|
| 1 | Stone for masonry work |
| 2 | Stone Aggregate(single size):20 mm nominal size |
| 3 | Stone Aggregate(single size): 10 mm nominal size |
| 4 | Coarse sand (zone III) |
| 5 | Portland Cement |
| 6 | Hire charges of Concrete Mixer 0.25 to 0.40 cum with Hopper |
| 7 | Vibrator (Needle type 40 mm) |
| 8 | Galvanised wire mesh of average width of aperture 1.4 and nominal dia. of wire 0.63 mm |
| 9 | Mild steel tubes hot finished welded type |
| 10 | Red oxide Zinc chromate primer |
| 11 | Welding by electric plant |
| 12 | Stone Aggregate(single size): 40 mm nominal size |
| 13 | wall form panel 1250x500 mm |
| 14 | Corner angle 45x45x5 mm 1.50 m long |
| 15 | 100 mm channel shoulder 2.5 m long |
| 16 | Double clip (bridge clip) |
| 17 | Twisted steel/deformed bars |
| 18 | M.S. Tube 40 mm dia |
| 19 | G.I. pipes 25 mm dia |
| 20 | Polyurethene bags |
| 21 | GI trafford profile sheet 0.35mm thick |
| 22 | Bitumen washer |
| 23 | Stainless steel screws 50 mm |
| 24 | Vitrified floor tile 60x60 cm |
| 25 | PVC pipe 63 mm outer dia . 6kgf/cm2 |
| 26 | PVC pipe 63 mm outer dia. 4 kgf/cm2 |
| 27 | PVC pipe 75 mm outer dia 6kgf/cm2 |
| 28 | Royalty for good earth |
| 29 | Quarry Waste |
| 30 | Galvanised steel plain sheets |
| 31 | G.I pipes 50 mm dia |
| 32 | Stone Aggregate(single size): 06 mm nominal size |
| 33 | Interlocking C.C paver block (80 mm thick, M-40 hydraulic blocks) |
| 34 | Solid blocks of size 30x20x15cm |
| 35 | Structural steel such as tees, angles, channels and R.S. joists |
| 36 | Adjustable span ESO+SI (2.35-3.40) |
| 37 | Adjustable telescopic prop 3 m (2.02-3.75m) |
| 38 | Anjili wood scantls |
| 39 | Mild Steel round bar above 12 mm dia |
| 40 | Flats up to 10 mm in thickness |
| 41 | Rawl plug 50 mm (designation 10 nos) |
| 42 | Fine sand (zone IV) |
| 43 | G.I. pipes 40 mm dia |
| 44 | Second class kail wood in planks |
| 45 | Second class kail wood in scantling |
| 46 | Safeda ballies 125 mm diameter |
| 47 | Dwarf coconut saplings |
| 48 | Interlocking C.C. paver block (60 mm thick, M-30) |
| 49 | Aracanut post |
| 50 | Boulder 50 mm to 200 mm |
| 51 | Crates made of Mesh type 10x12 (D=100mm)Zn+PVC coated Mesh wire diameter 2.70/2.70 mm (ID/OD) |
| 52 | Deharadun white lime |
| 53 | Gravel 1.5 mm to 2 mm |
| 54 | Epoxy paint |
| 55 | White Vitreous china 10 lit. (full flush) capacity controlled low level flushing cistern with all fittings |
| 56 | Synthetic enamel paint in black or chocolate shade |
| 57 | Bright finished or black enameled mild steel butt hinges 100x58x1.90 mm |
| 58 | Bright finished or black enameled mild steel butt hinges 50x37x1.50 mm |
| 59 | Bright finished or black enameled mild steel screws 40 mm |
| 60 | Bright finished or black enameled mild steel screws 20 mm |
| 61 | Vitreous China flat back wash basin 630x450 mm |
| 62 | 15 mm C.P.brass tap |
| 63 | C.P. brass waste 32 mm |
| 64 | C.I. bracket for wash basin and sinks |
| 65 | Stainless steel kitchen sink - without drain board 470x420 mm bowl depth 178 mm |
| 66 | Semi Rigid PVC waste pipe for sink and wash basin 32 mm dia with length not less than 700 mm i/c PVC waste fittings |
