|
| 1 | Geo physical survey charges |
| 2 | Drilling of 150mm (6\") dia vertical clear bores in hard rode in any habitation to required depth on directed by the offices concred including labour charges for insuting PVC casing pipes as per standard specification. upto 100m Pipe depth |
| 3 | Above 100 m Pipe depth |
| 4 | Supply of 165mm OD PVC 6 KSC casing pipe as per standard specification |
| 5 | Supply and delivery of wet type 200LPMx50m Headx2.00 HP mm submersible pumpset with motor and confirming to IS 8034/89 and IS 9283/79 with ISI marking |
| 6 | Three phase panel board (2.0 HP) withD.O.Las per standard specification. The pump set should be supplied with 5Mflat submersible copper cable. |
| 7 | Supply and delivery of 4.00 sq mmWater Proof cable |
| 8 | Supply and delivery of following pipe pipe line materials(with ISI mark) etc complete. 32 mm GI pipe with B class |
| 9 | 32mm dia G.I Elbow |
| 10 | 32mm G.I Capling |
| 11 | 32mm G.M Non Retrun valve |
| 12 | 32mm dia G.Ibend with coupler |
| 13 | 32mm G.M Gate valve |
| 14 | 20mm GI pipe with coupler medum class |
| 15 | 20mmG.I Coupling |
| 16 | 20mmG.I bend |
| 17 | 20mm CICP Tap |
| 18 | 32mm HDPE Pipe |
| 19 | 19mm Nylon Rope |
| 20 | 1000liter H.D.P.E water tank with ISI mark (1270/1996) |
| 21 | Labourcharge for the erection of submersible pump set in bore well including fixing and jointsubmersible cable with proper clamps upto staterto require depth and also fixing of raiser pipesto the required depth valve erection clamp pressure gauges upto the exterior wall of pump room and erection of panel board consisting of TPICNswitches starter Voltmeter, Ammeter, three pilot(indicating) lamps capacitor single phase preventor, water level guard and laying and jointing the cable and twin earthing as per IS rules etc complete. |
| 22 | Supply and Run of 2x4 sq.mm(84/0.3) PVC insulated Sc unsheathed Cu.Conductor of 1100V grade in 25mm dia G.I pipe (Bclass) suitable bend at both ends with necessary angle iron up right and end supports for mains. |
| 23 | Supply and Run of 2x4 sq.mm(84/0.3) PVC insulated Sc unsheathed Cu.Conductor of 1100Von 7/20 Gibearer wire for service connection mains. |
| 24 | Supply and fixing of following electrical materials16Amps MTPC Switch |
| 25 | 16 Amps fuse carrier |
| 26 | Supply and Delivery of MS Kisok of Size 0.75m x 0.45m x 0.75m madu up of MS angle of size 50mm x 50mm x 4mm alround covered with 16 gauge MS sheet and Kiosk door madu up of MS plates of size 25mm x 3mm including cutting, welding, grinding, locking arrangements and labour charges etc,. |
| 27 | S& Fixing of M.S bore well Dummy |
| 28 | S&F M.Sbore clamp |
| 29 | Earth workexcavating and deposting on bank with initial lead of 10m& intial lift of 2m in hard stiff clay, stiffblack cotton, hard red earth shales ,murram, gravel, stoneyearth mixed with small size boulders etc completed as per std specification. |
| 30 | Plain Cement Concrete 1:4:8 Mix (one part cement, four part sand and Eight part of aggrigate) using 40 mm size ISS HBG metal from approved quarry including cost and conveyance of all materials to site. Loading and unloading charges and labour charges for mixing. Laying and curing etc., complete as per TNDSS NO : 28 & VI (S2) VI (S5A) VII standard specifications as directed by Engineer incharge. |
| 31 | Brick work in cement motor 1:5 mix(one cement and five sand) using 2nd class country brick of size 9\"x41/2\"x3\" includingcuring finishing and cost and conveyance of materials and labour chargeetc completeas per std specification. |
| 32 | Plastering Cemend mortor 1:5mix (one cement and five sand) 12mm thick includingcost and conveyanace of materials and labour charge etc completed as per std specification. |
| 33 | Cement paint two coats of approved colour and qualityincluding preparation of plastering wall surface , finishing neatly and all other labour ,materials costetc complete as per std specification. |
