Tender For 1. Toilet Construction Work In Gogamedi (Devasthan Department) - Earth work in excavation in foundation, trenches etc. including dressing of sides and ramming of bottoms, including getting out the excavated material, refilling after laying pipe/ foundation and disposal of surplus excavated material at a lead upto 50m suitable site as per direction of Engineer for following depths, below natural ground / Road top level.In all types soils/ saturated soil such as moorum, sand, sandy silt,clay, black cotton soil, kankar, etc.Depth upto 1.5 m 2 Providing and laying in positioncement concrete including curing, compaclion etc. complite in specified grad excluind the cost of centering and shuttering.All work up to plinth level.1:4:8 (1Cement :4 Course Sand 8 Graded stone aggregate 20 mm nominal size lw 3 Providing and laying in position specified grade of reinforced cementconcrete excluding the cost of centring, shuttering, finishing and reinforcement - All work upto plinth level :1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) 4 Brick work with FPS bricks of class designation 75 in foundation and plinth in:Cement mortar 1:6 (1 cement : 6 coarse sand) 5 Brick work with FPS bricks of class designation 75 in superstructure above plinth level upto two stories in all shapes and sizes in :Cement mortar 1:6 (1 cement : 6 coarse sand) 6 Half brick masonry with FPS bricks of class designation 75 in superstructure above plinth level upto two stories.Cement mortar 1:4 (1 cement :4 coarse sand) 7 Cement plastering including T&P, scaffolding, material and complete labpour, including cost of water, curing, racking of joints etc. with 20 mm cement plaster of mix : 1:4 (1 cement : 4 fine/ coarse sand) 8 Cement plastering including T&P, scaffolding, material and complete labpour, including cost of water, curing, racking of joints etc. with 15 mm cement plaster of mix : 1:4(1 cement : 4fine/ coarse sand) 9 Cement plastering including T&P, scaffolding, material and complete labpour, including cost of water, curing, racking of joints etc. with 12mm cement plaster of mix : 1:4 (1 cement : 4 fine/ coarse sand) 10 Providing and fixing pressed steel door frames confirming to IS:4351 manufactured from commercial mild steel sheet of 1.25 mmthickness including hinges jamb, lock jamb, bead and if required angle threshold of mild steel angle of section 50x25mm, or base tiesof 1.25mm pressed mild steel welded or rigidly fixed together bymechanical means, adjustable lugs with split end tail to each jambincluding steel butt hinges 2.5mm thick with mortar guards, lock strike-plate and shock absorbers as specified and applying a coat ofapproved steel primer after pre-treatment of the surface as directed by Engineer-in-charge: 11 Centring and shuttering with plywood or steel sheet upto two stories or height upto 7.5 metre above plinth level including strutting,propping etc. and removal of form for :Lintels, beams, plinth beams, girders, bressumers and cantilevers 12 Reinforced cement concrete work in beams, suspended floors,roofs having slope upto 15° landings, balconies, shelves, chajjas,lintels, bands, plain window sills, staircases and spiral stair cases upto two stories excluding the cost of centring, shuttering, finishing and reinforcement:M-20 Grade Concrete (1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size) -As per design mix) 13 Reinforcement for R.C.C. work at all levels including straightening,cutting, bending, placing in position and binding all complete.Thermo-Mechanically Treated bars. 14 Providing & Fixing ISI Marked fulsh door shutters conforming to ISI 2202 Rate As Per RUIDP BSR 2017 15 P&F steel galzed door windows and ventilator shutter of stnadard rooled steel section….. Steel lugs 13 x 3 mm , 10 cm long 16 Providing and fixing 1st quality standard white, grey, ivory, fume redbrown, light green, light blue and other light shades glazed tiles confirming to IS : 13753 & IS :15622 of size 200mm x 300mm in walls, floors, steps, pillars etc. laid on a bed of neat cement slurry finished with flush pointing in the white cement mixed with pigment to match the shade of the tile complete (excluding the cost of cement plaster on walls and pillar).. 17 Providing and fixing 1st quality ceramic glazed vitrified tiles of colourstandard white, grey, ivory, fume, red brown, light green, light blue,and other light shades with water absorption less than or equal to0.08% confirming to IS : 13753 & IS : 15622 in floor, steps etc laidon bed on neat cement slurry finished with flush pointing in the white cement mixed with pigment to match the shade of the tile complete(excluding the cost of cement plaster on wall and pillar) 18 Kota stone slabs 25 mm thick in risers of steps, skirting, dado andpillars laid on 12 mm (average) thick cement mortar 1:3 (1 cement 3coarse sand) and jointed with grey cement slurry mixed with pigmentto match the shade of the slabs, including rubbing and polishing complete. 19 With ready mixed aluminium primer of approved brand andmanufacture on resinous wood and plywood 20 Painting with synthetic enamel paint of approved brand andmanufacture to give an even shade :Two or more coats on new work 21 Distempering with dry distemper of approved brand and manufacture (two or more coats) and of required shade on newwork, over and including priming coat of whiting to give an evenshade. 22 Providing and fixing water closet squatting pan (Indian type W.C.pan ) with 100mm sand cast Iron P or S trap, 10 litre low level whiteP.V.C. flushing cistern with manually controlled device (handle lever)conforming to IS : 7231, with all fittings and fixtures completeincluding cutting and making good the walls and floors whereverrequired : White Vitreous china Orissa pattern W.C. pan of size 580x440mm with integral type foot rests. 23 Providing and fixing white vitreous china pedestal type water closet(European type) with seat and lid, 10 litre low level white vitreouschina flushing cistern & C.P. flush bend with fittings & C.I. brackets,40mm flush bend, overflow arrangement with specials of standard make and mosquito proof coupling of approved municipal designcomplete including painting of fittings and brackets, cutting andmaking good the walls and floors wherever required : 24 Providing and fixing white vitreous china flat back or wall corner typelipped front urinal basin of 430x260x350mm and 340x410x265mm sizes respectively. 25 Providing and fixing wash basin with C.I. brackets, 15 mm C.P.brass pillar taps,32 mm C.P. brass waste of standard pattern,including painting of fittings and brackets, cutting and making goodthe walls wherever require : White Vitreous China Flat back wash basin size 450x300 mm withsingle 15 mm C.P. brass pillar tap. 26 Providing and fixing 600x450 mm beveled edge mirror of superior glass (of approved quality) complete with 6 mm thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete. 27 Providing and fixing G.I. pipes complete with G.I. fittings and clamps,including cutting and making good the walls etc.Internal work - Exposed on wall 15 mm dia. nominal bore 28 Providing and fixing G.I. pipes complete with G.I. fittings and clamps,including cutting and making good the walls etc. Internal work 20 mm dia. nominal bore 29 Providing and fixing C.P. brass long body bib cock of approvedquality conforming to IS standards and weighing not less than 690 gms.15 mm nominal bore 30 Providing and placing on terrace (at all floor levels) polyethylenewater storage tank ISI : 12701 marked with cover and suitablelocking arrangement and making necessary holes for inlet, outletand overflow pipes but without fittings and the base support for tank 31 Providing and fixing C.P. brass stop cock (concealed) of standarddesign and of approved make conforming to IS:8931. 15 mm nominal bore. 32 Providing and fixing PTMT Ball cock of approved quality, colour andmake complete with Epoxy coated aluminium rod with L.P./ H.P.H.D.plastic ball.15 mm nominal bore, 105 mm long. Weighing not less than 138 gms. 33 Providing and fixing on wall face Unplasticised Rigid PVC Singlesocketed pipes rain water pipes conforming to IS : 13592 Type Aincluding jointing with seal ring conforming to IS : 5382 leaving 10 mm gap for thermal expansion.75 mm diameter 34 110 mm diameter 35 Providing and fixing Unplasticised P.V.C. connection pipe with PTMT Nuts collar and bush of approved quality and colour.15 mm nominal bore with 30cm length. 36 Wiring of light point/ fan point/ exhaust fan point/ call bell point asper PWD specification for electrical Works with ISI marked 1.5 sq. mm nominal size FR PVC insulated unsheathed flexible copperconductor 1.1 kV grade (IS:694) and 1.5 sq. mm nominal size FR PVC insulated unsheathed flexible copper earth conductor 1.1 kVgrade (IS:694) in recessed ISI marked MMS ( IS:9537 P - III )vergin material PVC conduit & its all accessories( J.B. , Bends etc.), round tiles,18 SWG G.I. box with earth terminal, 6 A switch , 3 pin ceiling rose/ Lamp holder / 3 point Connector, 3.0 mm Short Ponit 37 Wiring of light point/ fan point/ exhaust fan point/ call bell point asper PWD specification for electrical Works with ISI marked 1.5 sq. mm nominal size FR PVC insulated unsheathed flexible copperconductor 1.1 kV grade (IS:694) and 1.5 sq. mm nominal size FR PVC insulated unsheathed flexible copper earth conductor 1.1 kVgrade (IS:694) in recessed ISI marked MMS ( IS:9537 P - III )vergin material PVC conduit & its all accessories( J.B. , Bends etc.), round tiles,18 SWG G.I. box with earth terminal, 6 A switch , 3 pin ceiling rose/ Lamp holder / 3 point Connector, 3.0 mm Mudium Poni 38 Wiring of light point/ fan point/ exhaust fan point/ call bell point asper PWD specification for electrical Works with ISI marked 1.5 sq. mm nominal size FR PVC insulated unsheathed flexible copperconductor 1.1 kV grade (IS:694) and 1.5 sq. mm nominal size FR PVC insulated unsheathed flexible copper earth conductor 1.1 kVgrade (IS:694) in recessed ISI marked MMS ( IS:9537 P - III )vergin material PVC conduit & its all accessories( J.B. , Bends etc.), round tiles,18 SWG G.I. box with earth terminal, 6 A switch , 3 pin ceiling rose/ Lamp holder / 3 point Connector, 3.0 mm Long Ponit 39 Wiring of 3/5 pin 6 amp. Light plug point as per PWD specification for electrical Works with ISI marked 1.5 sq. mm nominal size FR PVC insulated unsheathed flexible copper conductor 1.1 kV grade 40 SITC of IP 40 3 pole current limiting Moulded case circuit breaker(MCCB) made of flame retardent & heat resistant material havingfollowing current rating, short circuit breaking capacity at 440/415V, 50 Hz; O/L & S/C settings as per PWD specification for electrical Works, conforming to IS/IEC 60947 P -2 :2003 with front face andcentralised adjustable, trip free mechanisum, 41 Providing & Fixing of Fluorscent tube rod in existing fixtures asrequired complete in all respect. All as per pre approved by Engineerin charge. For additional technical parameters of products/ work ,refer Annexure A attached with this BSR . 36/40 watt 42 Providing & Fixing of modular type Step Fan regulator duly ISImarked (IS :11037) as per PWD specification for electrical Works,made out of unbreakable and fire retardant vergin poly carbonatewith brass terminals and captive screws & silver alloy contact tip 43 Providing and fixing circular/ Hexagonal cast iron or M.S. sheet box for ceiling fan clamp of internal dia 140mm, 73mm height, top lid of 1.5mm thick M.S. sheet with its top surface hacked for proper bonding, top lid shall be screwed into the cast iron/ M.S. sheet box by means of 3.3mm dia. round headed screws, one lock at the corners. Clamp shall be made of 12mm dia M.S. bar bent to shape as per standard drawing.
