putting bamboo sticks to keep the plants straight etc. are included in the maintenance work. The sensor will have to manage it at his own level. Up to 12 months after planting. Maintenance of grass - Maintenance of planted grass includes removing weeds, regular irrigation, applying fertilizers and regular harvesting through machine so that grass can grow well. Maintenance of Hedge, Climbers, Shrubs at parks including watering, trimming, preparation of thawala, manure and complete work.
