Tender For Fth Compound Wall And Drainage Balance Works.--1 Earthwork excavation 2 Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.All kinds of soil 3 PCC 4 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size) 5 Random rubble masonry 6 Random rubble masonry with hard stone in foundation and plinth including levellingup with cement concrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate20 mm nominal size) up to plinth level with:Cement mortar 1:6 (1 cement : 6 coarsesand) 7 RCC upto plinth level 8 Providing and laying in position specified grade of reinforced cement concrete,excluding the cost of centering, shuttering, finishing and reinforcement - All work upto plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mmnominal size 9 RCC above plinth level 10 Reinforced cement concrete work in walls (any thickness), including attachedpilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers,abutments, posts and struts etc. up tot floor five level excluding cost of centering, shuttering, finishing and reinforcement 11 Shuttering for plinth beam 12 Centering and shuttering including strutting, etc. and removal of form for:Lintels, beams, plinth beams, girders bressumers and cantilevers 13 Centering and shuttering for foundation 14 Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete 15 Solid block masonry- Rate include solid block masonry for corniche/grooves/architectural works as shown in the drawing 16 Solid block masonry using pre cast solid blocks (Factory made) of size 30x20x15 cm or nearest available size confirming to IS 2185 part I of 1979 for foundation and plinth with thickness 15cm in: CM 1:6 ( 1 cement :6 coarse sand) etc complete excluding the cost of cement. 17 Steelwork for RCC 18 Steel reinforcement for R.C.C work including straightening, cutting, bending, placingin position and binding all complete upto plinth levelThermo - Mechanically Treatedbars of grade Fe-500D or more 19 Plastering works- Rate include plastering for corniche/grooves/architectural works as shown in the drawing 20 Plastering with 15 mm cement plaster of mix:1: 4 ( 1 cement : 4 fine sand) for compound wall including groove cut,cornice works etc as per drawing and instructions of engineer in charge 21 Centering & shuttering for Drainage 22 Centering and shuttering including strutting, propping etc. and removal of form workfor:Retaining walls, return walls, (any thickness) including attached pilasters, buttresses, plinth and string courses fillets, kerbs and steps etc. 23 Labour charge 24 Miscellaneous labour 25 Structural GI work for Roofing over verandah 26 Steel work in built up GI tubular (round, square or rectangular hollow tubes etc.) trusses etc,including cutting, hoisting, fixing in position and applying a priming coat of approved epoxy primer and 2 or more coats of epoxy paint, including welding and bolted with special shaped washers etc. complete 27 Roofing with cement board 8 mm thick 28 Providing and fixing plain Multipurpose Cement board (High Pressure steam cured) as per IS : 14862, with suitable screws for fibre cement board in ceiling etc. complete (frame work to be paid separately) : 12 mm thick cement board 29 False ceiling with 9mm thick TKT panels 30 Providing and fixing wall panels with 9 mm thick TKT Panel boards of approved quality( clour and pattern of panels shall be as per direction of engineer) with selfdrilling / taping screws / fasteners @ 60cm c/c of approved make(if required for additional support provided aluminum frame work with standard sections-(cost offrame work to be paid for separately) 31 Brick pillar demolition 32 Demolishing brick work manually / by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-Charge.In cement mortar 33 Plastering works 34 12 mm cement plaster finished with a floating coat of neat cement of mix:1:3 ( 1cement : 3 fine sand) 35 Brick masonry
