Tender For Structural Painting For Stacker & Rmhs/Spr-2000155202, Joda-Odisha

Tender For Structural Painting For Stacker & Rmhs/Spr-2000155202 00155202 10 10 50 PREPARATION PAINTING SURFACE 5,000 M2 10 PAINTING OF GENERAL STRUCTURE 5,000 M2 30 SCAFFOLDING LIFTING CHARGES 5,000 M2 20 SCAFFOLDING LIFTING CHARGES 5,000 M2 40 SCAFFOLDING LIFTING CHARGES 5,000 M2 Email : NIMAIN.PANDA@AMNS.IN Contact : Name : Nimain Panda Item Details : Vendor selection note: 1. Service provider must work in industries like IOCL, IFFCO, TATA 2 Contactor who provides the paint should be trained or have relevant experience in carrying out the said job earlier. 3 Make certain that all material as per M/s AMNS standard of requirement. 4 The contractor shall ensure to use safety gadgets, PPEs, Safety belts, safety harness wherever applicable. (FRP helmet, safety goggles, safety shoes, nose mask, ear muff <(>&<)> reflective jacket must provide) 5 The contractor shall ensure maximum safety at work and all the necessary precautions, toolbox talk, Hazard identification is to be carried before work. Job type- scaffolding: 1 Scaffolding supply, fixing <(>&<)> removal under contractor scope. 2 Contactor who provides scaffolds should be trained or have relevant experience in carrying out the said job earlier as per AMNS FPS standard . 3 Scaffolds shall be secured from tipping when the scaffold height exceeds four times its minimum base dimension. 4 The members of scaffolds shall overhang not less than 6 on either ends but not more than 12. They shall be fastened on both ends and laid tight by scaffolds and clamps. 5 The contractor shall ensure to use safety gadgets, PPEs, Safety belts, safety harness wherever applicable. 6 The contractor shall ensure maximum safety at work and all the necessary precautions, toolbox talk, Hazard identification is to be carried before erection and dismantling of scaffold. Job type- paint: 1 Surface Preparation as per ISO 8501- Localized hand and power tool cleaning- St 3 (Minimum drying time 24 hrs. each coat) . Water jet cleaning /scraping with manual wire brush further corroded part of the structural may use as per site in charge instruction if possible, at site. 2 Paint application to be done by spray paint only. Manual brush /roller paint will be allowed in case of difficult reach area. 3 provide and application of One cot epoxy Zinc rich Primer 40 micron <(>&<)> two coat MIO of each minimum 60 micron ( Total – 160 micron) 4 Provide and application of two coat epoxy finish paint of 60 micron each coat 5 1st <(>&<)> 2nd Color band on pipes to be superimposed as per site in charge instruction. 6 Total paint application should be 160 micron or above max. (DFT) 7 DFT equipment must be carry by service provider <(>&<)> calibrated. 8 supply of paint of make- Asian Paints PPG Ltd, Berger paints Ltd, Akzo Nobel paints FREQUENCY <(>&<)> GUARANTEE: 1 For surfaces painted after Manual Cleaning as surface preparation 4 years. 2 Paint material shall be procured from approved manufacturers who also will stand guarantee as above clause PAINT MONITORING SYSTEM: 1 All painting works shall be mentioned (sign writing) with date of completion and PO no. at site/structure. These would facilitate defects observations and would also be basis for evaluation of the painting contractor /paint system and manufacturer for future works. OTHER NOTES: 1 RA invoice to be raised every month. 2 Minimum 2 no’s of gang to be mobilized consisting 2 grinder ,2 painter, one helper

Refer document

Refer document

Refer document