Tender For Thorough Repair And Renovation Of Existing Building Of Board Of Waqf, West Bengal

Sharing tender

Tender For Thorough Repair And Renovation Of Existing Building Of Board Of Waqf, West Bengal tender for Thorough Repair And Renovation Of Existing Building Of Board Of Waqf, West Bengal ----- Modernization And Up Gradation Of Existing G Plus 4 Lift. Thorough Repair And Renovation Of Existing Building Of Board Of Waqf, West Bengal ----- Modernization And Up Gradation Of Existing G Plus 4 Lift. , Sitc Of Automatic Lift ( As Per Manufacturer Design & As Per Detailed Specification Below Conforming To Is ) And Putting Into Operation After Final Testingin The Existing Liftshaft Complete With All Accessories Andrepairing Thedamage Wall / Floor If Any Etc To Complete As Reqd. Make : Category-I (Otis/Kone/Schindler)/ Pwd Approved Category-Ii , Type:Passanger Lf. Load :5 Passenger/340Kg Control: Microprocessor Based With Serial Communication, Controller In Shaft And User Interface In Landing. Drive : Ac Vf Drive With Feedback Control (Closed Loop) Machine:- Energy Efficient Machine: Gearless,With Machine Room. Position Of Machine Room: Above The Shaft Speed: 1.0Mtrsj Sec Floor Served: G +4 Landing: 5 Lands, All On Same Side Total Rise :14.6 Mtr (Approx) Operation: Microprocessor Based Simplex Fullcollectivewith Or Without Attendant. Signals: Digital Car Position Indicator,Car Travels Direction Indicator In Car & At All Landing With Call Registration Indicator. Cop And Lop Must Have Stainless Steel Faceplate Silver Brushed With Surface Mounted Button With Braille. Button :All Buttons On Car& Landing Shall Be Luminious And Encoded With Braille On / Off Switc For Lift Fan,Light, Toggle Switch Or Key Switch For Autometic I Attended Mode Of Operation. Display Type :Color Lcd/ Segmented Lcd/ Led. Opration Push Button For Lift Maintainnence & Service Should Be On Top Of The Car. Travelling Accuracy:± 5 Mm(Micro Levelling Arrangement) , Car Car Inside As Per Oem Car Entrance: Clear Opening:- 700Mm X 2000Mm Protected With Car Door Car Enclosure: Stainless Steel Sheet (20 Swgj With Hairline Finish Withhand Rail. Car Ceiling& Lighting: Stainless Steel With Hairline Finish With Led Lighting Andfan. Car Ventllatlon:Pressure Fan With Anodised Aluminium Grill. Car Flooring :Decorative Granite Flooring (As Per Direcion Of Eic And According To This Departments Order). Car Door:Stainless Steelcentre Opening (Copd)/Telescopic Opening (Tspd) Automatic Door Provided With Ac V3f Controlled Door Drive System With Full Height Infrared Curain Of Light And Mechanical Force Limiting Divice. Landing Door: Stainless Steel Centre Opening (Copd)/ Telescopic Opening (Tspd) Automatic Door Providedwith Ac V3f Controlled Door Drive System With Fire Rating Of 120 Min. Door Opening: Automaticpower Oprated Door With Full Length Photocell Assembly Light Curtain Sensor / Infrared Detector. , P R O T E C Tiv E D E V Ic E S & O T H E R A C E S S O R Ie S Ard: Automatic Rescue Device Complete With Dry Maintenance Free Batteries As Required For Automatic Evacuation To The Nearest Floor In Case Of Power Failure I Single Phasing / Others. Overload Protection:Fully Loaded With Overload Protection.On Overloading The Lift Car Will Not Start With Door Remaining Open And Give Audio& Display Indication. Emergency Lighting In Car: Battery Operated Emergency Lighting In The Lift Car. Intercom System:Battery Operated Intercom System In Lift Car, Machine Room & Control Room Emergency Alarm:Battery Operated Alarm Bell System In Lift Car And Control Room Fireman Switch: Fireman Switch At Main Landing Terminal. Voice Synthesizer: Voice Announcementsystem (Voice Synthesizer) In The Car To Announce The Position Of The Elevator In The Hoist Way As The Car Passes Or Stops At A Floor Served By The Elevator. , Dimension Of Shaft & Power Supply Available Shaft Dimension:1500 Mm (W) X 1400 Mm (D) Pit Depth :1500 Mm Overhead : 4200Mm Electric Power Supply:Ac 415 Volt 3Phase, 50 Hz, Terminated In Bob At Top Landing As Per Is. N.B. (1) Please Correlatewith Lift Technical Requirements (Annexure A), If There Is Any Conflict, Technicalrequirement Will Overside Boq. 2) Rates Shouldbe Quotedwith Minor Civil Works,Wall Cutting And Mending Good The Damages To The Originalfinish. G) Necessary Ms Member Eg; Angle Iron, Ms Channel Brackets Etc As Required To Be Providedby The Manufacturer. , Less Cost For Dismantled Materialsof The Oldexistinglift (G+4) , (Rate Should Be Quoted Inclusive Of All Taxes And Duties)