Tender For Road Furniture Work In Zone I D Area (Arc) - Plantation and maintenance at various places in area of Zone I-D (ARC) Sl. No. Item Description 1 Earth work in excavation by mechanical means (Hydraulic Excavator )/ manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan) including dressing of sides and ramming of bottoms, lift upto 1.5 m, including taking out the excavated soil and depositing and refilling of jhiri with watering & ramming and disposal of surplus excavated soil as directed with in a lead of 50 meter. All kinds of soils 2 Providing and laying in position cement concrete including curing, compaction etc. complete in specified grade excluding the cost of centering and shuttering - All work up to plinth level. 3 M10 grade Nominal Mix 1: 3: 6 (1 cement : 3 coarse sand : 6 graded stoneaggregate 20mm nominal size). 4 Random Rubble stone masonry for with hard stone in foundation and plinth in Cement Sand mortar above 30 CM thick wall in: 5 Cement Mortar 1:6 ( 1-Cement : 6-Sand). 6 Random Rubble stone masonry with hard stone in superstructure aboveplinth level and upto five levelabove 30cm. thick walls in : 7 Cement Mortar 1:6 ( 1-Cement : 6-Sand). 8 Plaster on new surface on walls in cement sand mortar 1:6 including racking of joint etc. complete fine finish : 9 20mm thick. 10 Providing and laying at or near ground level factory made kerb stone of M-25 grade cement in position to the required line, level and curvature jointed with cement mortar 1:3 (1 cement : 3 coarse sand ) including making joints with without grooves (thickness of joints except at sharp curve shall not to more than 5mm) including making drainage opening wherever required complete including painting etc. as per direction of Engineer-in-charge (length of finished kerb edging shall be measured for payment). (Precast C.C. kerb stone shall be approved by Engineerin- charge). 11 M-30, 60 mm thick to be used in non traffic areas like building premises, monument premises, land scapes, public gardens/ park, domestic drives, paths and patios, Embankment slopes, sand stabilization Area etc.( As per table 1 of IS 15658:2006 12 (B) Category „B‟ Denated only two side like I,Z,T shape etc. as per IRC SP 63:2004 13 Add extra over rates of item No. 11.38, A to C if colored paver blocks are used 14 Supply & Stacking good soil of earth at site complete including loading unloading & Transportation etc. 15 Good soil of earth 16 Spreading of manure , good earth in required thickness (cost of manure and good earth to be separately ) 17 Providing and laying in position cement concrete including curing, compaction etc. complete in specified grade excluding the cost of centering and shuttering - All work up to plinth level. M20 grade Nominal Mix1: 1.5: 3 (1 cement : 1.5 coarse sand : 3 graded stoneaggregate 20mm nominal size). 18 Providing and laying damp-proof course with cement concrete grade M-150 (1 : 2 : 4) mortar prepared with 1% solution of water-proof compound completeandno glass strips are used andnot applying 2 coats of hot bitumen complete as per specifications. 50mm thick. 19 Random rubble dry stone Kharanja under floor. 20 Finishing wall with water proofing cement paint of approved brand and manufacture and or required shadetogive an even shade including all scaffolding: 21 New work (Two or more coats applied @ 3.84 kg/10 sqm). 22 Painting with synthetic enamel paint of approved brand and manufacture togive an even shade :Two or more coats on new work 23 Providing and fixing steel gate, grating , and grills made of angles, tees, square bars, flats,or black pipe with holdfast and fittings complete as per design and drawing including cutting welding and fabrication with priming coat of red oxide 24 Extra if square,rectangular hollow tubelar sectionsareusedorgrillmadebyflatsonly 25 TUBE WELL 26 Construction of Tube-well upto 100 Meter depth and above in all type of rocks by DTH system and over burden, to accommodate casing pipe of following sizes in all types of soils and over burden including lowering of casing pipes, but excluding cost of casingpipes as per IS : 2800 (Part I & II) 1979 specifications. The work would be completed after obtaining sand free water. The tube well should have a throughout bore as per nominal dia of casing pipe: 27 150mm-do- 28 Supply of ERW M.S. black casing pipe ISI marked (IS:4270/1992) of grade Fe410 of following sizes at site of work. 29 150 mm Nominal bore of pipe 30 Supply of strainer pipes made of ERW M.S. black pipe ISI mark of following sizes at the site of work including required size of slotting as per IS:8110-1985. 31 150 mm Nominal bore of pipe 32 S & F tube well cover ofM.S.sheet (6mm thick) with nuts and bolts complete for casing size: 33 150mm dia 34 S & F M.S. clamp, set of 50 ×6mm flat iron with nuts and bolts etc. for holding the riser pipe assembly of submersible pump set. 35 Supplying and installation of 32 mm dia G.I. pipe medium class IS 1239marked in 3m length including all accessories and fittings required for installation of hand pump. 36 SITC of Radial / mixed flow ISI marked water and anti-corrosive liquid filled submersible motor pump setssuitable for 100/150mm dia borewell.The size of adopter fixed on top of the motor should exceed the top of coupler , for safegaurd the coupler. The construction material of motor and pump should match IS: 8034 : 2018 and IS: 9283 guideline. The radial flow pumpset should operate at 5 star energy efficiency level of BEE and mixed flow pump set should operate at 3 star energy level of BEE, accompained by valid BEE certificate. Motor should be IE2 class as per IEC 60034-2-1: 2007, IEC 60034-30: 2008,& IS12615:2011with required accessories including making connection suitable for Bore well. The job includes labour part of lowering ofriser pipe G.I./H.D.P.E. with rope, cables & pump, installation of complete fitting and accessories, jointing of electrical cables up to Starter. All labour for testing of submersible pumps set and supply of water to water mains, complete in all respect. OEM shall have submitNABL / CPRI / ERDA accrediatedlab type test certificate before execution. All as per pre approved by Engineer in charge.For additional technical parameters of products/ work, refer Annexure A attached with this BSR . 37 1.5HP, 1-Ø, (11 - 94)Mtr, (40 - 10) LPM 38 Providing & Laying P.V.C. / XLPE insulated & P.V.C. sheathed ArrmouredAluminiumcable confirming to IS:1554 P-I / IS :7098 P - I of 1.1 KV withH4- Grade electrolyticaluminium conductor confirming to IS 8130 of purity >99.6 %, round / flat strip armouring of cables, Inner / outer sheath confirming to IS:5831in existing RCC / Hume / Stoneware / PVC pipe/ open duct/cable trench / Cable tray(with cable tie) includingtesting etc. as required of following size. OEM must have its own in house NABL accrediated Laboratory for testing procedure as per IS:10810.For additional technical parameters of product / work refer Annexure A attached with this BSR 39 3 core, 6mm 40 Demolishing brick work manually/ by mechanical means including stacking of serviceable MATERIAL and disposal of unserviceable MATERIAL within 50 metres lead as per direction of Engineer-in-charge. In cement mortar. 41 Demolishing cement concrete manually/ by mechanical means including disposal of MATERIAL within 50 metres lead as per direction of Engineer-in-charge. 1: 3: 6 or richer mix. 42 Supply of dry manure including loading unloading,transportation & stacking at site. 43 Goat dungmanure. 44 Supply of Chemical Fertilizers at store in bags weighing not less than 50 kg each including loading unloading & transportation 45 DAP 46 Supply of PVC hose pipe of different sizes at store including transportation etc. complete. 47 38 mm dia 48 Supply of different varities of tree/shrubs/climbers according to height and age of the plant at side including loading/unloading & transportation etc.complete 49 Different flowering plants 900mm to1500mm 50 Different varieties of shrubs 600mm to 900 mm 51 Different varieties of climbers 900mm to 1500 mm 52 Supply of different varieties of bougainvillea in ply bags/earthen pot according to height growth and age of plant at site including loading unloading and transportation etc. complete 53 Local variety of bougainvillea 600mm to 900mm 54 Different varieties of bougainvillea 600mm to 900mm 55 Supply of different varieties of rose plants in poly bag/ earthen pot according to height growth and age of the plant at site including loading unloading and transportation etc. complete 56 Desi rose / root stock plant 57 Ganganagari rose plant in poly beg 58 Supply of different varieties of palms in poly bags/earthen pot according to height growth and age of plant at site including loading unloading and transportation etc. complete 59 Raffish palm 2 to 2.2 feet 60 Deshi palm 2 to 3 feet 61 China palm 1 to 1.5 feet 62 Arica palm many branches 5 to 6 feet 63 Bottle palm 5 to 8 feet 64 Fox talepalm 5 to 8 feet 65 Fish tale palm 5 to 8 feet 66 T cycuss3 feet 5 feet 67 Supply of different varieties of indoor plantsin poly bags/earthen pot according to height growth and age of plant at site including loading unloading and transportation etc. complete 68 Deshi crotons 69 Rubber plants etc 70 Differentfycus plants tolairy 100mm to 125 cm height 71 Different champa 125 cm to 215 cm height 72 Ground Cover of various varieties 73 Syngonium in P.B(7”X8”)- 6”-1’ 74 Ribbion grass P.B (7”X8”)- 6” 75 Lalsaggin P.B(5”X5”)- 6” 76 Lenthrain P.B- 6” 77 Vadaliain P.B- 6” 78 Jade Plant in P.B(7”X8”)- 6” 79 Pendanus inP.B(9”X11”)- 1’ 80 Digging of pits size 60x60x60 cms. Including removal of stones Manuring applicable of insecticides & watering atleast 15 litre per plant after plan ting. 81 Hedges of various varieties 82 Golden durantain P.B(5”X6”)-6”-1’ 83 TecomaGoudichoudi in P.B(9”X11”)- 2’ 84 Enarmi in P.B(5”X5”)- 1’ 85 Ornamental Plants of different varieties 86 Different varieties of Ficus plantin P.B(9”X11”)- 2’ 87 PART B -UIT Approved Item 88 Providing and fixing benches with side panel casted in Cast Iron single piece and middle part is of mild steel. Approx. ht. is 700 mm and length is 1250 mm the carving work is as per enclosed drawing and details and instruction of engineer incharge. 89 laosnd }kjk fuEu iztkfr;ksa ds ikS/kksa dh vkiwfrZ ,oa yxkukA ikS/kksa dh mapkbZ 5 eh- ls vf/kd gksuk pkfg;sA ikS/kk LoLFk gksuk pkfg,A laosnd }kjk ikS/kk jksi.k ls iwoZ izR;sd [kMMs esa vizqOM [kkn o vko;drkuqlkj dhVukkd Mkyuk gksxk ,oa ikS/kk yxkus ds ipkr de ls de 20 ls 25 yh- ikuh izfr ikS/kk nsuk gksxkA 90 dpukj 10 ls 12 QhV 91 xqyeksgj 10 ls 12 QhV 92 djat 10 ls 12 QhV 93 uhe 10 ls 12 QhV 94 `khke 10 ls 12 QhV 95 Laying of lawns including ploughing levelingbreaking of clods manuring and removal of stones etc. (cost of manure or extra good earth to be paid separately )maintenance of lawn foe 30 days or more till the grass forms a thick lawns free from weeds and fit for moving in the duration of planting if lawn die some where the contractor will replant it at his own costin rows 5 cmapart in either direction 96 Maintenace of Plants by the contractor including of pits/bids watering preparation of Thavala Hoeing weeding etc. & application of insecticides etc. & security if the plant die during maintenance contractor has to replace same height plant at his own cost. (For 12 months) 97 nwc dk la/kkj.k dk;Z &yxh gqbZ nwc dk la/kkj.k dk;Z esa [kjirokj fudkyuk] fu;fer flapkbZ djuk] [kkn Mkyuk ,oa e’khu ds }kjk fu;fer dVkbZ djuk rkfd nwc vPNh rjg ls fodflr gks ldsA ¼12 ekg ds fy;s½ 98 Maintenance of Hedge, Climbers, Shrubs at parks including watering, trimming, preparation of thawala, manure and complete work. (For 12 Months) 99 Maitenance of hedge, climbers, shrubs at dividers including watering, trimming, preparation of thawala manure and complete work including watch and ward of trees, shrubs, plants etc. with protection of planter from unauthorised displayboard posters banners including P & F and protection of advertisment/display boards tree guards fixed by the department and as per direvction of engineer-in-charge. 100 Making and fixing of Tree Guard from Fencing of GI wire of 12 Gauge in size 75mmx75mmx8 feet height tree guard shall be fixed at pit location as directed and icluding planting tree at this location carried from UIT side in all respect as per direction of Engineer-in-charge