Tender For Beatification Work Of Hospital Chauraha At Raebareli - Dismantling road up to ground level to prepare for piling 2 Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. In All kinds of soil. 3 P/L of CC 1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) 4 Boring with hydraulic piling rigs with power units, Providing and installing cast in situ single under reamed piles of specified diameter and length below pile cap in M-25 cement concrete, to carry a safe working load not less than specified, excluding the cost of steel reinforcement but including the cost of boring with bentonite solution and the length of the pile to be embedded in pile cap etc. all complete. (Length of pile for payment shall be measured upto to the bottom of pile cap): 300 mm dia piles 5 Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : 1:11/2:3 (1 cement: 11/2 Coarse Sand: and 3 graded stone aggregate 20mm nominal size. In Pile Cap / beam 6 Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:6 (1 cement : 6 coarse sand) 7 Excavating, supplying and filling of local earth (including royalty) by mechanical transport upto a lead of 5km also including ramming and watering of the earth in layers not exceeding 20 cm in trenches, plinth, sides of foundation etc. complete. 8 Centering and shuttering including strutting, propping etc. and removal of form for Foundations, footings, bases of columns, etc. for mass concrete 9 Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. 10 12mm thick cement plaster of mix 1:4 (1 cement : 4 coarse sand) 11 Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS: 15622, of approved make, in all colours and shades, laid on 20mm thick cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/ sqm including grouting the joints with white cement and matching pigments etc., complete. 12 Providing and laying Polished Granite stone flooring in required design and patterns, in linear as well as curvilinear portions of the building all complete as per the architectural drawings with 18 mm thick stone slab over 20 mm (average) thick base of cement mortar 1:4 (1 cement : 4 coarse sand) laid and jointed with cement slurry and pointing with white cement slurry admixed with pigment of matching shade including rubbing , curing and polishing etc. all complete as specified and as directed by the Engineer-in-Charge. 13 Providing and fixing of granite inauguration tablet engraving thereupon text as prescribed by engineer in charge and upto his satisfaction. 14 Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. 15 Providing and fixing double scaffolding system (cup lock type) on the exterior side of building/structure, upto 25 metre height, above ground level, including additional rows of scaffolding in stepped manner as per requirement of site, made with 40mm dia M.S. tube, placed 1.5 metre centre to centre, horizontal & vertical tubes joint with cup & lock system with M.S. Tubes, M.S. tube challis, M.S. clamps and staircase system in the scaffolding for working platform etc. and maintaining it in a serviceable condition for execution of work of cleaning and/ or pointing and/ or applying chemical and removing it thereafter. The scaffolding system shall be stiffened with bracings, runners, connecting with the building etc, wherever required, if feasible, for inspection of work at required locations with essential safety features for the workmen etc., complete as per directions and approval of Engineer-in-charge.Note:- (1) The elevational area of the scaffolding shall be measured for paymentpurpose. (2) The payment will be made once only for execution of all items forsuch works. 16 Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture 17 Providing and fixing stainless steel ( Grade 304) railing made of Hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (wherever required) and fitting the same with necessary stainless steel nuts and bolts complete, i/c fixing the railing with necessary accessories & stainless steel dash fasteners , stainless steel bolts etc., of required size, on the top of the floor or the side of waist slab with suitable arrangement as per approval of Engineer-in-charge, (for payment purpose only weight of stainless steel members shall be considered excluding fixing accessories such as nuts, bolts, fasteners etc.). 18 Design, Supply, Fixing, Installation and Commissioning of lights for Ornamental Tower with Innovative Lights, including Operation and Maintenance for a period of 1 Years, Supply of surface mounted LED Light fitting having min lumens output 3000 Im, suitable protection rating, system power in wattage 34-40- watt, 220 volt AC, Power factor between 0.90- 0.99, system luminous efficiency > 80i / c wiring connection, Supply & installation of Distribution box with Double Door 12 Way Encloser, with 1 Nos 32 Amp DP MCB, 4 NOS 16 Amp DP MCB, with necessary connection as required. With fixing arrangement on Existing MS supporting pipe of Shied / Wall complete in all respect and connections for supply, Supplying and drawing 3 X 2.5 sq. of FRLS PVC insulated copper conductor, single core cable in the existing surface/ recessed steel/ PVC conduit as required.3 3 * 2.5 sq. mm as per site requirement price cover supplying and making end termination with brass compression gland and aluminum lugs for following size of PVC insulated and PVC sheathed / XLPE aluminum conductor cable of 1.1 KV grade as required 2 * 10 sq. mm (19mm)., Supply of 3 * 4 ft panel box with 2 nos cooling fans (Easter make) 1500 ft LED RGB color water proof 12 volt model no P 12944, Controller YC 10000_10 pcs 12watt, Controller YC 9000_6 pcs 5 watt LT switchgear MNX 12 240 vee3 pole connecter, 1 mm and .5 mm polycab wire, SMPS 12V 18 pcs, 2 core 6 mm cable 14 mtr, MCB 32 AMP 2 pcs Havells make, Analog Time Switch FM / 1 . 16 ft height of 1 tower with top spread of 5 ft diameter (structure made of ms iron), 3 * 3 ft deep below ground and 2.5 *7.5 ft above ground foundation) (MS tower provided seperately) 19 Providiingand laying 80mm thick approved ruber moulded Interlocking Pavers over a bed of sand and filling the joints of the same with fine sand all in desired level and upto the specification of MORD 1500 (6.7) and upto the satisfaction of engineer in charge.
