Tender For Special Repair Of Gauharpur To Subedarpur Road Lot No-3 Of 5
Tender Value
62.20 Lakhs
Estimated cost
Bid Submission
27 Dec 2024
0 days left
EMD
6.22 Lakhs
Bank guarantee accepted
Document Fee
2714
Non-refundable
Tender Type
Online
Tender Overview
Organization
Tender ID
Competition Type
NCB
Bidding Type
Tender
Location / State
mahrajganj → Uttar Pradesh
EMD Exemption
Not Available
Quantity
Not Available
Website
Contact Person
Address
Project Description
Special Repair Of Gauharpur To Subedarpur Road Lot No-3 Of 5
BOQ
| Sl. No. | Item Description |
| 1 | Water Bound Macadam Grading -III :- Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheeled 80-100 kn in stages to proper grade and camber, applying and brooming crushable screening to fill up the interstices of coarse aggregate, watering and compacting to the required density grading-3 as per T.S.C.405 SL. No. 4.7(GST will be paid extra as applicable) (Includinglabour cess) |
| 2 | Tack coat :- Providing and applying tack coat with bitumen using bitumenpressure distributor at the rate of 0.30 kg per sqm on the prepared bituminous/granular surface cleaned with mechanical broom. As perper MORD S.N.-5.2Specification No. 503(Including cost of Bitumen & labour cess)(GST will be paid extra as applicable) |
| 3 | Premix Carpet :- Providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by seal coat of either Type C asper Mord S.N.-5.9 & Specification 508 (Including cost of Bitumen & labour cess)(GST will be paid extra as applicable) |
| 4 | Seal Coat Type C :- Providing and laying seal coat sealing the voids in a bituminousVG-10, surface laid to the specified levels, grade and cross fall using Type C as per Mord S.N.-5.12 Technical Specification Clause 510(Including cost of Bitumen & labour cess)(GST will be paid extra as applicable) |
| 5 | Cement Concrete Pavement Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade OPC cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, using curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501, Sl No. 6.4)(GST will be paid extra as applicable) (Includinglabour cess) |
| 6 | Earth work cutting or in embankment to oridinary soil, excavation to be in the from of regular pits not exceeding 0.5m in depth and earthwork in embankment to be in 20cm. layers, including ramming and dressing the surface to required levels & slopes & also including 1.5m. lift & 30m. lead The earth from cutting to be used in making embankment or to be deposited as spoil banks within 30m. distance as directed by the engineer-in-charge (Excluding Royalty) as per SI. No. 253 (GST will be paid extra as applicable) (Includinglabour cess) |
AI Tender Summary
Tender Timeline
Dec 19, 2024
11:30 IST
Tender Published
Tender notice published.
CompletedDec 27, 2024
17:00 IST
Bid Submission Deadline
Online submission via eProcurement portal.
CompletedDec 27, 2024
Bid Opening Date
Technical bids will be opened and evaluated.
CompletedTender Documents
Download All (ZIP) ↓
Disclaimer
We takes all possible care for accurate & authentic tender information. However users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender