|
| 1 | EMERGENT REPAIR WORK IN KM 0.00 TO 1.40 OF NH-80 |
| 2 | Bituminous Concrete Grading IIProviding and laying bituminous concrete with higher capacity batch type hot mix plant using crushed aggregates of specified grading, premixed with bituminous binder @ 5.4 percent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MORTH specification clause No. 507 complete in all respects). With CRMB-55 Grading-II (13 mm nominal size) |
| 3 | Tack Coat on Bituminous surfacesProviding and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.20 kg per sqm on the prepared bituminous surface cleaned with mechanical broom. |
| 4 | Road Marking with Hot Applied Thermoplastic CompoundProviding and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35 .The finished surface to be level, uniform and free from streaks and holes. |
| 5 | Painting on Steel SurfacesProviding and applying two coats of ready mix paint of approved brand on steel surface after through cleaning of surface to give an even shade |
| 6 | JACKETING WORK FOR REPAIR OF DAMAGED PIER OF RCC HL BRIDGE AT CH. 53.400 OF NH-333 |
| 7 | Chipping of concrete surface Av. 40 mm Removal of defective concrete, cleaning the surface thoroughly, applying the shotcrete mixture mechanically with compressed air under pressure, comprising of cement, sand, coarse aggregates, water and quick setting compound in the proportion as per clause 2807.1 sand and coarse aggregates conforming toIS:383 and table1ofIS: 9012 respectively, water cement ratio ranging from 0.35 to 0.50, density of gunite not less than 2000 kg/cum, strength not less than 25 Mpa and workmanship conforming to clause 2807.6. |
| 8 | Epoxy Bonding of new concrete to old concrete |
| 9 | Plain/Reinforced cement concretein sub-strucutre complete as per drawing and Technical specificationsHeight 5m to 10mRCC Grade M35 using batching plant, transit mixer & concrete pump |
| 10 | Supplying, fitting and placing HYSD bar reinforcement in sub structure complete as per drawing and technical specifications |
| 11 | Plastering with cement mortar (1:3) on brick work in substructure as per technical specifications |
| 12 | Providing and applying 2 coats of water based cement paint to unplastered concrete surface after cleaning the surface of dirt, dust, oil, grease, efflorescence and applying paint @ of 1 litre for 2 sqm. |
| 13 | Add GST 18% |
| 14 | Add 1% L.C. |
| 15 | Add Segniorage Fee |
