|
| 1 | Earth work in excavation of foundation trenches or drains, in all sorts of soil (including) mixed soil but excluding laterite or sand stone) including removing, spreading or stacking the spoils within a lead of 75.0 mtr. or as directed. The item includes necessary trimming the sides of trenches, leveling, dressing and ramming the bottom, bailing out water etc. as required complete. |
| 2 | Depth of excavation not exceeding 1500 mm |
| 3 | Earth work in filling in foundation trenches or plinth with good earth, in layers not exceeding 150mm including watering and ramming etc. layer by layer complete. |
| 4 | With earth obtained from excavation of foundation. |
| 5 | Filling in foundation or plinth by Silver Sand in layers not exceeding 150mm as directed and consolidating the same by thorough saturation with water, ramming complete including the cost of supply of sand. |
| 6 | Single brick flat soling of picked jhama bricks including ramming and dressing bed to proper level, and filling joints with powdered earth or local sand. |
| 7 | Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. |
| 8 | In ground floor and foundation |
| 9 | a) 1:2:4 Proportion |
| 10 | Considering 08 km from Baruipur Stackyard. |
| 11 | Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. |
| 12 | (i) Pakur Variety |
| 13 | Considering 08 km from Baruipur Stackyard. |
| 14 | Hire and labour charges for shuttering with centering and necessary staging upto 4mm, using approved scout props and thick hard wood planks of approved thickness with required bracings for concrete slabs, columns, lintels, beams etc. curved or straight, including fitting, fixing and striking out after completion of works (upto roof of ground floor). |
| 15 | (When the height of a particular floor is more than 4 m the equivalent floor height shall be taken as 4 m and extra for works beyond the initial 4 m ht. shall be allowed under 12 (e) for every 4 m or part thereof) |
| 16 | a)25 mm to 30 mm thick wooden shuttering as per decision and direction of the Engineer-in-Charge. |
| 17 | f) 25 m.m to 30 m.m shuttering without staging in foundation |
| 18 | Reinforcement for reinforced concrete work in all sort of structures including distribution bars, stirrups, binders etc. including supply of rods, initial straightening and removal of loose rust (if necessary) cutting to requisite length, hooking and bending to correct shape, placking in proper position and binding with 16 gauge black annealed wire at every inter-section, complete as per drawing and direction. |
| 19 | a) For works in foundation, basement and upto roof of ground floor upto 4 mtr. |
| 20 | (i) Tor steel/Mild Steel |
| 21 | I. SAIL/ TATA/RINL |
| 22 | Considering 08 km from Baruipur Distributor. |
| 23 | Brick work with 1st class bricks in cement mortar (6:1) |
| 24 | a) In foundation and plinth. |
| 25 | b) In Superstructure, ground floor. |
| 26 | 125mm thick brick work with 1st class bricks in cement mortar (4:1) in ground floor. |
| 27 | Supplying and laying polythene sheet (150gm/ m2) over damp proof course or below flooring or roof terracing or in foundation trenches. |
| 28 | Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame exluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be correted upto three decimals). |
| 29 | a) Sal - Local (Other than Malyasian). |
| 30 | Panel shutters of door and window, as per design (each panel consisting of single plank without joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings. In ground floor. (In case of non-supply of single plank, penal rate of reduction of 20% will be made) |
| 31 | (iii) 35mm thick shutters with 19mm thick panel of size 30 to 45 cm. |
| 32 | (b) Sishu, Gamar, Champ,Badam,Bhola, Mogra, Hallak. |
| 33 | 25 mm. thick damp proof with cement concrete with stone chips (1:1.5:3) (with graded stone aggregate 10 mm. normal size) and painting the top surface with a coat of bitumen [VG.40 ] using 1.7 kg. per sq.m. including heating the bitumen and cost and carriage of all materials complete. [Bitument to be supplied by the Agency]. |
| 34 | Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking outs joints or roughening of concrete surface by chamfering etc. including throating, nosing and drip course where necessary (Ground floor).Excluding cost of chipping over concrete surface] |
| 35 | i) With 1:6 cement mortar |
| 36 | a) 15mm thick plaster. |
| 37 | b) 20mm thick plaster. |
| 38 | ii) With 1:4 cement mortar |
| 39 | a) 10mm thick plaster. |
| 40 | Neat cement punning about 1.5mm thick in wall, dado, window, sill, floor etc.NOTE:Cement 0.152 cu.m per100 sq.m. |
| 41 | Making V-groove line (6mm wide, 6mm deep) in plastered surface. |
| 42 | Colour washing with any shade with Stainers, as required including cleaning and smoothening surface thoroughly : |
| 43 | (b) Two coats (on new works only). |
| 44 | (ii) Yellow, pink. |
| 45 | White washing including cleaning and smoothening surface thoroughly. |
| 46 | (a) Three coats (on new works only). |
| 47 | Priming one coat on steel or other metal surface with synthetic enamel /oil bound primer of approved quality including smoothening surfaces by sand papering etc. |
| 48 | Painting with best quality syntheticenamel paint of approved make and brand including smoothening surface by sand papering etc. including using of a approved putty etc. on the surface, if necessary. |
| 49 | a) On steel : With other than hi-gloss of approved quality |
| 50 | Two coats with any shade except white. |
| 51 | Priming one coat on timber or plastered surface with synthetic oil bound primer of approved quality including smoothening surfaces by sand papering etc. |
| 52 | Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface, if necessary: |
| 53 | (a) On timber or plastered surface : |
| 54 | With other than hi-gloss of approved quality |
| 55 | (iv) Two coats (with any shade except white) |
| 56 | M.S. or W.I. ornamental grill of approved design, joints continuously welded with M.S. W.I. flats and bars for windows, railing etc. fitted and fixed with necessary screws and lugs in ground floor. |
| 57 | (Add extra @ 1% for each addl. floor upto 4th floor and @ 1.25% for each addl. floor above 4th floor) |
| 58 | i) Grill weighing above 10 Kg/Sq. m. and upto 16 Kg. / m2 |
| 59 | Supplying, fitting and fixing M.S. clamps for door and window frame made of flat bent bar, end bifurcated with necessary screws etc. by cement concrete(1:2:4) as per direction. (Cost of concrete will be paid separately) |
| 60 | (a) 40mm X 6mm, 250mm Length |
| 61 | Supplying, fitting, fixing hinged Cleat in position. |
| 62 | With 50mm iron butt hinges. [Local : Sal] |
| 63 | Supplying, fitting and fixing PVC pipes of approved make of Schedule 80 (medium duty) conforming to ASTMD - 1785 and threaded to match with GI Pipes as per IS : 1239 (Part- I). with all necessary accessories, specials viz. socket, bend, tee, union, cross, elbo, nipple, longscrew, reducing socket, reducing tee, short piece etc. fitted with holder bats clamps, including cutting pipes, making threads,fitting, fixing etc. complete in all respect including cost of all necessary fittings as required,jointing materials and two coats of painting with approved paint in any position above ground. (Payment will be made on the centre line measurements of total pipe line including all specials. No separate payment will be made for accesories, specials. Payment for painting will be made seperately) |
| 64 | (a) For Exposed Work |
| 65 | PVC Pipes |
| 66 | a) 15 mm |
| 67 | Earth work in filling in foundation trenches or plinth with good earth, in layers not exceeding 150 mm. including watering and ramming etc. layer by layer complete. (Payment to be made on the basis of measurement of finished quantity of work) |
| 68 | (c) (i) With carried earth arranged by the contractor within a radius of 1 km. including cost of carried earth. |
| 69 | Supplying, fitting and fixing bib cock or stop cock. |
| 70 | (a) (i) Chromium plated Bib Cock short body (Equivalent to Code No. 511 & Model - Tropical / Sumthing Special of ESSCO or similar brand). |
| 71 | Supplying, fitting and fixing shower of approved brand and make. |
| 72 | (i) Chromium plated round shower with revolving joint 100 mm dia with rubid cleaning system (Equivalent to Code No. 542(N) & Model - Tropical / Sumthing Special of ESSCO or similar brand). |
| 73 | Add GST @ 18% on all item |
| 74 | Add CESS @ 1% on all items & on GST |
