|
| 1 | Item rate |
| 2 | Stone for masonry work |
| 3 | Quarry Waste |
| 4 | Interlocking C C paver block (80 mm thick, M-30) |
| 5 | Stone Aggregate (single size):06 mm nominal size |
| 6 | Stone Aggregate(single size):20 mm nominal size |
| 7 | Stone Aggregate (single size):10 mm nominal size |
| 8 | Stone Aggregate (single size): 40mm nominal size |
| 9 | Gravel 5 mm to10 mm |
| 10 | Gravel 1.5 mmto 2 mm |
| 11 | Coarse sand (zone III) |
| 12 | Fine sand (zone IV ) |
| 13 | Portland Cement |
| 14 | Twisted steel/deformed bars |
| 15 | wall form panel 1250 X 500 mm |
| 16 | Corner angle 45X45X5 mm 1.50 m long |
| 17 | 100 mm channel shoulder 2.5 m long |
| 18 | Double clip (bridge clip) |
| 19 | Single clip |
| 20 | M S Tube 40 mm dia |
| 21 | Royalty for good earth |
| 22 | Structural steel such as tees,angle , channels and R.S.joists |
| 23 | Red oxide Zinc chromate primer |
| 24 | Adjustable telescopic prop 3 m (2.02-3.75m) |
| 25 | Beam clamp 300-380 mm (450-1070 mm ) |
| 26 | Solid blocks of size 30x20x15 cm |
| 27 | Water thinnable cement primer for interior wall surface , having VOC content less than 50 gms/litre |
| 28 | Plastic emulsion paint |
| 29 | Mild steel tubes hot finished welded type |
| 30 | Synthetic enamel paint in black or chocolate shade |
| 31 | GI trafford profile sheet 0.35 mm thick |
| 32 | Bitumen washer |
| 33 | Stainless steel screws 50 mm |
| 34 | Galvanised wire mesh of average width of apertune 1.4 and nominal dia of wire 0.63 mm |
| 35 | Wire nails |
| 36 | Epoxy paint |
| 37 | Mild steel sheets for tanks |
| 38 | Iron pintels including weldded pin |
| 39 | Mild steel sheets with bolts and nuts to rest on pintels |
| 40 | Mild steel hooks |
| 41 | Oxidised mild steel handles 125 mm |
| 42 | Oxidised mild steel screws 25 mm |
| 43 | mild steelbutt hinges 100x 58 x 1.90 mm |
| 44 | Bright finished or black enameled mild steel screws 40 mm |
| 45 | Flats up to 10 mm in thickness |
| 46 | Vitrified floor tile 60 X 60 cm |
| 47 | stainless steel kitchen sink without drain board 470 X 420 mm bowl depth 178 mm |
| 48 | C. I bracket for wash basin and sinks |
| 49 | semi rigid PVC waste pipe for sink and wash basin 32 mm dia with length not less than 700 mm i/c PVC waste fittings |
| 50 | PVC pipe 20 mm outer dia 10 kgf/cm2 |
| 51 | PVC pipe 32 mm outer dia 10 Kgf/cm2 |
| 52 | PVC pipe 63 mm outer dia 6kgf/cm2 |
| 53 | PVC Elbow 63 mm dia |
| 54 | PVC bend 63 mm dia |
| 55 | PVC Tee 63 x 63 X 63 mm dia |
| 56 | PVC Reducer 63 X 50 mm dia |
| 57 | PVC pipe 160 mm outer dia 4 kgf/cm2 |
| 58 | Mild Steel round bar above 12 mm dia |
| 59 | Rawl plug 50 mm (designation 10 nos) |
| 60 | Second class kail wood in planks |
| 61 | Second class kail wood in scantling |
| 62 | Hire charges of Concrete Mixer 0.25 to 0.40 cum with Hopper |
| 63 | Vibrator (needle type 40 mm ) |
| 64 | Welding by electric plant |
