Tender For Repair And Beautification Work Of Inspection Building Of Public Works Department Located At Naimisharanya Dham Under District Sitapur Development Block Mishrikh

Sharing tender

Tender for repair and beautification work of inspection building of Public Works Department located at Naimisharanya Dham under District Sitapur Development Block Mishrikh, 1 Wiring for light point/fan point/exhaust fan point/call bell point with 1.5sq.mm. FRLS PVC insulated copper conductor single core cable in surface/ recessed medium class PVC conduit, with moduler switch,modular plate, suitable GI box and earthing the point with 1.5 sq.mm FRLS PVC insulated copper conductor single core e.t.c as required. 2 Wiring for twincontrol light point with 1.5 sq.mm FRLS PVCinsulated copper conductor single core in surface/ recessed medium class PVC conduit, 2 way module switch, module plate suitable GI box and earthing the point with 1.5 sq.mm FRLS PVC insulated copper conductor single core e.t.c as required. 3 Wiring for circuit/ submain wiring along withearth wire with the following sizes of FRLS PVC insulated copper conductor single corecable in surface/ recessed medium class PVC conduit, as required. 4 2 X 1.5 sq. mm + 1 X 1.5 sq. mm earth wire 5 2 X 2.5 sq. mm + 1 X 2.5 sq. mm earth wire 6 2 X 4 sq. mm + 1 X 4 sq. mm earth wire 7 2 X 6 sq. mm + 1 X 6 sq. mm earth wire 8 2 X 10 sq. mm + 1 X 10 sq. mm earth wire 9 Supplying and fixing following module switch/socket on the existing module plate & switch box including connections but excluding modular plate etc. as required 10 5/6 A switch 11 15/16 A swich 12 3 pin 5/6 A socket outlet 13 6 pin 15/16 A socket outlet 14 TV antenna socket outlet 15 Bell push 16 Supplying and fixing two module stepped type electronic fan regulator on the exitingplate switch box including connections but excluding module plate as required. 17 Supplying and fixing following ways,4 ways (4+12), Double door and 4 way Double door TPN MCBDBhorizontal type three pole and neutral, sheet steel, MCB distribution board, 415 V, on surface/recess, complete with tinned copper bus bar, neutral bus bar, earth bar, din bar, interconnections,powder painted including earthing etc. as required. (But without MCB/RCCB/Isolator) 18 Supplying and fixing Cable End Box (Loose wire box) Suitable for following triple pole and neutral, Sheet steel, MCB distribution board, 415 volts, on surface/recess, complete with testing and commissioning etc. as required. 19 Supplying and fixing Cable End Box (Loose wire box) Suitable for following Single pole and neutral, Sheet steel, MCB distribution board, 240 volts, on surface/recess, complete with testing and commissioning etc. as required. 20 For 8 way, Double door SPNMCBDB 21 For 12 way, Double door SPN MCBDB 22 Supplying and fixing following way Double door SPN MCBDB single pole and neutral, sheet steel, MCB distribution board, 240 V, on surface/ recess, complete with tinned copper bus bar, neutral bus bar, earth bar, din bar, interconnections,powder painted including earthing etc. as required. (But without MCB/RCCB/Isolator) 23 For 8 way, Double door 24 For 12 way, Double door 25 Providing and fixing 100 A capacity TP&N disconnector fuse switch unit inside the existing pannel board with ISI marked HRC fuses switch unit inside the existing panel board with ISI marked HRC fuses including drilling holes in cubical pannel, making connections, etc. as required. 26 Supplying and fixing 63 A rating, double pole, 240 V, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required. 27 Supplying and fixing 100 A rating, four pole, 415 V, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required. 28 Supplying and fixing 5 A to 32 A rating, 240/415 V, 10 kA, C curve, miniature circuit breaker suitable for inductive load of Single poles in the exixting MCB DB complete with connections, testing and commissioning etc. as required. 29 Supplying and fixing DP sheet steel enclosure on surface/ recess along with 25/32 A 240 V Ccurve DP MCB complete with connections, testing and commissioning etc. as required. 30 Earthing with G.I. earth plate 600 mm X 600 mm X 6 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metrelong etc. with charcoal/coke and salt as required. 31 Supplying and laying 6 SWG G.I. wire at 0.50 metre below ground level for conductor earth electrode, including connection/termination with GI thimble etc. as required. 32 S/o Sony Smart TV actual screen size (Inches) 43 LED. Type Smart TV(2) Display Type LED (Light Emitting Diode) Audio Power 10Wx2 Maximum Resolution (pixels) 4K Ultra HD (UHD) :3840x2160 Typical Brightness (Nits) 300-399 Salient Feature Inbuilt Speakers, Table mount(legs) 33 S/o Sony Smart TV actual screen size (Inches) 55 LED. Type Smart TV(2) Display Type LED (Light Emitting Diode) Audio Power 10Wx2 Maximum Resolution (pixels) 4K Ultra HD (UHD) :3840x2160 Typical Brightness (Nits) 300-399 Salient Feature Inbuilt Speakers, Table mount(legs) 34 S/o Exhaust Fan 300mm (Propeller Type AC Ventilating Fan, Size of Fan (in mm) 300, Number of Pole (in Nos) 4, Number of Blades 3, Rated voltage230V, 50 HZ, AC, Single Phase, Type of Fan Capacitor Type, Power Factor 0.9, Type of Enclosures for Motors Ventilated Type, Provision of Guards for Outlet Side 35 Supplying, Installation, Testing andCommissioning of 1200 mm sweep, BEE 5 star rated, ceiling fan with Brush Less Direct Current (BLDC) Motor, class of insulation: B, 3 nos. blades, 30 cm long down rod, 2 nos, canopies, shackle kit, safty rop, copper winding, Power factor not less than 0.9, Service value (CM/M/W) minimum 6.00, Air delivery minimum 210 Cum/Min, 350 RPM (tolerance as per IS : 347-2019), THD less than 10%, remote or electronic regulator unit for speed control and all remaining accessories including safety pin, nut bolts, washers, temprature rise =75 degree C(max.), insulation resistance more than 2 mega phm, suitable for 230 V, 50 Hz, single phase AC Supply, earthing etc. complete as required. 36 Supplying and fixing call bell/ buzzer suitable for single phase, 230 V, complete as required. 37 Supplyand fixing of LED Tube Light with heavy duty Metal Box type Tube Light fitting 1x22watt suitable for up to 1x22watt LED Polycarbonate tubelight complete Including tube suitable for bothsurface & suspended complete in all respect. 2620 system lumens, >120 Lm/W, PF>0.95, THD <10%, CRI>80, sheet thickness min 0.8mm, Tube with aluminium heat sink,>300V over voltage protection, 2.5 KV internal Surge Protection, with 5year warrantee.CAT AAA 38 S/Fof LED Street light Fitting with mandatory driver set having die cast aluminium body with toughend glass/UV stabilized PC Cover and lenses suitable for 30 Watt. to 40 Watt,Confirming to IP 65/66, and IK07 and above protection complete having Company LOGO Engraved complete in all respect including Labour. 39 S/F of decorative 40Watt to 45Watt, LED Post to pin direct light luminaire having Pressure die cast aluminium body and UV Stabilized PC Clear/ frosted glass cover, with driver set confirming to IP66 and IK08 protection,Potted driver (Not circuitory) complete in all respect. 40 S/F of IP20, Mid Power SMD type LED Light, 2 x 236 Watt to 46Watt, Indoor Recess mounting LED Square Fitting for Armstrong Ceiling Powder coated CRCA housing body, High purity / transmisivity UV Stabilized Non yellowish diffuser/Reflector for uniform light distribution, detachable driver set, open and short circuit protection, suitable for 24Hr Continuous Operation, Complete in all respect. 41 S/F of IP 20, Front Lit, Mid Power SMD type LED Light, recess/ Surface mounting round 10Watt to 15Watt, Cutout Min 125 mm, Height Min 40 mm,, LED Down Lighter having Powder coated die cast aluminium housing with heat sink, High purity / transmisivity UV Stabilized Non yellowish diffuser/Reflector for uniform light distribution, detachable driver set, suitable for 24 Hr Continuous Operation, Complete in all respect. 42 Supplying and fixing following way Double door SPN MCBDB single pole and neutral, sheet steel, MCB distribution board, 240 V, on surface/ recess, complete with tinned copper bus bar, neutral bus bar, earth bar, din bar, interconnections,powder painted including earthing etc. as required. (But without MCB/RCCB/Isolator) 43 S/O of 10sqmm 2core Al. conductor PVC insulated armoured served sheathed cables. 44 Supplyandlayingof aluminiumconductorPVCinsulated armoured served sheathed cables 1100 Volts grade on wall surface as directed by the Engineer-Incharge, complete in all respect. including excavation & refilling. The armouring of the cable shall be properly connected with the earth conductor by clamps etc. 45 S/O of 35 sqmm 3-1/2 core armoured cable. 46 S/O of 70sqmm 3-1/2 core armoured cable. 47 Supplying and making end termination with brass compression gland and aluminium lugs for following size of PVC insulated and PVC sheated/XLPE aluminium conductor cable of 1.1 KV grade as required 48 35 sq. mm 3-1/2 core 49 70 sq. mm 3-1/2 core 50 S/O Four Poll Change over Switch 100Amp. 51 L/c for Dismentaling of old wiring