Tender For Provn Of 20 Dus For Ncs (E) At Af Stn Grtc Under Ge (Af) Faridabad

Sharing tender

Tender For Provn Of 20 Dus For Ncs (E) At Af Stn Grtc Under Ge (Af) Faridabad; 1 Sch A Section I (Building Works) is not pre-priced by MES and prepriced rates indicates 0.00 under column 6 signified this fact only. 2 Lump sum price worked out by the contractor for Construction of 20 DUs for NCs (E) in 4 Qtrs Each Block (Double Storey) at AF Stn Chandinagar with permanent specifications and as per drawing details 3 Lump sum price worked out by the contractor for Construction of RCC framed structure bldg for 2 x Car Parking (Single Storey) at AF Stn Chandinagar as per permanent specifications and as per drawing details 4 Lump sum price worked out by the contractor for Construction of RCC framed structure bldg for 6 x Car Parking and 10 x Scooter Parking (Single Storey)at AF Stn Chandinagar as per permanent specifications and as per drawing details 5 Note : Schedule A Section -II to X under are Pre-priced by MES. 6 Lump sum price worked out by the contractor for EARTH WORK as listed in Sch A Section-II (refer prepriced shedule attached seperately) 7 Lump sum price worked out by the contractor for ROAD PATH & CULVERTas listed in Sch A Section-III (refer prepriced shedule attached seperately) 8 Lump sum price worked out by the contractor for as listed in Sch A Sewage Disposal as listed in Sch A Section-IV (refer prepriced shedule attached seperately) 9 Lump sum price worked out by the contractor for Area Drainage as listed in Sch A Section-V (refer prepriced shedule attached seperately) 10 Lump sum price worked out by the contractor for COMPOUND WALL & FENCINGas listed in Sch A Section-VI (refer prepriced shedule attached seperately) 11 Lump sum price worked out by the contractor for Internal Water Supplyas listed in Sch A Section-VII (refer prepriced shedule attached seperately) 12 Lump sum price worked out by the contractor for External Water Suply as listed in Sch A Section-VIII (refer prepriced shedule attached seperately) 13 Lump sum price worked out by the contractor for Internal Electric supply as listed in Sch A Section-IX (refer prepriced shedule attached seperately) 14 Lump sum price worked out by the contractor for External Electric Supply as listed in Sch A Section - X (refer prepriced shedule attached seperately) 15 MISCELLANEOUS ITEMS under Sch A Section-XI are not prepriced by MES and item Rate to be quoted by contractor for each item. 16 M&L for RCC septic tank conventional method designed to carry sewage and sullage water, excavation in any type of soil, PCC 1:4:8 below foundation, RCC M-30 design mix in walls, base slab, baffle walls and roof slab including beams etc with vent shaft, man hole opening with cover connection etc complete with effective depth of 1.5 meter and overall depth of 3 meter for 100 user 17 M&L for 3.6 meter dia, 4.5 meter effective depth soakage well excavation, in any type of soil, foundation in PCC 1:3:6 walls of honey combed masonary with top ring of M-25 concrete including intercepting chamber and screen chamber made of brick masonary in CM, RCC cover slab in M-25/SFRC cover, interconnecting pipes of RCC/DWC complete filled with brick bats of size. 18 Supply and fix cast Iron Air Valve with Single air outlets, confirming to IS 14845 of size 50 mm dia bore and fixing up in cast iron water supply mains of size 50 mm dia . Complete all as specified and directed. 19 Material and labour for Cutting CI /DI Pipe line of size up to 150 mm to provide new connection by inserting CI/GI /DI TEE of Size 80 mm including necessary lead joints,Excavation,returning,filling in of excavated material and incl CI/GI fittings complete all as specified. 20 M&L for construction of Valve pit chamber 90 cmx90cm (inner dimension) and 90 cm deep , from the top of MS cover fixed on PCC Base , top cover shall be of 3.15 mm thick MS Sheet with locking arrangement of pad lock of 50mm size including brick work with sub classB bricks in CM 1:4 including 15 mm thick plaster in CM 1:4 (internally and externally) and necessray earth work in any type of soil including returning filling in and disposal of surplus oil to a distance n exc 50 mtrs and 150 mm thick PCC 1:4:8 , type D-2 , using 40mm graded stone aggregates as in floor complete all as specifiedand directed. 21 Supply and fixing of laying of HDPE (DWC) tubing 100 mm dia of presuure rating 6Kgf/cm2 fixing on poles, wall under floors laying on surface etc as required at site and as per direnctions of Engr-incharge.Note : All items and accessories, bend, joints, nut bolts, clamps, T&P etc are incl in quoted rates. 22 Supply, installation and commissioning CPRI approved outdoor cubical fidder pillar box/ LT panel suitable for 3 pahse 4 wire 415 volts 50 Hz supply system and size not less than 1.6m x 1.3mx0.5m powder coated coating provided with suitable to make it dust/vermin proof. The panel shall be made with 3 mm thick CRCA sheet for outer shell and inner shell mde out of 2 mm thick CRCA sheet double door, front openable with locking arrangement, provision of threaded earthing stud at bottom, inner shell be compartmentalized. front openable single door system lockable inner shell completely vermin proof and to accommodate incoming/outgoing MCCBs, MCBs and TPN aluminium bus and efension links. Aluminium bus bar of capacity 300 Amp 4 Nos including neutral duly insulated with colour coated heat shrinkable sleeves and shall be mounted on suitable size / rating of epoxy resin insulator all housed and suitable bus bar chamber all control wires shall be with 2.5 sqmm multi stranded copper conductor and shall be properly bunched tied ferrulled for proper identification and crimped with adequate size f lugs and provision and fixing of voltmeter , ammeter with built i seclector switch CTs of suitable ration and pilot indication amp complete alongwith provision of necessary cable entry/ exit boxes for all incloming and outgoing cable with suitable size of cable gland etc the panel shall be mounted on 50x50x6 mm angle stand of height 45 cm above ground and 45 cm embeded in ground on suitable PCC foundation computer cut self adhesive vinyl danger notice plate having conventional symbol of bones and skull be provided the panel shall consist of following accessories.Note : Earth work and PCC foundation work are deemed to be included in quoted rates.INCOMING(a) MCCB, 160 amp, AC, 415 volts, 4 Pole, 25 KA rupturing capacity with adjustable type-01 No.(b) Analog Ammeter with LED indication lamp with selector switch - 01 Nos (c) Analog voltmeter with LED indication lamp with selector switch - 01 Nos(d) Three Phase (Red, Yellow, Blue) indicating lamp - 01 Nos (Set of three )BUSBAR - Electrolytic high conductivity Aluminium Bus Bar duly drilled holes for connections and mounted on epoxy based post insulator for 3 phase 4 wire 50 Hz AC supply rated at 300 A suitable to withstand fault level of 50 kA with heat shrinkableOUTGOING(a)MCCB 25 Amp, 04 Pole, 415 V, AC 415 volts, 10 KA rupturing capacity, with adjustable thermal (70% to 100%) and magnetic setting conforming to IS: 13947-II complete.-06Nos.(b) Times switches astro type (Having longitude and lattitude of indian cities in memory) 230 V single phase of 20 AMp rating with suitable contactor - 01 nos 23 Supply & Fixing LED lamp 9/10 watt with B-22 cap complete all as specified and directed. 24 Supply & Fixing ofMeter box sheet metal enclosure concealed type made of metal of size 90 x 90 x 30 cm having suitable incoming and outgoing openings for cables complete all as specified and as directed 25 M&L for cable route indicator/ cable joint indicatopr solid block of size 75cmx30cmx10cm in arc shape at top above the ground level duly embossed words as per requirement including required necessary excavation, earth work, PCC complete all specified and directed. 26 Supply and fixing of integrated hybrid type LED Solar all in one street light, 30 watt made of die cast aluminium housing, system lumen output 6000 lumens with efficiency >= 150 lm/w, IP65/IP66, 12.8 v lithium ferrous phosphate battery not less than 80 AH with BMS BIS approved mpno crystalline panel - 120 Wp CCT (5700K-6500K) life of LED luminaire should be 50000 Hr along with built in high efficiency MPPT charge controller (inbuilt into the street light) PIR motion sensor provided start dimming 33% with backup - 1 night or programmable (programming decided by local in charge on demand) Lm79/80, TTC BIS and NABL lab document complete all as specified and directed. 27 Supply and erect 6 mtr long Hot dip galvanised octagonal pole with 130 mm bottom A/F and 70 mm top A/F made up of 3 mm thick HT steel plate having base plate of 220x220x12 mm thick along with single arm bracket of 1000 mm length made up of 48.3x3.25mm thick plate including with bolts nuts complete all as specified and directed.