|
| 1 | Earthwork excavation for foundation in all soils and sub soils in hard stiff clay, stiff black cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders and to full depth as may be directed,except in hard rock,requiring blasting including shoring and shuttering and bailing out of water wherever necessary,refilling the sides of foundation with excavated earth or sand in layer of not more than 15cm thick.well rammed and consolidated and depositing on bank with initial lead and lift of 10m & initial lift of 2m and depositing the surplusr earth within the compound in places shown by the departmental officers with iniital lead and lifts,clearing and levelling the site etc., complete as per SS20B and as directed by departmental Engineers(TNBP No.17,23,24). |
| 2 | PlainCement Concrete 1:4:8 mix (One Part of Cement, Four part ofFine Aggregate and Eight part of Coarse Aggregate) Using 40mm ISS HBG metal for foundation and basement including dewatering if found necessary and laid in layer of not more than 15cm thick and consolidated including all cost conveyance of materials and labour charges etc. complete as per standard specifications and as directed by departmental Engineers(TNBP No.28). |
| 3 | Supplying and erecting centering for sides and soffits including supports and strutting uptp 3.29m height for plane surfaces in all floors with all cross bracings using mild steel sheets of size 90cmx60cm and 10 gauge stiffened, welded with mild steel angles of size 25mmx25x3mm for boarding laid over silver oak (country wood) joist of size 10cmx6.5cm dia spaced about 90cm centre to centre and supported by casuarina props of 10cm to 13cm dia spaced at 75cm centre tocentre etc.complete complying with standard specification and as directed by the departmental engineers. TNBP No.30Ground Floor & First Floor |
| 4 | A) Column |
| 5 | B) Grade beam |
| 6 | C) Lintel. Beam &slab |
| 7 | Supplying, fabricating and placing in position mild steel or TMT rods for all reinforced cement concrete works as per design given including cost of steel and binding wire with all conveyance and lead charges in all floors etc.complete complyingwith standard specifications and as directed by the deparmental engineers.TNBP No:30 |
| 8 | Vibrated Reinforced Cement Concrete 1:1.5:3 mix (One cement and One and a half Fine Aggregate and Three Coarse Aggregate) Using 20mm ISS HBG metal including all cost conveyance of materials and labour charges for curing,finishing but excluding centering,shuttering and cost of reinforcement grills, including vibrating charges etc. complete as per standard specification and as directed by departmental Engineers(TNBP No.30). |
| 9 | Upto Basement |
| 10 | Ground floor |
| 11 | First Floor |
| 12 | Brick Work in Cement Mortor 1:5 Mix (one cement, five M.sand ) using new best countryBricks of size 8 ¾”x 4 ¼”x 2 ¾”from approved quarry including cost and conveyance of all materials to site. loading and unloading charges and labour charges for mixing, laying and curing etc. complete. complying with std. specifications. |
| 13 | a) Upto Basement |
| 14 | b) Ground Floor |
| 15 | c) First Floor |
| 16 | c) Second Floor |
| 17 | Supplying and Filingin foundation and basement with Filling Well Gravelin layers of not more than 15cm thick well rammed,watered consolidated including cost and conveyance of materials and labour charges etc., complete as per Standard Specification and as directed by departmental Engineers(TNBP No.24&25). |
| 18 | Special Ceiling Plastering with CM 1:3 (One part of cement & three parts of sand)mix for 10mm thick including cost and conveyance of materials to work site and including all labour charges for mixing, laying, curing,finishing etc., complete as per standard specifications and as directed by departmental Engineers – TNBP No:30,56&57 |
| 19 | Plastering with CM 1:5(One part of cement & four parts of sand) mix for 12mm thick including cost and conveyance of all materialsto work site and including all labour charges for mixing, laying, curing,finishing etc., complete as per standard specifications and as directed by departmental Engineers – TNBP No:56&57 |
| 20 | Plastering in Cement Mortor 1:5 Mix (one part ofcement and five part of sand) 20mm thick including cost and conveyance of all materials to site, loading and unloading charges and labour charges for mixing, laying and curing etc. complete. Complying with std. specifications. |
| 21 | Supply and Fixing of Teak wood scantling wrought and put up for frames of door and windows including fixing holdfast and all labour chargesand conveyance of all materials to siteetc., Complete as per standard specification. |
| 22 | Supply and fixing of Teak wood fully panelled and Double leaf (two Equal Panels) shutter for door including all labour charges cost and conveyance of all materials to site etc., Complete as per standard specification. |
| 23 | Supply and Fixing of U-PVC Shutter openable Door using GI Steel Reinforcement, Butt hinge,Aldrop lock and foam Sheet includingcost and conveyance of all labour and all meterial charges etc Complete as per standard specification. |
| 24 | Supplying and fixing M.S.grill to doors, special windows and ventilators etc as directed by the departmental officers inclusive of cost of MS grill including one of cost red oxide and fixing in position etc., complete (as per the schedule of rate) SL.NO.182 Q3 |
| 25 | Supply and fixing of U-PVC Two shuter openable Window using G.I steel Reinforcement, friction hinge, multipoint lock, and 5mm clear glass or foam sheet including cost and conveyance of all labour and all meterial charges etc Complete as per standard specification. |
| 26 | Supply and fixing of U-PVC Fixed Louvers type Ventilator using GI Steel Reinforcement and 4mm Pinhead glass includingcost and conveyance of all labour and all meterial charges etc Complete as per standard specification. |
| 27 | Supplying and fixing in Position of indian type water closet with all set in brick jelly concrete 1:4:8 Mix concrete 10 cm thick using 20mm brick jelly and top finished with c.m. 1:3 mix 20mm thick without any leakage etc. Complete as per standard specification. |
| 28 | Supplying and fixing in position colour glazed EUROPEAN WATER CLOSET with \"P\" or \"S\" trap and double flapped seat cover, 12.50 litres capacity P.V.C. low level FLUSHING TANK including all internal fittings fixed on C.I. brackets, 12mm PVC or brass nipple, chromium plated brown headed stopcock, 12mm nylon connection with necessary teakwood plugs, clamps, screws to the portion coming with walls and floors, including dismantling masonry and redoing the same to the original condition. |
| 29 | Dadooing the walls with glazed tiles of 30 c.m x 20 c.m 6mm size laid in cement mortor 1:2 mix 10mm thick and pointing with 0.40 kg white cement per m2 etc. |
| 30 | Paving the floor with best quality VetrifiedTiles of size 600 x 600 x 8mm of approved colour, shade and quality laid in cement mortar 1:3 (one cement and three sand) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification.(The make and brand of the tiles should be got approved by Executive Engineer before use on works)m thick and pointing with white cement including finishing jointing and polishing with glossy finish etc complete as per std specification |
| 31 | Weathering Course concrete using best quality broken brick jelly of size 20mm uniform gauge in pure slaked lime (no sand to be used) near the RCC roof slab in the properties of brick jelly to lime being 12:12-1/2 by volume and laid over in single layer and consolidated to the required designs and finished thickness, beating the concrete with woodenbeaters of approved pattern, keeping the surface constantly watted by sprinking lime jaggary water. |
| 32 | Finishing with top of roof with one course of machine pressed tiles of size 20cmx20cmx20cm of approved quality laid in cement mortar 1:3 (One cement and three sand) 12mm thick mixed with water proofing compound conforming to ISS by 2% weight of cement used and the joint pointed neatly to full depth of tiles with same water proofing compound mixed with cement motar ,red oxide, etc.complete complying with standard specification as directed by the departmental officers.TNBP No:44-I |
| 33 | Laying with new C.C. Laminated tiles (Like Dora tiles Eurocon tiles etc),(anti skid) of 20mm thick of approved spl quality and set in Cement Mortar 1:3 (1 of cement and 3 of M- Sand ) 20mm. Thick using river M- Sand and pointing with colour cement using at the rate of 0.40 kg/M2 and mixing with colour pigment at the rate of 0.3 Kg/M2 including finishing complete with Standard Specification and as directed by the DePart ofmental Officers etc., |
| 34 | Painting two coats of newly plastered wall surface with ready mixed plastic emulsion paint of first class quality and of approved colour over a priming coat including thorough scrapping, clean removal of dirt, and including necessary plaster of paris putty, wherever required etc., complete complying with standard specification. |
| 35 | Painting new wood work with two finishing coats of synthetic enamel ready mixed paint of approved quality and colour over one coat priming coat in all floors including the cost of primer etc., complete complying with standard specification. (The make, quality and colour of paint should be got approved by the Executive Engineer before use on works.) |
| 36 | Painting new iron works such as steel doors, windows, ventilators, window bars, balustrades etc., with two coats of best approved first quality and colour of synthetic enamel paint over one coat of red oxide priming coat in all floors including cost of priming coat etc., complete complying with standard specification. (The make, quality and colour of paint should be got approved by the Executive Engineer before use on works.) |
| 37 | Wiring with 2X1.5 sqmm (22/0.3) PVC insulated sc unsheathed Cu.conductor cable of 1100 V grade in suitable heavy gauge MS conduit pipe concealed in wall and ceiling with MS accessories with switch box with 5A F.T. switch(two way) in flush with wall and convered with 3mm thick hylem sheet for MS switch box with continous earth wire connection of 14 SWGTC wire and making good of the concealed portion with suitable colour for concealed stair case light point/Fan Point (SD.NO.24) Page No -13 |
| 38 | Wiring with 2x1.5sqmm (22/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100 V grade in suitable PVCrigid pipe concealed in wall and ceiling with PVC accessories, in flush with wall, with 150mm x 100mm x 113mmTW switch box with 3 mm thick Hylem sheet cover for 5 A 3 pin non inter locking CS Plug with continuous earthwire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour for concealedPVC plug point (SD 38) |
| 39 | Supply and fixing of TNEB meter board suitable for 32 A threephase service connection with3 nos of32A fuseunit (500 V) 32A neutral link and earth link (1\"X18\" copper flat) on TW plant of size 600mm X 450mm X19 with supporiting TW reepers of 1 \" thick an either side withpainting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit (SD No.127) Page No -59 |
| 40 | Supply and run of 4 of 6 sqmm (84/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V grade in 32mm G.I pipe (Class \"B\" bent at both ends with necessary angle iron up right and end supports for mains(SD No.73)Page No -33 |
| 41 | Supply and run of 4 of 6 sqmm (84/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V grade on7/20 GI bearer wire for service connection mains(SD No.68) |
| 42 | Supplying and Fixing A.C Ceiling fan complete 1200mm (48”) sweep with 300mm Down Rod , with regulator ( Crompton make ) including cost and conveyance charges fixing and its position etc complete SD 106 ISI make with standard specification. |
| 43 | Supply and fixingof 3 phase 4 wire 4way ICDB of 32 Amps per way with 100Amps TPNMC switch with suitable trunking box ms cable entry boxes and internal connection on suitable angle iron frame work with earth connection etc complete as per std sepcification.(SD177) Page No -67 |
| 44 | Supply and fixing of WT bulk head fitting with guard (Philips / Bajaj / Crompton / K. Lite) suitable for11W CFL lamp with CFL. SD 83 |
| 45 | Supply and fixing of single box type 4\"40 W flu fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flu tube with PVC unsheathed Copper leads from terminals to the fitting. SD 88 |
| 46 | Supply and delivery of 2000 litre capacity H.D.P.E.Water tank approved ISI Quality including cost and convenance of all materils to the site etc complete As per standard specification |
| 47 | Supplying and filling in foundation, basement, etc with filling sand in layers of not more than 15 cm thick well watered, rammed and consolidated etc. complete complying with standard specification and as directed by the departmental officers. |
| 48 | Supply and Filling of40 mm HBG ISS Metalfrom approved quarry including cost and conveyance of all materials to site, loading and unloading charges and filling to required depth etc., Complete as per standard Specification |
| 49 | Supply and delivery of following PVC Pipes 110mm PVC Pipe 6kg/cm2 including cost and conveyance of materials to site etc complete,. |
