|
| 1 | LABOUR CHARGES (As per scope specified in Clause No. 1(A)of Annexure-V (A) |
| 2 | SUPPLY OF FOLLOWING NEW SPARE PARTS FOR REPLACEMENT OFDAMAGED / DEFECTIVE PARTS. |
| 3 | HV leg coil complete with TPC insulation, varnishing by vacuum impregnation and baking of coil assembly etc. |
| 4 | LV leg coil complete with TPC insulation, varnishing by vacuum impregnation and baking of coil assembly etc. |
| 5 | HV bushing (33 KV) as per relevant ISS |
| 6 | LV bushing (11 KV) as per relevant ISS |
| 7 | Metal parts for HV bushing |
| 8 | Metal parts for LV bushing |
| 9 | Set of gaskets (Neoprene Rubberized Cork sheets) |
| 10 | Silica-gel breather with 3 Kg min, silica-gel up to 5 MVA X-mer and5 Kg. min silica-gel content for above5 MVA X-mer (in Aluminium die cast container) Make - Yogya/Press n forge /Rinutansco |
| 11 | Magnetic type oil level gauge complete with toughened glass and low level alarm contrac |
| 12 | Tapping switch 33 KV |
| 13 | Tapping switch handle |
| 14 | Oil drain / filter valve incorporating sampling device (with narrow orifice) And suitable arrangement for locking |
| 15 | Radiator valves |
| 16 | Air release plug |
| 17 | LT terminal plate complete with terminal |
| 18 | Fresh Type- II transformer oil as per specification enclosed |
| 19 | Sundry items viz, cover bolts, plug, cap screws, washer, insulating material, minor repair of tank, radiator, welding if required etc. |
| 20 | Dial type thermometer of minimum 150 mm diameter with max, temperature indicator complete with resetting device and alarm contactor.Make – Precimeasure, /SCD/Temp. |
| 21 | Double float buchhoz relay complete with alarm and trip contracts. Make- Viat Instrument/Press n forge/trans equipment |
| 22 | Paint for inside & outside of Transformers of primer & two coats of gray paint and marking etc. |
| 23 | Cooling tubes /fins |
| 24 | Conservator tank with detachable end plate |
| 25 | Cost of lamination |
| 26 | Material for conversion of on load tap changer to off load tap changer |
| 27 | Cost of damaged unusable metal parts of the terminal bushing |
| 28 | Brass |
| 29 | Copper |
| 30 | Cost of burnt damaged leg coil |
| 31 | HV leg coil |
| 32 | LV leg coil |
| 33 | Cost of unusable old transformer oil |
| 34 | TRANSPORTATION CHARGES |
| 35 | 0 to 50 Kms (In Rs. on lump sum basis) |
| 36 | For additional distance above 50 Kms. (In Rs. on per Km Basis) |
