Auction Sale Of Scrap Condemned Electric Loco No. 23207/Wag5/Bwn As Is Where Is Basis . The Loco Will Be Sold Without Following Excluded Fittings (I) Wheel Sets With Axle- 06 Nos, (Ii) Axle Boxes- 12 Nos , (Iii) Bull Gear- 06Nos. Iv) 01 No Bogie /1 Sl No., asansol-West Bengal

Auction Sale Of Scrap Condemned Electric Loco No. 23207/Wag5/Bwn As Is Where Is Basis . The Loco Will Be Sold Without Following Excluded Fittings (I) Wheel Sets With Axle- 06 Nos, (Ii) Axle Boxes- 12 Nos , (Iii) Bull Gear- 06Nos. Iv) 01 No Bogie /1 Sl No. Simplex -882 (20-05-2011) Condition- 1.The Purchaser Should Visit The Condemned Loco As Well As Its Actual Location Before Bidding, 2.Dismantling And Cutting Is Permitted For Loading And Delivery Purpose, 3. The Purchaser Has To Make His Own Arrangements Such As Tools, Lifting Tackles/Vehicle And Necessary Trained Men For Cutting And Dismantling The Components Of The Condemned Loco As Per Requirements, 4. The Purchaser Is Required To Stack All The Reclaimable/Excluded Items At One Location Well Away From The Cut Up Parts Of The Locos And It Is Required To Be Returned To The Custodian Before Affecting The Delivery. Purchaser Should Take Adequate Precaution During Dismantling Of Excluded Fitting Sitem So That The Same Can Be Return Over To The Custodian In A Sound, Undamaged And Intact Conditionother Wise Railway Reserve The Right To Recover The Amount Against Damaged Item Prior To The Delivery, 5. The Purchaser Is Required To Take Adequate Safety Measures So That No Railway Property In The Near Vicinity Ofcutting Spot Are Damaged In Any Way. The Purchaser Will Be Held Responsible For Any Damage/Fire Accidentto The Railway Property Caused During Cutting Operation Or Delivery, 6) It Is The Responsibility Of The Purchaserto Segregate And Remove The Unwanted And Leftover Scrap Before Completion Of Delivery Of Loco. Purchaserhas Also To Keep The Cutting And Loading Spot Neat And Clean, Otherwise He May Be Penalized By The Railway,7. The Purchaser Has To Comply All The Rules And Regulation Of Pollution Control Board Prevailing/Existing In The Cutting Spot During Cutting And Dismantling Operation Of Condemned Loco, 8. The Purchaser Should Bea Ware Of The Fact That Total Wt. Shown Against Heading [Lot Wt. In Mt] In Lot Details Page Under Ireps Portal Isindicative Only Against This Lot And Purchaser Should Note That During Delivery Of The Lot, The Above [Lot Wt. Inmt] In Lot Details Page Is Not To Be Taken Into Consideration, 9. Bidders Are Required To Check The Detailed Conditions And Amendments / Modifications If Any, In Special Condition And In Depot Condition Against Eachlot Online For The Lot/Catalogue Published For E-Auction Purpose Before Bidding. Before Bidding Bidders Arealso Advised To Inspect And Tally Every Details Of The Lot Including Description, Location, Quantity, State, Hsncode, Gst Percentage Etc With The Actual Material On Ground As Per Offer Kept With The Custodian And If Any Discrepancies Is Found, It Is Required To Be Brought To The Notice Of The Custodian As Well As To This Office Forfurther Action. No Complaints/Claim By The Purchaser Will Be Entertained In This Regard After E Auction Sale, 10.Gst, Actual Tcs And Other Taxes Will Be Calculated At The Time Of Preparation Of Challan For Final Deposition Ofbsv. 11 .Ground Rent Is To Be Imposed @ � % Of The Value Of The Materials Yet To Be Lifted Per Day Or Part Of Aday Before Initiating Delivery Of The Remaining Un-Lifted Materials In Case Of Failure To Lift The Entire Sold Materials Due To The Fault Of The Purchaser�S Own Within The Stipulated Free Time Period.

Refer document

Refer document

Refer document