|
| 1 | Excavation in foundation trenches etc. in all kinds of soil such as pick work, jumper work, blasting hard or soft rock, by chieselling where the blasting work is water with in all heights stacking the excavated soil with in all leads clear from the edge of excavation and then returning the stacked soil in 15 cms. layers when required in to plinths, sides of foundations consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth as per the direction of Engineer-in-charge with in all leads and lifts complete in all respect.Pick Jumper work |
| 2 | Providing and laying cement concrete 1:4:8(1cement:4sand:8 graded stone aggregate 40mm nominal size and curing completeexcluding the cost of form work in foundation and plinth in all leads and lifts. |
| 3 | R/R Masonry coursed with hard stone of approved quality in c.m. 1:6 (1cement :6 sand) in Foundation and plinth i/c all lead and lifts. |
| 4 | Brick Masonry using common brunt clay building bricks in super stracture above plinth level. up to floor two level. Cm 1:6 (1cement :6 sand). (2nd class bricks). |
| 5 | Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm, so as to give a fair finish including centring, shuttering, strutting and propping etc. with wooden battons and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4.00mtrs. and removal of the same for in-situ-reinforced and plain concrete work in:- |
| 6 | Flat surfaces such as soffits of suspended floors, roofs, landing and the like floor etc. upto 200mm in thickness within all leads and lifts. |
| 7 | Providing and laying cement concrete 1:1.5:3 (1 cement: 1.5 sand : 3 graded stone aggregate 20mm nominal size) and curing complete excluding the cost of form work and reinforcment for RCC work in :-In foundation and plinth within all leads and lifts complete in all respect. |
| 8 | Suspended floors, roofs, landing and shelves and their supports balconies, beams, girder, bressumers and cantilever up to floorlevel with in all leads and lifts complete in all respect. |
| 9 | Providing tor steel reinforcement for RCC work including bending and ballies complete (cost fof posts, struts and straining bolts shall be paid for separately. |
| 10 | Boulder filling behind retaining wall including all leads and lifts complete in all respect. |
| 11 | 6mm thick cement plaster to ceilling cm 1:3 ( 1cement : 3 sand)all leads and lifts complete in all respect |
| 12 | 20 mm thick cement plaster in single coat on rough side of brick/stone/concrete walls for interior plastering up to floor -2 level including arrisses, internal rounded angles, chamfers and or rounded angles not exceeding 80 mm in girth and finished even and smooth in C.M 1:6 (1 cement, 6 sand) with in all leads and lifts complete in all respect |
| 13 | Distempering (two coat) with oil bound washable distemper of approved brand and manufacture and of required shade on un- decorated wall surfaces to give an even shade over and including a priming coat with distemper primer of approved brand and manufacture after thoroughly brushing the surface free from mortar droppings and other foreign matter and also including preparing the surface even and sand papered smooth within all leads and lifts. |
| 14 | Finishing wall with water proofing cement paint of approved brand and manufacture & of required shade on decorated wall surfces (two coats) to given an even shade after thoroughly brushing the surface to remove all dirt and remains of loose powered materials. |
| 15 | Providing wood work in frames of doors, windows, clearstory, windows and other frames wrought, framed and fixed in position in 1st class SAL wood all leads and lifts complete in all respect |
| 16 | Providing and fixing glazed andpanelled glazed or panelled and glazed shutters for doors windows & clear story windows including black enamelled iron butt hinges with necessary screws 40mm thick 1st class SAL woodall leads and lifts complete in all respect |
| 17 | Providing and fixing wire gauge shutters using glavanised MS wire gauge of IS gauge destination 85 G with wire of dia 0.56mm for doors, windows including bright finished black enamelled iron hinges with necessary screws 40mm thick 1st class SAL wood (40mm thick) within all leads and lifts. |
| 18 | Provd/Laving Duro stone Vetrified tiles (300x300mmx10mm)in grey/colered or of approved shade in flooring,treads of step and landing laid ona bed of 12mm thick c.m.1:3 in (1cement :3 sand )laid over and jointed with neat cement slurry finished with flush pointing in white cement mixed with pigment of requred shade to match the shade. of tiles. Complete. |
| 19 | Provd/Laving Duro stone Vetrified tiles (300x300mmx10mm)in grev/colered or of approved shade in Skirting of Riser of step. Dado etc. laid ona bed of 12mm thick c.m.1:3 in (1cement :3 sand )laid over and jointed with neat cement slurry finished with flush pointing in white cement mixed with pigment of requred shade to match the shade. of tiles. Complete. |
| 20 | Painting two coats (excluding priming coat) on newwood and wood based surfaces with ready mixed paint brushing to give an even shade including cleaning of all dirt, dust and other foreign matter and sand papering and stoppingwith ready mixed paint other than white within all leads and lifts. |
| 21 | Providing 40x3 mm flat iron hold fast 40 cm long including fixing to frame with 10mm diameter bolts nuts and wooden plugs and embeding in cement concrete block 30x10x15cm 1:3:6 (One cement: three sand: six graded stone aggregate 20mm nominal size) within all leads and lifts. |
| 22 | Providing and fixing Ms sliding bolts including of 200 X 10 mm |
| 23 | P/Fsteel Tower bolts (barrel type) anodised transparent with necessary screws. |
| 24 | 200x10mm |
| 25 | P/F Steel handles anodized transparent or dyed to required colour or shade with screw etc. |
| 26 | 200x10mm |
